Mid- and far-infrared localized surface plasmon resonances in chalcogen-hyperdoped silicon.

Plasmonic sensing in the infrared region employs the direct interaction of the vibrational fingerprints of molecules with the plasmonic resonances, creating surface-enhanced sensing platforms that are superior to traditional spectroscopy. However, the standard noble metals used for plasmonic resonances suffer from high radiative losses as well as fabrication challenges, such as tuning the spectral resonance positions into mid- to far-infrared regions, and the compatibility issue with the existing complementary metal-oxide-semiconductor (CMOS) manufacturing platform. Here, we demonstrate the occurrence of mid-infrared localized surface plasmon resonances (LSPR) in thin Si films hyperdoped with the known deep-level impurity tellurium. We show that the mid-infrared LSPR can be further enhanced and spectrally extended to the far-infrared range by fabricating two-dimensional arrays of micrometer-sized antennas in a Te-hyperdoped Si chip. Since Te-hyperdoped Si can also work as an infrared photodetector, we believe that our results will unlock the route toward the direct integration of plasmonic sensors with the on-chip CMOS platform, greatly advancing the possibility of mass manufacturing of high-performance plasmonic sensing systems.

Controlled Silicidation of Silicon Nanowires Using Flash Lamp Annealing.

Among other new device concepts, nickel silicide (NiSix)-based Schottky barrier nanowire transistors are projected to supplement down-scaling of the complementary metal-oxide semiconductor (CMOS) technology as its physical limits are reached. Control over the NiSix phase and its intrusions into the nanowire is essential for superior performance and down-scaling of these devices. Several works have shown control over the phase, but control over the intrusion lengths has remained a challenge. To overcome this, we report a novel millisecond-range flash lamp annealing (FLA)-based silicidation process. Nanowires are fabricated on silicon-on-insulator substrates using a top-down approach. Subsequently, Ni silicidation experiments are carried out using FLA. It is demonstrated that this silicidation process gives unprecedented control over the silicide intrusions. Scanning electron microscopy and high-resolution transmission electron microscopy are performed for structural characterization of the silicide. FLA temperatures are estimated with the help of simulations.

Foliage application of selenium and silicon nanoparticles alleviates Cd and Pb toxicity in rice (Oryza sativa L.).

Direct discharge of untreated industrial waste water in water bodies and then irrigation from these sources has increased trace metals contamination in paddy fields of southern China. Among trace metals, cadmium (Cd) and lead (Pb) are classified as most harmful contaminants in farmland to many organisms including plants, animals and humans. Rice is a staple food which is consumed by half population of the world; due to longer growth period it can easily absorb and accumulate the trace metals from soil. The objective of study was to check the efficacy of Se and Si NPs (nanoparticles) alone or in combination on metals accumulation and Se-fortified rice (Oryzasativa L.) production as their efficiency remained untested. Alone as well as combined application of Se- and Si-NPs (5, 10 and 20 mg L-1) was achieved along with CK. All the treatments significantly reduced the Cd and Pb contents in brown rice, except CK, Se3, Si1 and Se1Si3. Combined application of Se and Si (Se3Si2) was more effective in reducing the Cd and Pb contents by 62 and 52%, respectively. In addition, foliar application of both NPs improved the rice growth and quality by increasing the grain yield, rice biomass, and Se contents in brown rice. Highest concentration of Se (1.35 mg kg-1) in brown rice was observed with combined application of Se- and Si-Nps (Se3Si2). Selenium speciation revealed the presence of organic species (74%) in brown rice. The combinations of different doses of Se- and Si-Nps are the main determining factor for total concentration of metals in grains. These results demonstrate that foliage supplementation of Se and Si-Nps alleviate the Cd and Pb toxicity by reducing the metals' concentration in brown rice. Additionally foliage supplementation improved the nutritional quality by reducing the phytic acid contents in rice grains.

Identification of high cadmium-accumulating oilseed sunflower (Helianthus annuus) cultivars for phytoremediation of an Oxisol and an Inceptisol.

Forty oilseed sunflower cultivars were screened in two soil types for phytoremediation of Cd coupled with maximum biomass yield and oil production. Several cultivars exhibited a significant difference in biomass and yield with enhanced uptake in shoots and low accumulation in roots from two Cd-contaminated soil types, an Oxisol and an Iceptisol. The Transfer Factor of Cd was >1 in several cultivars in both soil types, where as a significant difference in phytoextraction of Cd was observed in the Oxisol (acidic soil), greater than in the Inceptisol (alkaline soil). The results revealed that of the 40 cultivars, S9178, Huanong 667in the Oxisol and cvs. DW 667, HN 667, Huanong 667 and 668F1 in the Inceptisol showed a high biomass, better yield and enhanced accumulation of Cd in the shoots but a lesser accumulation in oil. The screened cultivar S 9178 produced the greatest amount of oil (55.6%) with 77% oleic acid, which makes it suitable for human consumption. Cultivar Huanong 667 was found to be the highest accumulating cultivar in both soil types. It is therefore suggested that some sunflower cultivars do exhibit phytoremediation potential together with agro-production potential.

Hydrothermal carbonization of different wetland biomass wastes: Phosphorus reclamation and hydrochar production.

Hydrothermal carbonization (HTC) has drawn increasing interest for the disposal of solid wastes with a high moisture content, while minimal attention has been paid to HTC treatment of wetland plants and the corresponding phosphorus (P) transformation. In order to evaluate its feasibility for wetland plants treatment, hydrochars from different wetland plants were produced at different temperatures (200 °C, 220 °C, 240 °C, and 260 °C) and characterized, and the transformation of P was investigated. In comparison with wetland plant derived biochars, the derived hydrochars had a moderate pH (5.0-7.7), more oxygen-containing groups, and higher energy density (18.0-27.1 MJ kg-1). These properties were affected by hydrothermal temperature and feedstock choice. In contrast to high water-soluble P in biomass (71.0-73.2% of total P), more recalcitrant P species formed in hydrochars, implying that HTC treatment could achieve P immobilization and reduce P leaching loss. Nuclear magnetic resonance (NMR) results indicated that monoester-P and soluble orthophosphate were transformed to insoluble orthophosphate during the HTC treatment. Therefore, HTC is a promising treatment technique for wetland plants to produce valuable char with P reclamation.