UV/TiO2 photocatalysis as post-treatment of anaerobic membrane bioreactor effluent for reuse.

Advanced oxidation processes have been widely applied as a post-treatment solution to remove residual organic compounds in water reuse schemes. However, UV/TiO2 photocatalysis, which provides a sustainable option with no continuous chemical addition, has very rarely been studied to treat anaerobically treated effluents. In the current study, the removal of organics and nutrients from an anaerobic membrane bioreactor (AnMBR) effluent is evaluated during adsorption and photocatalysis processes under various conditions of TiO2 dose and UV intensity and compared to the effluent from an aerobic membrane bioreactor (AeMBR). The sequence for preferential adsorption on TiO2 was found to be phosphorus, inorganic carbon and then ammonia/organic carbon were found. The competing effect between the organics and nutrients, along with the low UV transmission efficiency caused by the need for high doses of TiO2, ultimately compromise the organic removal efficiency in the AnMBR permeate. TiO2 dosage was found to have a greater impact than UV intensity on improving the overall removal performance as nutrients are competing for the adsorption site but are not photodegraded. Under the same operational condition, the UV/TiO2 photocatalysis displayed a higher removal efficiency of organic matter and phosphorus in the AeMBR effluent due to a lower initial organics concentration and absence of ammonia as compared to the AnMBR effluent.

Recovery and reuse of alginate in an immobilized algae reactor.

The use of microalgae for nutrients removal from wastewater has attracted more attention in recent years. More specifically, immobilized systems where algae cells are entrapped in beads in a matrix of a polysaccharide such as alginate have shown a great potential for nutrients removal from wastewater to low levels with reduced retention times and hence smaller footprint. However, a significant operational cost in the up-scaling of alginate-immobilized algae reactors will be the gelling agent alginate. To reduce expenditure of this consumable a proof-of-concept is given for an alginate recycling method using sodium citrate as a dissolving agent. Using algae beads made from virgin and recycled alginate yielded comparable removal rates for both phosphorus and nitrogen compounds from wastewater. At labscale, an alginate recovery of approximately 70% can be achieved which would result in a net operational cost reduction of about 60%.

Influence of microalgal N and P composition on wastewater nutrient remediation.

Microalgae have demonstrated the ability to remediate wastewater nutrients efficiently, with methods to further enhance performance through species selection and biomass concentration. This work evaluates a freshwater species remediation characteristics through analysis of internal biomass N:P (nitrogen:phosphorus) and presents a relationship between composition and nutrient uptake ability to assist in species selection. Findings are then translated to an optimal biomass concentration, achieved through immobilisation enabling biomass intensification by modifying bead concentration, for wastewaters of differing nutrient concentrations at hydraulic retention times (HRT) from 3 h to 10 d. A HRT <20 h was found suitable for the remediation of secondary effluent by immobilised Scenedesmus obliquus and Chlorella vulgaris at bead concentrations as low as 3.2 and 4.4 bead·mL(-1). Increasing bead concentrations were required for shorter HRTs with 3 h possible at influent concentrations <5 mgP L(-1).