Optimization and Comparison of Microwave-Assisted Extraction, Supercritical Fluid Extraction, and Eucalyptus Oil-Assisted Extraction of Polycyclic Aromatic Hydrocarbons from Soil and Sediment.

Polycyclic aromatic hydrocarbons (PAHs) are persistent organic compounds of major concern that mainly accumulate in soils and sediments, and their extraction from environmental matrices remains a crucial step when determining the extent of contamination in soils and sediments. The objective of the present study was to compare the extraction of PAHs (phenanthrene, pyrene, chrysene, and benzo[a]pyrene) from spiked soil and sediment using supercritical fluid extraction (SFE) with ethanol as the modifier, microwave-assisted extraction (MAE), and eucalyptus oil-assisted extraction (EuAE). Recoveries of PAHs were comparable between the three methods, and >80% of applied pyrene, chrysene and benzo[a]pyrene were recovered. The most efficient method of extracting PAHs from naturally incurred soils with different levels of contamination was SFE. A longer extraction time was required for the EuAE method compared with SFE and MAE under optimized conditions. However, EuAE required lower extraction temperatures (15-20 °C) compared with SFE (80 °C) and MAE (110-120 °C), and consumed less solvent than SFE and MAE. Compared with hexane/acetone used in MAE, the use of ethanol in SFE and eucalyptus oil in EuAE can be considered as more sustainable approaches to efficiently extract PAHs from spiked/naturally contaminated soils and sediments. And, although less efficient for matrices containing higher carbon content, EuAE offered a cheap, low-tech approach to extracting PAHs. Environ Toxicol Chem 2023;42:982-994. © 2023 The Authors. Environmental Toxicology and Chemistry published by Wiley Periodicals LLC on behalf of SETAC.

Polycyclic aromatic hydrocarbon contamination in soils and sediments: Sustainable approaches for extraction and remediation.

Polycyclic aromatic hydrocarbons (PAHs) are carcinogenic environmental pollutants that are extremely hydrophobic in nature and resistant to biological degradation. Extraction of PAHs from environmental matrices is the first and most crucial step in PAH quantification. Extraction followed by quantification is essential to understand the extent of contamination prior to the application of remediation approaches. Due to their non-polar structures, PAHs can be adsorbed tightly to the organic matter in soils and sediments, making them more difficult to be extracted. Extraction of PAHs can be achieved by a variety of methods. Techniques such as supercritical and subcritical fluid extraction, microwave-assisted solvent extraction, plant oil-assisted extraction and some microextraction techniques provide faster PAH extraction using less organic solvents, while providing a more environmentally friendly and safer process with minimum matrix interferences. More recently, more environmentally friendly methods for soil and sediment remediation have been explored. This often involves using natural chemicals, such as biosurfactants, to solubilize PAHs in contaminated soils and sediments to allow subsequent microbial degradation. Vermiremediation and microbial enzyme-mediated remediation are emerging approaches, which require further development. The following summarises the existing literature on traditional PAH extraction and bioremediation methods and contrasts them to newer, more environmentally friendly ways.

A rapid method for the simultaneous quantification of the major tocopherols, carotenoids, free and esterified sterols in canola (Brassica napus) oil using normal phase liquid chromatography.

A normal phase high performance liquid chromatography (HPLC) method was developed to simultaneously quantify several prominent bioactive compounds in canola oil vis. α-tocopherol, γ-tocopherol, δ-tocopherol, ß-carotene, lutein, ß-sitosterol, campesterol and brassicasterol. The use of sequential diode array detection (DAD) and tandem mass spectrometry (MS/MS) allowed direct injection of oils, diluted in hexane without derivatisation or saponification, greatly reducing sample preparation time, and permitting the quantification of both free sterols and intact sterol esters. Further advantages over existing methods included increased analytical selectivity, and a chromatographic run time substantially less than other reported normal phase methods. The HPLC-DAD-MS/MS method was applied to freshly extracted canola oil samples as well as commercially available canola, palm fruit, sunflower and olive oils.

Urban stormwater inputs to an adapted coastal wetland: role in water treatment and impacts on wetland biota.

The Lake Pertobe wetland system is a semi-natural wetland that has been modified primarily for recreational use. However, this lake system receives stormwater from much of the central business district of Warrnambool City (Victoria, Australia) and serves as a buffer zone between the stormwater system and the Merri River and Merri Marine Sanctuary. This work considers the impact of stormwater inputs on Lake Pertobe and the effectiveness of the lake in protecting the associated marine sanctuary. Sediment contaminants (including heavy metals and polycyclic aromatic hydrocarbons (PAHs)) and water quality parameters within the lake, groundwater and stormwater system were measured. Water quality parameters were highly variable between stormwater drains and rain events. Suspended solids rapidly settled along open drains and shortly after entering the lake. Groundwater inputs increased both salinity and dissolved nitrogen in some stormwater drains. Some evidence of bioaccumulation of metals in the food chain was identified and sediment concentrations of several PAHs were very high. The lake acted as a sink for PAHs and some metals and reductions in Escherichia coli, biological oxygen demand and total phosphorus were observed, affording some protection to the associated marine sanctuary. Nutrient retention was inadequate overall and it was identified that managing the lake primarily as a recreational facility impacted on the effectiveness of stormwater treatment in the system.