Curcumin encapsulation in capsules and fibers of potato starch by electrospraying and electrospinning: Thermal resistance and antioxidant activity.

The aim of this work was to encapsulate curcumin at different concentrations in capsules and fibers of native potato starch by electrospraying and electrospinning. The best conditions for the production of capsules and fibers were obtained by varying the polymer concentration and resting time of the polymer solution. The best conditions were used for the encapsulation of curcumin. The curcumin-loaded capsules and fibers had an average diameter of 1373 nm to 1787 nm and 108 nm to 142 nm, respectively, and had a high curcumin loading capacity with values ranging from 79.01 % to 97.09 %. Curcumin encapsulated in starch capsules and fibers showed higher thermal stability at 180 °C for 2 h compared to unencapsulated curcumin. The antioxidant activity of starch fibers containing 1 % of curcumin had the greatest ability to inhibit the ABTS radical (45 % inhibition). These materials are promising for use in food or active packaging.

Lipid oxidation and sensory characterization of Omega-3 rich buffalo burgers enriched with chlorogenic acids from the mate (Ilex paraguariensis) tree harvesting residues.

A freeze-dried extract from the bark of mate branches (BMBE) containing high chlorogenic acids (CGA) content (30 g 100 g-1) was produced. Then, chia oil was mixed with 7.5% BMBE and sonicated for 0, 10, and 20 min. Chia oil with or without the addition of BMBE was hydrogelled and used to produce buffalo burgers with 50% reduction in animal fat. CGA levels and the nutritional, oxidative, and sensory properties of the burgers were analyzed. A reduction of ~30% fat and an increase above 60% PUFA/SFA ratio was observed for the reformulated raw and cooked burgers. In addition, the Omega-6/Omega-3 PUFA ratio of the burgers decreased from 20.8 (raw) and 31.9 (cooked) to values lower than 2. The addition of BMBE enriched the burgers with CGA, preventing an increase in lipid oxidation caused by chia oil. The addition of BMBE-enriched hydrogelled chia oil not subjected to sonication did not affect the sensory properties of the burgers.

Characterization and quantification of bioactive compounds from Ilex paraguariensis residue by HPLC-ESI-QTOF-MS from plants cultivated under different cultivation systems.

Ilex paraguariensis is a perennial plant used in the production of mate tea, "chimarrão" and "tererê," cosmetics, and other food products. Its leaves are harvested every 12 or 18 months. Approximately 2 to 5 tons of residue are generated per hectare during the harvest. The bioactive composition of this residue has not been characterized to date. Therefore, this paper presents for the first time, the simultaneous characterization of the bioactive compounds of the leaves, thin branches, and thick branches (residue) from I. paraguariensis grown under two cultivation systems: "full sun" and "shaded." The identification and quantification of the compounds was performed using high-performance liquid chromatography coupled to electrospray ionisation and quadrupole time-of-flight mass spectrometer (HPLC-ESI-QTOF-MS). Consequently, 35 compounds were identified. The average dry weight of phenolic compounds in the residue was 4.1 g/100 g, whereas that in the bark of the residue was 12.9 g/100 g, which was similar to the content found in leaves. The same compounds were identified in the two cultivation systems but with a difference in their contents. While the "full sun" cultivation had a higher content of phenolic acids, the "shaded" cultivation had a higher content of flavonoids and saponins. It was found that the I. paraguariensis residue, particularly the bark, is rich in bioactive compounds, such as quinic, 3-caffeoylquinic, 5-cafefoylquinic, 3,5-dicaffeoylquinic, and 4,5-dicaffeoylquinic acids as well as rutin, and their contents vary according to the cultivation system. Therefore, this residue is an underutilized natural resource with a potential for industrial applications. PRACTICAL APPLICATION: Yerba mate producers will be able to choose the best cultivation system ("full sun" or "shaded") to increase the content of bioactive compounds. New products may be developed with yerba mate residue due to its high concentration of compounds that are beneficial to the human health. New destinations may be applied to yerba mate residue from the harvest pruning, adding commercial value to this unexplored natural resource.

Impact of the use of saccharides in the encapsulation of Ilex paraguariensis extract.

