Physical and Chemical Properties of Vegetable Films Based on Pumpkin Purée and Biopolymers of Plant and Animal Origin.

Highly methylated apple pectin (HMAP) and pork gelatin (PGEL) have been proposed as gelling agents for pumpkin purée-based films. Therefore, this research aimed to develop and evaluate the physiochemical properties of composite vegetable films. Granulometric analysis of film-forming solutions showed a bimodal particle size distribution, with two peaks near 25 µm and close to 100 µm in the volume distribution. The diameter D4.3, which is very sensitive to the presence of large particles, was only about 80 µm. Taking into account the possibility of creating a polymer matrix from pumpkin purée, its chemical characteristic was determined. The content of water-soluble pectin was about 0.2 g/100 g fresh mass, starch at the level of 5.5 g/100 g fresh mass, and protein at the level of about 1.4 g/100 g fresh mass. Glucose, fructose, and sucrose, the content of which ranged from about 1 to 1.4 g/100 g fresh mass, were responsible for the plasticizing effect of the purée. All of the tested composite films, based on selected hydrocolloids with the addition of pumpkin purée, were characterized by good mechanical strength, and the obtained parameters ranged from about 7 to over 10 MPa. Differential scanning calorimetry (DSC) analysis determined that the gelatin melting point ranged from over 57 to about 67 °C, depending on the hydrocolloid concentration. The modulated differential scanning calorimetry (MDSC) analysis results exhibited remarkably low glass transition temperature (Tg) values, ranging from -34.6 to -46.5 °C. These materials are not in a glassy state at room temperature (~25 °C). It was shown that the character of the pure components affected the phenomenon of water diffusion in the tested films, depending on the humidity of the surrounding environment. Gelatin-based films were more sensitive to water vapor than pectin ones, resulting in higher water uptake over time. The nature of the changes in water content as a function of its activity indicates that composite gelatin films, with the addition of pumpkin purée, are characterized by a greater ability to adsorb moisture from the surrounding environment compared to pectin films. In addition, it was observed that the nature of the changes in water vapor adsorption in the case of protein films is different in the first hours of adsorption than in the case of pectin films, and changes significantly after 10 h of the film staying in an environment with relative humidity RH = 75.3%. The obtained results showed that pumpkin purée is a valuable plant material, which can form continuous films with the addition of gelling agents; however, practical application as edible sheets or wraps for food products needs to be preceded with additional research on its stability and interactions between films and food ingredients.

Development and Characterization of Novel Composite Films Based on Soy Protein Isolate and Oilseed Flours.

The possibility of using oilseed flours as a waste source for film-forming materials with a combination of soy protein isolate in preparation of edible films was evaluated. Physical, mechanical and barrier properties were determined as a function of the oilseed type: hemp, evening primrose, flax, pumpkin, sesame and sunflower. It was observed that the addition of oilseed flours increased the refraction and thus the opacity of the obtained films from 1.27 to 9.57 A mm-1. Depending on the type of flours used, the edible films took on various colors. Lightness (L*) was lowest for the evening primrose film (L* = 34.91) and highest for the soy protein film (L* = 91.84). Parameter a* was lowest for the sunflower film (a* = -5.13) and highest for the flax film (a* = 13.62). Edible films made of pumpkin seed flour had the highest value of the b* color parameter (b* = 34.40), while films made of evening primrose flour had the lowest value (b* = 1.35). All analyzed films had relatively low mechanical resistance, with tensile strength from 0.60 to 3.09 MPa. Films made of flour containing the highest amount of protein, pumpkin and sesame, had the highest water vapor permeability, 2.41 and 2.70 × 10-9 g·m-1 s-1 Pa-1, respectively. All the edible films obtained had high water swelling values from 131.10 to 362.16%, and the microstructure of the films changed after adding the flour, from homogeneous and smooth to rough. All blended soy protein isolate-oilseed flour films showed lower thermal stability which was better observed at the first and second stages of thermogravimetric analysis when degradation occurred at lower temperatures. The oilseed flours blended with soy protein isolate show the possibility of using them in the development of biodegradable films which can find practical application in the food industry.

Candida utilis ATCC 9950 Cell Walls and ß(1,3)/(1,6)-Glucan Preparations Produced Using Agro-Waste as a Mycotoxins Trap.

Mycotoxins are harmful contaminants of food and feed worldwide. Feed additives with the abilities to trap mycotoxins are considered substances which regulate toxin transfer from feed to tissue, reducing its absorption in animal digestive tract. Market analysis emphasizes growing interest of feed producers in mycotoxins binders obtained from yeast biomass. The aim of the study was to prescreen cell walls (CW) and ß(1,3)/(1,6)-glucan (ß-G) preparations isolated from Candida utilis ATCC 9950 cultivated on waste potato juice water with glycerol as adsorbents for aflatoxin B1 (AFB1), zearalenone (ZEN), ochratoxin A (OTA), deoxynivalenol (DON), nivalenol (NIV), T-2 toxin (T-2) and fumonisin B1 (FB1). The adsorption was studied in single concentration tests at pH 3.0 and 6.0 in the presence of 1% of the adsorbent and 500 ng/mL of individual toxin. Evaluated CW and ß-G preparations had the potential to bind ZEN, OTA and AFB1 rather than DON, NIV, T-2 toxin and FB1. The highest percentage of adsorption (about 83%), adsorption capacity (approx. 41 µg/ g preparation) and distribution coefficient (458.7mL/g) was found for zearalenone when CW preparation was used under acidic conditions. Higher protein content in CW and smaller particles sizes of the formulation could influence more efficient binding of ZEN, OTA, DON and T-2 toxin at appropriate pH compared to purified ß-G. Obtained results show the possibility to transform the waste potato juice water into valuable Candida utilis ATCC 9950 preparation with mycotoxins adsorption properties. Further research is important to improve the binding capacity of studied preparations by increasing the active surface of adsorption.

Modification of the cell wall structure of Saccharomyces cerevisiae strains during cultivation on waste potato juice water and glycerol towards biosynthesis of functional polysaccharides.

Changes in cell wall structure of four strains of Sacccharomyces cerevisiae species (brewer's, baker's and probiotic yeast) after culturing on deproteinated potato juice water (DPJW) with diverse addition of glycerol and different pH were investigated. It allowed to select conditions intensifying biosynthesis of ß(1,3)/(1,6)-glucan and mannoproteins of cell walls of tested strains. Yeast cell wall structural polysaccharides show biological activity and technological usability in food industry but also decide about therapeutic properties of yeast biomass. The highest increase in the thickness of walls (by about 100%) and ß-glucan layer (by about 120%) was stated after cultivation of S. cerevisiae R9 brewer's yeast in DPJW supplemented with 5 and 10% (w/v) of glycerol and pH 7.0 while S. cerevisiae var. boulardi PAN yeast synthesized by ab. 70% thicker ß-glucan layer when the pH of growth medium was equal to 5.0. The cells of brewer's yeast (S. cerevisiae R9), probiotic (S. cerevisiae CNCM 1-745) and baker's (S. cerevisiae 102) intensified the ratio of mannoproteins in the structure of cell walls cultivated in mediums supplemented with above 15% of glycerol what point out the protective action of glycoprotein's under osmotic stress conditions. The study confirms at the first time the possibility of using agro-industrial waste in biosynthesis of functional polysaccharides of S. cerevisiae cell wall. It could be an new advantage in production of yeast biomass with therapeutic properties or ß-glucan preparation as a novel food ingredient.