Temporal chemical composition changes in water below a crude oil slick irradiated with natural sunlight.

Photooxidation can alter the environmental fate and effects of spilled oil. To better understand this process, oil slicks were generated on seawater mesocosms and exposed to sunlight for 8 days. The molecular composition of seawater under irradiated and non-irradiated oil slicks was characterized using ion mobility spectrometry-mass spectrometry and polyaromatic hydrocarbons analyses. Biomimetic extraction was performed to quantify neutral and ionized constituents. Results show that seawater underneath irradiated oil showed significantly higher amounts of hydrocarbons with oxygen- and sulfur-containing by-products peaking by day 4-6; however, concentrations of dissolved organic carbon were similar. Biomimetic extraction indicated toxic units in irradiated mesocosms increased, mainly due to ionized components, but remained <1, suggesting limited potential for ecotoxicity. Because the experimental design mimicked important aspects of natural conditions (freshly collected seawater, natural sunlight, and relevant oil thickness and concentrations), this study improves our understanding of the effects of photooxidation during a marine oil spill.

Oil Irradiation Experiments Document Changes in Oil Properties, Molecular Composition, and Dispersant Effectiveness Associated with Oil Photo-Oxidation.

While chemical dispersants are a powerful tool for treating spilled oil, their effectiveness can be limited by oil weathering processes such as evaporation and emulsification. It has been suggested that oil photo-oxidation could exacerbate these challenges. To address the role of oil photo-oxidation in dispersant effectiveness, outdoor mesocosm experiments with crude oil on seawater were performed. Changes in bulk oil properties and molecular composition were quantified to characterize oil photo-oxidation over 11 days. To test relative dispersant effectiveness, oil residues were evaluated using the Baffled Flask Test. The results show that oil irradiation led to oxygen incorporation, formation of oxygenated hydrocarbons, and higher oil viscosities. Oil irradiation was associated with decreased dispersant efficacy, with effectiveness falling from 80 to <50% in the Baffled Flask Test after more than 3 days of irradiation. Increasing photo-oxidation-induced viscosity seems to drive the decreasing dispersant effectiveness. Comparing the Baffled Flask Test results with field data from the Deepwater Horizon oil spill showed that laboratory dispersant tests underestimate the dispersion of photo-oxidized oil in the field. Overall, the results suggest that prompt dispersant application (within 2-4 days), as recommended by current oil spill response guidelines, is necessary for effective dispersion of spilled oil.

Biodegradation of dispersed oil in Arctic seawater at -1°C.

As offshore oil and gas exploration expands in the Arctic, it is important to expand the scientific understanding of arctic ecology and environmental impact to mitigate operational risks. Understanding the fate of oil in arctic seawater is a key factor for consideration. Here we report the chemical loss due to the biodegradation of Alaska North Slope (ANS) crude oil that would occur in the water column following the successful dispersion of a surface oil slick. Primary biodegradation and mineralization were measured in mesocosms containing Arctic seawater collected from the Chukchi Sea, Alaska, incubated at -1°C. Indigenous microorganisms degraded both fresh and weathered oil, in both the presence and absence of Corexit 9500, with oil losses ranging from 46-61% and up to 11% mineralization over 60 days. When tested alone, 14% of 50 ppm Corexit 9500 was mineralized within 60 days. Our study reveals that microorganisms indigenous to Arctic seawater are capable of performing extensive biodegradation of chemically and physically dispersed oil at an environmentally relevant temperature (-1°C) without any additional nutrients.

The acute toxicity of chemically and physically dispersed crude oil to key Arctic species under Arctic conditions during the open water season.

The acute toxicity of physically and chemically dispersed crude oil and the dispersant Corexit 9500 were evaluated for key Arctic species. The copepod Calanus glacialis, juvenile Arctic cod (Boreogadus saida), and larval sculpin (Myoxocephalus sp.) were tested under conditions representative of the Beaufort and Chukchi Seas during the ice-free season. The toxicity of 3 water-accommodated fractions (WAF) of Alaska North Slope crude oil was examined with spiked, declining exposures. A dispersant-only test was conducted with the copepod C. glacialis. Each preparation with oil (WAF, breaking wave WAF [BWWAF], and chemically enhanced WAF [CEWAF]) produced distinct suites of hydrocarbon constituents; the total concentrations of oil were lowest in WAF and highest in CEWAF preparations. The relative sensitivity for the different species and age classes was similar within each WAF type. Median lethal concentration values based on total petroleum hydrocarbons ranged from 1.6 mg/L to 4.0 mg/L for WAF and BWWAF treatments and from 22 mg/L to 62 mg/L for CEWAF. For Corexit 9500 exposures, median lethal concentration values ranged from 17 mg/L to 50 mg/L. The differences in the relative toxicity among the accommodated fractions indicated that the majority of petroleum hydrocarbons in the CEWAF are in less acutely toxic forms than the components that dominate the WAF or BWWAF. Further evaluation showed that the parent polycyclic aromatic hydrocarbon compounds, specifically naphthalene, were highly correlated to acute toxicity.

The primary biodegradation of dispersed crude oil in the sea.

Dispersants are important tools for stimulating the biodegradation of large oil spills. They are essentially a bioremediation tool - aiming to stimulate the natural process of aerobic oil biodegradation by dispersing oil into micron-sized droplets that become so dilute in the water column that the natural levels of biologically available nitrogen, phosphorus and oxygen are sufficient for microbial growth. Many studies demonstrate the efficacy of dispersants in getting oil off the water surface. Here we show that biodegradation of dispersed oil is prompt and extensive when oil is present at the ppm levels expected from a successful application of dispersants - more than 80% of the hydrocarbons of lightly weathered Alaska North Slope crude oil were degraded in 60 d at 8 °C in unamended New Jersey (USA) seawater when the oil was present at 2.5 ppm by volume. The apparent halftime of the biodegradation of the hydrocarbons was 13.8 d in the absence of dispersant, and 11 d in the presence of Corexit 9500 - similar to rates extrapolated from the field in the Deepwater Horizon response.