RESUMEN
This study developed an analytical method to determine the urushiol content in sap and several foods. The full process for urushiol analysis consists of extraction, trimethylsilyl silylation, analysis, and identification via GC-MS, with each step optimized to attain the required accuracy and precision. Urushiol was separated from sap via liquid-liquid extraction and was derivatized via silylation. The components were analyzed using a polar capillary column and identified using GC-MS. The deviations of relative retention times and retention time windows were within 0.001 and 0.02 min, which satisfied the criteria of 0.06 and 0.03 min, respectively. The response of the urushiol standards tested was found to be linear in the investigated concentration range, with a correlation coefficient of 0.998. The LODs were between 1.74 and 2.67 µg/mL.
Asunto(s)
Catecoles/análisis , Ingredientes Alimentarios/análisis , Cromatografía de Gases y Espectrometría de Masas/métodos , Rhus/química , Catecoles/aislamiento & purificación , Límite de Detección , Extracción Líquido-Líquido , Extractos Vegetales/análisis , República de Corea , Plantones/química , Compuestos de Trimetilsililo/análisis , Compuestos de Trimetilsililo/síntesis químicaRESUMEN
A reverse-phase ultra-high-performance liquid chromatography (u-HPLC) method was developed for the rapid quantification of 22 ginsenosides in ginseng products. The proposed method for the analysis of ginsenosides is based on a heating-block method without further treatment. The u-HPLC separation was performed on a reversed C18 column (100 × 2 mm id, particle size 2 µm) followed by ultraviolet detection at 203 nm. Aqueous 50% methanol was used as the extraction solvent. The optimum amount of extraction solvent and the optimum extraction time were 20 mL and 20 min (extracted twice with 10 mL), respectively. The method validation parameters yielded good results for linearity, precision, accuracy and recovery. The recovery of ginsenosides from ginseng powder was greater than 98.1% and the limits of detection and quantification of the u-HPLC analysis were >0.6 and >1.8 mg/kg for ginsenosides. The calibration graphs for ginsenosides were linear from approximately 2.6 to 40.4 mg/kg for u-HPLC. The inter-day and intra-day precisions (relative standard deviation values) were <14.6 and 14.7%, except for Rg2(R) + Rh1(R).