The yerba mate (Ilex paraguariensis A.St.-Hil.) is abundant on phenolic compounds and their preservation by encapsulation can promote increased stability. The objective was to produce mate extract with a high concentration of bioactive compounds, microencapsulate and characterize them. A commercial yerba mate was used to produce the extracts and select the best extraction solvent (ethanol, water, and ethanol:water (1:1). The ethanol:water extract was encapsulated at 1:1 (w/w) by fructooligosaccharide (FOS) and gum arabic (GA), in different combinations: FOS, GA:FOS (1:3), GA:FOS (1:1), GA:FOS (3:1) and GA. The encapsulation of chlorogenic acids was around 80%, considering the major phenolic compounds by HPLC. Thermal stability, by DSC, increased at treatments FOS, GA:FOS (1:3), and GA:FOS (1:1) compare to the unencapsulated extract, and changes were noticed in ATR-FTIR bands and antioxidant activity. The encapsulated phenolic compounds from I. paraguariensis can be stable in food under heat processing.

Chlorogenic acids and flavonoid extraction during the preparation of yerba mate based beverages.

This study determined the content of chlorogenic acids (CA) and rutin during successive aqueous extraction of yerba mate for tererê and chimarrão from four yerba mate types (smooth, native, traditional and coarse ground). Aqueous extracts were prepared aiming to simulate homemade procedure by partially (chimarrão) or completely (tererê) immersing the herb into hot (chimarrão) or cold (tererê) water (30 times consecutively). The content of CA and rutin in the aqueous extracts was compared to those in methanolic extracts (exhaustive extraction). Tererê aqueous extracts gave higher amounts of all phenolic compounds (2.5 to 6 times higher than chimarrão). Among chimarrão, course-ground aqueous extracts had on average 15% more PC (phenolic compounds). By comparing the content in aqueous and methanolic extracts, after 30 successive extractions, on average 14% of the total amount of CA in yerba mate leaves and 9% of rutin were transferred to the chimarrão extracts, whereas tererê achieved between 40% and 100% of transference. Thus, this study shows that CA and rutin are continuously extracted during the preparation of aqueous extracts of chimarrão and tererê, favoring a high intake of these antioxidant species by consumers.

Chlorogenic acid isomer contents in 100 plants commercialized in Brazil.

This study analysed 100 plants employed in Brazil as ingredients to infusions for their caffeic acid, 3-caffeoylquinic acid (3-CQA), 4-caffeoylquinic acid (4-CQA), 5-caffeoylquinic acid (5-CQA), 3,4-dicaffeoylquinic acid (3,4-DQA), 3,5-dicaffeoylquinic acid (3,5-DQA), and 4,5-dicaffeoylquinic acid (4,5-DQA) contents. The samples were collected from public markets and analysed using ultra-high performance liquid chromatography (UPLC). The highest concentrations of chlorogenic acids were found in yerba mate (Ilex paraguariensis), 9,2g·100g-1, white tea (Camellia sinensis), winter's bark (Drimys winteri), green tea (Camellia sinensis), elderflower (Sambucus nigra), and Boehmeria caudata (known as assa-peixe in Brazil), 1,1g·100g-1. The present work showcased the investigation of chlorogenic acids in a wide range of plants not yet studied in this regard and also resulted in a comparative table which explores the content of six isomers in the samples.

Optimization of the Preparation Conditions of Yerba Mate tea Beverage to Maximize Chlorogenic Acids Extraction.

The beverage obtained from the yerba mate tea, besides being the most consumed in Brazil, has high concentrations of chlorogenic acids. In this study, a central composite design was employed to establish the best infusion time, temperature and water volume to maximize the extraction of chlorogenic acids 5-caffeoylquinic (5CQ), 3.4-dicaffeoylquinic (3.4 DQ), 3.5-dicaffeoylquinic (3.5 DQ) and 4.5-dicaffeoylquinic (4.5 DQ), from the leaves and stems of yerba mate tea (beverage ready for consumption). Analyses were performed by high-performance liquid chromatography and the optimum conditions were obtained through the use of the desirability function of Derringer and Suich. The maximum chlorogenic acids content in the beverage was obtained when the infusion was prepared with 2 g of mate tea, in 300 mL of water at 95 °C, under infusion for 16 min. The optimal conditions were applied for the preparation of beverages from 15 commercial samples of yerba mate tea, and it was observed that the sum of the concentration of the four compounds showed variation of up to 79 times between the average of the samples, which can be attributed to climatic conditions of cultivation of the plant and/or of processing.

Phenolic compounds from yerba mate based beverages--A multivariate optimisation.

