Bioelectrochemical approaches for removal of sulfate, hydrocarbon and salinity from produced water.

Produced water (PW) is the largest liquid waste stream generated during the exploration and drilling process of both the conventional hydrocarbon based resources like crude oil and natural gas, as well as the new fossil resources like shale gas and coal bed methane. Resource management, efficient utilization of the water resources, and water purification protocols are the conventionally used treatment methods applied to either treat or utilize the generated PW. This review provides a comprehensive overview of these conventional PW treatment strategies with special emphasises on electrochemical treatment. Key considerations associated with these approaches for efficient treatment of PW are also discussed. After a thorough assessment of the salient features of these treatment platforms, we propose a new strategy of uniquely integrating bioelectrochemical processes with biological system for more effective PW treatment and management.

Electrochemical removal of sulfate from petroleum produced water.

Petroleum produced water (PPW) is a waste-stream that entails huge cost on the petroleum industry. Along with other suspended and dissolved solids, it contains sulfate, which is a major hurdle for its alternative use intended toward enhanced oil recovery. This study proposes a two-step process for sulfate removal from PPW. A synthetic PPW was designed for the study using response surface methodology. During the first step, sulfate present in PPW was reduced to sulfide by anaerobic fermentation with 80% efficiency. In the second step, more than 70% of the accumulated sulfide was electrochemically oxidized. This integrated approach successfully removed sulfate from the synthetic wastewater indicating its applicability in the treatment of PPW and its subsequent applications in other oil field operations.

Enrichment, isolation and characterization of pentachlorophenol degrading bacterium Acinetobacter sp. ISTPCP-3 from effluent discharge site.

Three pentachlorophenol (PCP) degrading bacterial strains were isolated from sediment core of pulp and paper mill effluent discharge site. The strains were continuously enriched in mineral salts medium supplemented with PCP as sole source of carbon and energy. One of the acclimated strains with relatively high PCP degradation capability was selected and characterized in this study. Based on morphology, biochemical tests, 16S rDNA sequence analysis and phylogenetic characteristics, the strains showed greatest similarity with Acinetobacter spp. The strain was identified as Acinetobacter sp. ISTPCP-3. The physiological characteristics and optimum growth conditions of the bacterial strain were investigated. The results of optimum growth temperature revealed that it was a mesophile. The optimum growth temperature for the strain was 30 degrees C. The preferential initial pH for the strain was ranging at 6.5-7.5, the optimum pH was 7. The bacterium was able to tolerate and degrade PCP up to a concentration of 200 mg/l. Increase in PCP concentration had a negative effect on biodegradation rate and PCP concentration above 250 mg/l was inhibitory to its growth. Acinetobacter sp. ISTPCP-3 was able to utilize PCP through an oxidative route with ortho ring-cleavage with the formation of 2,3,5,6-tetrachlorohydroquinone and 2-chloro-1,4-benzenediol, identified using gas chromatograph-mass spectrometric (GC-MS) analysis. The degradation pathway followed by isolated bacterium is different from previously characterized pathway.