Brain activation patterns during unilateral premolar occlusion.

OBJECTIVE: To observe the characteristics of brain activation during unilateral premolar occlusion. METHODS: Functional magnetic resonance imaging was collected from 10 healthy volunteers during occlusion of the left first premolar (L1), left second premolar (L2), and right first premolar (R1). The brain activation patterns were analyzed, and the primary sensorimotor cortex, supplementary motor area, insula, thalamus, and prefrontal cortex were chosen as regions of interest. RESULTS: Single premolar occlusion activated the precentral gyrus, postcentral gyrus, cerebellum, thalamus, frontal lobe, hippocampus, cingulate gyrus, and parietal lobe. The brain areas showing activation during single premolar occlusion were similar to those activated by chewing. The activation pattern of L1 was more similar to that of L2 than R1. No significant left and right hemisphere differences in signal intensity were detected within the regions of interest. CONCLUSION: Brain activation patterns from two ipsilateral premolars were more similar than the pattern from a contralateral premolar.

Effects of Danggui-Shaoyao-San on the Influence of Spatial Learning and Memory Induced by Experimental Tooth Movement.

BACKGROUND: The pain caused by orthodontic treatment has been considered as tough problems in orthodontic practice. There is substantial literature on pain which has exactly effected on learning and memory; orthodontic tooth movement affected the emotional status has been showed positive outcomes. Danggui-Shaoyao-San (DSS) is a Traditional Chinese Medicine prescription that has been used for pain treatment and analgesic effect for orthodontic pain via inhibiting the activations of neuron and glia. We raised the hypothesis that DSS could restore the impaired abilities of spatial learning and memory via regulating neuron or glia expression in the hippocampus. METHODS: A total of 36 rats were randomly divided into three groups: (1) Sham group (n = 12), rats underwent all the operation procedure except for the placement of orthodontic forces and received saline treatment; (2) experimental tooth movement (ETM) group (n = 12), rats received saline treatment and ETM; (3) DSS + ETM (DETM) group (n = 12), rats received DSS treatment and ETM. All DETM group animals were administered with DSS at a dose of 150 mg/kg. Morris water maze test was evaluated; immunofluorescent histochemistry was used to identify astrocytes activation, and immunofluorescent dendritic spine analysis was used to identify the dendritic spines morphological characteristics expression levels in hippocampus. RESULTS: Maze training sessions during the 5 successive days revealed that ETM significantly deficits in progressive learning in rats, DSS that was given from day 5 prior to ETM enhanced progressive learning. The ETM group rats took longer to cross target quadrant during the probe trial and got less times to cross-platform than DETM group. The spine density in hippocampus in ETM group was significantly decreased compared to the sham group. In addition, thin and mature spine density were decreased too. However, the DSS administration could reverse the dendritic shrinkage and increase the spine density compared to the ETM group. Astrocytes activation showed the opposite trend in hippocampus dentate gyrus (DG). CONCLUSIONS: Treatment with DSS could restore the impaired abilities on ETM-induced decrease of learning and memory behavior. The decreased spines density in the hippocampus and astrocytes activation in DG of hippocampus in the ETM group rats may be related with the decline of the ability of learning and memory. The ability to change the synaptic plasticity in hippocampus after DSS administration may be correlated with the alleviation of impairment of learn and memory after ETM treatment.

The effect of calcium phosphate composite scaffolds on the osteogenic differentiation of rabbit dental pulp stem cells.

