Precise recognition and efficient recovery of Pd(II) from high-level liquid waste by a novel aminothiazole-functionalized silica-based adsorbent.

Efficient recognition, separation and recovery of palladium from high-level liquid waste (HLLW) not only helps the safe, green and environmentally friendly disposal of nuclear waste, but also is an essential important supplement to overcome the growing shortage of natural palladium resources. Herein, a novel silica-based functional adsorbent named 2AT-SiAaC was prepared by a two-step method, i.e., grafting of 2-aminothiazole (2AT) via the amidated reaction after in-situ polymerization of acrylic monomers on porous silica. SEM, EDS, TG-DSC, BET and PXRD all proved the successful preparation of 2AT-SiAaC, and it exhibited ultrahigh adsorption selectivity for Pd(II) (Kd (distribution coefficient) ≥ 10,344.2 mL/g, SFPd/M (separation factor) ≥ 613.7), fast adsorption kinetics with short equilibrium time (t ≤ 1 h) and good adsorption capacity (Q ≥ 62.1 mg Pd/g). The dynamic column experiments shows that 2AT-SiAaC achieved efficiently separation of Pd(II) from simulated HLLW, and the enrichment coefficients (C/C0) of Pd(II) was as high as about 14 with the recovery rate nearly 99.9% and basically kept the same performance in three adsorption-desorption column cycle experiments. The adsorption mechanism was analyzed by FT-IR, XPS and DFT calculations, and the ultrahigh selectivity of 2AT-SiAaC was attributed to the preferred affinity of the soft N-donor atoms in 2AT for Pd(II). NO3- ions participated in the adsorption reaction to keep charge balance, and the frontier orbital electron density distribution diagram shows the charge transfer in the process of material preparation and adsorption. To sum up, 2AT-SiAaC adsorbent provided a new insight for precise recognition and efficient separation of Pd(II) from HLLW.

Synthesis and fabrication of segregative and durable MnO2@chitosan composite aerogel beads for uranium(VI) removal from wastewater.

To address the imperative need for efficient removal of uranium-containing wastewater and mitigate radioactive contamination risks associated with nuclear energy, the development of materials with high removal efficiency and facile separation is crucial. This study designed and synthesised MnO2@chitosan (CTS) composite aerogel beads by in-situ growing δ-MnO2 on porous CTS aerogel beads. This approach not only mitigates the agglomeration of MnO2 nanospheres but also significantly enhances the porous structure and surface area of MnO2@CTS. These cost-effective and eco-friendly millimeter-scale spherical aerogels exhibited convenient separation properties after adsorption. These characteristics help mitigate the risk of equipment seam blockage and secondary pollution that are often associated with powdered adsorbents. Additionally, MnO2@CTS exhibited remarkable mechanical strength (stress approximately 0.55 MPa at 60 % strain), enabling rapid separation and easy regeneration while maintaining high adsorption performance even after five cycles. Significantly, MnO2@CTS exhibited a maximum adsorption capacity of 410.7 mg/g at pH 6 and 298 K, surpassing reported values for most CTS/MnO2-based adsorbents. The chemisorption process of U(VI) on MnO2@CTS followed the pseudo-second-order kinetic and Dubinin-Radushkevish models. X-ray photoelectron spectroscopy analysis further confirmed the reduction of U(VI) to U(V/IV). These findings highlight the substantial potential of MnO2@CTS aerogel beads for U(VI) removal from aqueous solutions, positioning them as a promising solution for addressing U(VI) contamination in wastewater.

Hydrothermal-treatment desorption of cesium from clay minerals: The roles of organic acids and implications for soil decontamination.

The adsorption and desorption of cesium (Cs) on clays of contaminated soil in a rhizosphere zone can be greatly affected by various biogeochemical processes, the timespans of which are usually months to years. Herein, we present several representative scenarios of the binding of Cs on diverse sites of vermiculitized biotite by controlled Cs adsorption to particles of different sizes. We investigated whether and how the fixed Cs in the different scenarios is desorbed by ambient and hydrothermal treatments with several low-molecular-weight organic acids (LMWOAs). The results showed that the sorbed Cs was discriminatively retained in the un-collapsed, partially collapsed, and thoroughly collapsed structures of vermiculites. The desorption of the sorbed Cs by hydrothermal LMWOAs extractions was easily realized in the un-collapsed structure, but was limited or minimal in the partially collapsed and thoroughly collapsed structures. The Cs desorption varied in accord with the LMWOA species applied and increased with the acid concentration, temperature, and number of treating cycles. The analysis of Cs-desorbed specimens confirmed their partial destruction and interlayer expansion, suggesting that the underlying mechanism of Cs removal by LMWOAs involves not only acid dissolution and complexation but also the accelerated weathering of clays within a short time under hydrothermal conditions. Our findings contribute novel insights into the mobility, bioavailability, and fate of Cs in contaminated soils and its removal from these soils for environmental restorations.