Accumulation Capacity of Nickel and Zinc in Yerba Mate Cultivated in Soils with Contrasting Parent Materials.

Yerba mate (Ilex paraguariensis St. Hill.) has shown a relatively high capacity for micronutrient absorption and could be a candidate for biofortification and combating a lack of micronutrients. To further evaluate the accumulation capacity of Ni and Zn, yerba mate clonal seedlings were grown in containers under five rates of Ni or Zn (0, 0.5, 2, 10, and 40 mg kg-1) with three soils originating from different parent material (basalt, rhyodacite, and sandstone). After 10 months, plants were harvested, divided into component parts (leaves, branches, and roots), and evaluated for 12 elements. The use of Zn and Ni enhanced seedling growth under rhyodacite- and sandstone-derived soils at the first application rate. Application of Zn and Ni resulted in linear increases based on Mehlich I extractions; recovery of Ni was smaller than Zn. Root Ni concentration increased from approximately 20 to 1000 mg kg-1 in rhyodacite-derived soil and from 20 to 400 mg kg-1 in basalt- and sandstone-derived soils; respective increases in leaf tissue were ~ 3 to 15 mg kg-1 and 3 to 10 mg kg-1. For Zn, the maximum obtained values were close to 2000, 1000, and 800 mg kg-1 for roots, leaves, and branches for rhyodacite-derived soils, respectively. Corresponding values for basalt- and sandstone-derived soils were 500, 400, and 300 mg kg-1, respectively. Although yerba mate is not a hyperaccumulator, this species has a relatively high capacity to accumulate Ni and Zn in young tissue with the highest accumulation occurring in roots. Yerba mate showed high potential to be used in biofortification programs for Zn.

Measurements of Soil Carbon by Neutron-Gamma Analysis in Static and Scanning Modes.

The herein described application of the inelastic neutron scattering (INS) method for soil carbon analysis is based on the registration and analysis of gamma rays created when neutrons interact with soil elements. The main parts of the INS system are a pulsed neutron generator, NaI(Tl) gamma detectors, split electronics to separate gamma spectra due to INS and thermo-neutron capture (TNC) processes, and software for gamma spectra acquisition and data processing. This method has several advantages over other methods in that it is a non-destructive in situ method that measures the average carbon content in large soil volumes, is negligibly impacted by local sharp changes in soil carbon, and can be used in stationary or scanning modes. The result of the INS method is the carbon content from a site with a footprint of ~2.5 - 3 m2 in the stationary regime, or the average carbon content of the traversed area in the scanning regime. The measurement range of the current INS system is >1.5 carbon weight % (standard deviation ± 0.3 w%) in the upper 10 cm soil layer for a 1 hmeasurement.