The objective of this study is to compare the effects of the two calcium phosphate composite scaffolds on the attachment, proliferation, and osteogenic differentiation of rabbit dental pulp stem cells (DPSCs). One nano-hydroxyapatite/collagen/poly (l-lactide) (nHAC/PLA), imitating the composition and the micro-structure characteristics of the natural bone, was made by Beijing Allgens Medical Science & Technology Co., Ltd. (China). The other beta-tricalcium phosphate (ß-TCP), being fully interoperability globular pore structure, was provided by Shanghai Bio-lu Biomaterials Co, Ltd. (China). We compared the absorption water rate and the protein adsorption rate of two scaffolds and the characterization of DPSCs cultured on the culture plate and both scaffolds under osteogenic differentiation media (ODM) treatment. The constructs were then implanted subcutaneously into the back of severely combined immunodeficient (SCID) mice for 8 and 12 weeks to compare their bone formation capacity. The results showed that the ODM-treated DPSCs expressed osteocalcin (OCN), bone sialoprotein (BSP), type I collagen (COLI) and osteopontin (OPN) by immunofluorescence staining. Positive alkaline phosphatase (ALP) staining, calcium deposition and calcium nodules were also observed on the ODM-treated DPSCs. The absorption water rate and protein adsorption rate of nHAC/PLA was significantly higher than ß-TCP. The initial attachment of DPSCs seeded onto nHAC/PLA was significantly higher than that onto ß-TCP; and the proliferation rate of the cells was also significantly higher than that of ß-TCP on 1, 3, and 7 days of cell culture. The ALP activity, calcium/phosphorus content and mineral formation of DPSCs + ß-TCP were significantly higher than DPSCs + nHAC/LA. When implanted into the back of SCID mice, nHAC/PLA alone had no new bone formation, newly formed mature bone and osteoid were only observed in ß-TCP alone, DPSCs + nHAC/PLA and DPSCs + ß-TCP, and this three groups displayed increased bone formation over the 12-week period. The percentage of total bone formation area had no difference between DPSCs + ß-TCP and DPSCs + nHAC/PLA at each time point, but the percentage of mature bone formation area of DPSCs + ß-TCP was significantly higher than that of DPSCs + nHAC/PLA. Our results demonstrated that the DPSCs on nHAC/PLA had a better proliferation, and that the DPSCs on ß-TCP had a more mineralization in vitro, much more newly formed mature bones in vivo were presented in DPSCs + ß-TCP group. These findings have provided a further knowledge that scaffold architecture has different influence on the attachment, proliferation and differentiation of cells. This study may provide insight into the clinical periodontal bone tissue repair with DPSCs + ß-TCP construct.

New nano-sized Al2O3-BN coating 3Y-TZP ceramic composites for CAD/CAM-produced all-ceramic dental restorations. Part I. Fabrication of powders.

Partially sintered 3 mol % yttria-stabilized tetragonal zirconium dioxide (ZrO(2), zirconia) polycrystal (3Y-TZP) ceramics are used in dental posterior restorations with computer-aided design-computer-aided manufacturing (CAD/CAM) techniques. High strength is acquired after sintering, but shape distortion of preshaped compacts during their sintering is inevitable. The aim of this study is to fabricate new machinable ceramic composites with strong mechanical properties that are fit for all-ceramic dental restorations. Aluminum oxide (Al(2)O(3))-coated 3Y-TZP powders were first prepared by the heterogeneous precipitation method starting with 3Y-TZP, Al(NO(3))(3) . 9H(2)O, and ammonia, then amorphous boron nitride (BN) was produced and the as-received composite powders were coated via in situ reaction with boric acid and urea. Transmission electron microscopy (TEM) and X-ray diffraction (XRD) were used to analyze the status of Al(2)O(3)-BN on the surface of the 3Y-TZP particles. TEM micrographs show an abundance of Al(2)O(3) particles and amorphous BN appearing uniformly on the surface of the 3Y-TZP particles after the coating process. The size of the Al(2)O(3) particles is about 20 nm. The XRD pattern shows clearly the peak of amorphous BN among the peaks of ZrO(2).

[Preparation and chromaticity properties of colored dental 3Y-TZP ceramics].

OBJECTIVE: To obtain and investigate the chromaticity properties of colored dental 3Y-TZP ceramics with different colorant combinations. METHODS: Colorant combinations were mixed with TZ-3Y-S powder, then the mixtures were compacted at 200 MPa using cold isostatic pressure, densely sintered at 1500 degrees C for 2 h forming 5 graded colored dental zirconia ceramics. Specimen were sectioned into 10 mm x 10 mm x 0.5 mm and 10 mm x l0 mmx 1 mm slices from the sintered blocks. Color measurement was performed under black background using spectrophotometer. The chromaticity properties were compared with that of the VITA In-Ceram YZ shade guide. RESULTS: Five colored dental zirconia ceramics were obtained. The lightness decreased gradually, and the chroma value increased gradually. The color differences of the two thickness specimens were little. The parameters of the color space were L*: 67.76-77.78; a*: -2.19-3.80; b*: 12.13-25.01, which was similar with that of the VITA In-Ceram YZ shade guide, while the lowest value of lightness was relatively higher than that of the VITA In-Ceram YZ shade guide. CONCLUSION: Colored 3Y-TZP dental ceramics are suitable for clinical use. There is a need to develop more darkness shaded zirconia dental ceramics.