This work used a central composite design to optimise a reverse phase high performance liquid chromatographic method for the simultaneous separation of gallic, syringic, 5-caffeoylquinic, caffeic, p-coumaric, ferulic, 3,4-dicaffeoylquinic, 3,5-dicaffeoylquinic, 4,5-dicaffeoylquinc acids, rutin in aqueous extracts of yerba mate (Ilex paraguariensis). The effect of the linear gradient time, the initial and the final methanol concentration in the mobile phase on the peak resolution and peak symmetry was evaluated. The 26 responses obtained were simultaneously optimised using the desirability method of Derringer and Suich. According to results, the increasing in the resolution and peak symmetry was achieved by using lesser levels of methanol in both initial and final gradient elution (-1.68, -1), as well as higher gradient times (+1, +1.68). The optimal condition (13.9-40% of methanol in 39.4 min) were successfully applied for analysis of chimarrão, tererê and mate tea aqueous extracts, which showed as excellent sources of chlorogenic acids.

Doehlert design-desirability function multi-criteria optimal separation of 17 phenolic compounds from extra-virgin olive oil by capillary zone electrophoresis.

In Brazil, the consumption of extra-virgin olive oil (EVOO) is increasing annually, but there are no experimental studies concerning the phenolic compound contents of commercial EVOO. The aim of this work was to optimise the separation of 17 phenolic compounds already detected in EVOO. A Doehlert matrix experimental design was used, evaluating the effects of pH and electrolyte concentration. Resolution, runtime and migration time relative standard deviation values were evaluated. Derringer's desirability function was used to simultaneously optimise all 37 responses. The 17 peaks were separated in 19min using a fused-silica capillary (50µm internal diameter, 72cm of effective length) with an extended light path and 101.3mmolL(-1) of boric acid electrolyte (pH 9.15, 30kV). The method was validated and applied to 15 EVOO samples found in Brazilian supermarkets.

Common sources and composition of phytosterols and their estimated intake by the population in the city of São Paulo, Brazil.

OBJECTIVE: Phytosterols have been used alone, or combined with lipid-altering drugs, to reduce cholesterol levels and the burden of cardiovascular disease. Considerable variation in the composition of phytosterols exists and its consumption, in a regular diet, by the Brazilian population is still unknown. Thus, the aim of the present study was to determine the phytosterols content of the most consumed plant foods and to estimate the phytosterols intake by this population. METHODS: Intake of plant foods of a representative population of the city of São Paulo (n = 1609), randomly selected on the basis of the Brazilian Institute for Geography and Statistics census data (2010), was obtained by a food frequency questionnaire (FFQ). Foods were chosen on the basis of the Consume Expenditure Survey (2002-2003) and from answers to the FFQ. Phytosterols composition of most consumed greens, legumes, cereals, and seeds, fruits, and vegetable oils was determined by gas chromatography (flame ionization detection). Daily phytosterols intake was estimated in terms of mg per 100 g (mg/100 g(-1)) of edible portion. Underreporters and overreporters were excluded. RESULTS: Mean (SE) daily phytosterols intake in the diet of the study population was 100.6 (1.2) mg, with ß-sitosterol as the largest sterol component (65.4%), followed by campesterol (23.2%), and stigmasterol (10%). No significant changes in daily phytosterols intake were observed after exclusion of underreporters and overreporters. Considerable variation was observed in phytosterols content among the most consumed plant foods. CONCLUSIONS: Analysis of phytosterols composition in most consumed plant foods has shown that phytosterols content varied among food groups. Dietary intake of phytosterols in a large population of the city of São Paulo is in the same range of some countries.

Use of multivariate statistical techniques to optimize the simultaneous separation of 13 phenolic compounds from extra-virgin olive oil by capillary electrophoresis.

Characterization of phenolic compounds in olive oil has not been achieved as yet, owing to the complexities of their chemical structures and analytical matrix. The aim of this work is to optimize and validate a method for simultaneous separation and quantification of 13 phenolic compounds from extra-virgin olive oil: tyrosol, hydroxytyrosol, oleuropein glycoside, ferrulic acid, p-coumaric acid, cinnamic acid, p-hydroxybenzoic acid, gallic acid, caffeic acid, luteolin, apigenin, vanillic acid and 3,4-dihydroxybenzoic acid. A statistical central composite design, response surface analysis and the simultaneous optimization method of Derringer and Suich were used to separate all the peaks. These multivariate procedures were efficient in determining the optimal separation condition, using five peak-pair resolutions and runtime as responses. The optimized method employed a fused-silica capillary of 50 µm i.d.× 60 cm effective length with extended light path, 50 mmol L(-1) boric acid electrolyte, 10.2 pH, 25°C, injection of 50 mbar for 25s with application of reverse voltage (-30 kV for 5s) before setting the running voltage (+30 kV) with detection at 210 nm and a run time of 12 min. Peak resolutions are found to be very sensitive to pH values outside the 10.15-10.25 range but acceptable electropherograms can be obtained for a wide range of boric acid concentrations within this pH interval.