Effect of temperature and pH on the properties of skim milk gels made from a tamarillo (Cyphomandra betacea) coagulant and rennet.

Reconstituted skim milk was gelled with a crude protease extract from tamarillo [Cyphomandra betacea or Solanum betacea (syn.)] fruit and compared with gels prepared with calf rennet. The effects of temperature and pH on the gelation of skim milk were investigated by small deformation oscillatory rheology. The tamarillo extract-induced gels had a faster rate of increase in the elastic modulus (G') at the early stage of gelation than rennet-induced milk gels. This was probably due to the broader proteolytic activity of tamarillo protease extracts as shown by sodium dodecyl sulfate-PAGE analysis. Confocal microscopy also showed that the milk gels resulting from the addition of tamarillo extracts had larger voids than rennet-induced milk gels. The proteolytic activity of tamarillo extracts was found to be optimal at pH 11. For both rennet and tamarillo extracts, the aggregation time was similar between pH 6.7 and 6.5, but the aggregation time of rennet-induced milk gels was lower than that of milk gels obtained by the addition of tamarillo extracts at pH lower than 6.5. An increase in temperature was found to have a significant effect on aggregation time, particularly at 20°C, where rennet did not coagulate milk in 3 h but the tamarillo extracts coagulated milk within 2 h. The results of this study suggest that extracts from tamarillo fruit could be used for milk gelation, particularly under lower temperature or high pH conditions.

Determination of immunoglobulin G in bovine colostrum and milk powders, and in dietary supplements of bovine origin by protein G affinity liquid chromatography: collaborative study.

An AOAC collaborative study was conducted to evaluate an affinity LC procedure for measuring immunoglobulin G (IgG) in selected dairy powders. The powders were extracted with 0.15 M sodium chloride solution and the pH was adjusted to 4.6 to precipitate caseins, which would otherwise lead to an overestimation of IgG. The analyte was then bound to a commercially available Protein G affinity cartridge and selectively eluted with a glycine buffer at pH 2.5. Detection was at 280 nm and quantification was made against a calibration curve prepared from bovine serum IgG. The samples analyzed included the likely matrixes for which this assay will find commercial use, namely, high- and low-protein-content colostrum powders, tablets containing colostrum powder, and some IgG-containing dairy powders; milk protein isolate, whey protein concentrate, and skim milk powder. Eleven laboratories provided data for the study and assayed blind duplicates of six materials. The repeatability RSD values ranged from 2.1 to 4.2% and the reproducibility RSD values ranged from 6.4 to 18.5%. The Protein G method with casein removal has adequate reproducibility for measuring IgG in colostrum-derived powders that are traded on the basis of IgG content as a colostral marker.

Direct measurements of interfacial interactions between pectin and kappa-casein and implications for the stabilisation of calcium-free casein micelle mimics.

Using Surface Plasmon Resonance (SPR) it has been shown that the fine structure of the anionic polysaccharide pectin strongly influences its interfacial interaction with a kappa-casein layer coated onto a gold surface (via a dextran linker) in the pH range 3.5-6.8, with the highest SPR signal being observed for pectin with the lowest charge density tested (a degree of methylesterification (DM) around 90%). Furthermore, the Brownian motions of kappa-casein coated polystyrene beads (used to provide calcium-free 'model casein micelles') were studied in pectin solutions using Diffusing Wave Spectroscopy (DWS) and microscopy, and were compared with measurements made on naked beads. At every pH value studied (with the exception of 3.5), bridging of the protein-covered probe particles was observed for pectins of both DM 28 and DM 78. However, no aggregated complexes were found in these model casein micelle systems when pectin of an unusually high DM was used (90%). It was hypothesised that having a limited number of binding regions of spatially limited extent maximises the number of chains binding to the protein layer (as found with the SPR measurement), encourages the formation of loops and trains, and additionally limits the potential for destabilisation via bridging.