Phytochemical screening and antioxidative property evaluation of lipid-producing fungi.

The increased demands for natural bioactive compounds have induced the search for unusual sources. Microorganisms, especially fungi are a potent source of secondary metabolites, which could act mainly as antioxidant compounds to prevent oxidative stress. In the present study three soil-isolated fungi Aspergillus niger, Aspergillus heteromorphus and Aspergillus fumigatus, were screened for their oleaginous property as well as their potential for the production of bioactive compounds. Fungal biomasses were freeze dried and extracted with methanol using a cold percolation process for the production of intracellular metabolites and the fungal culture media after fermentation were examined for extracellular metabolites. Intracellular and extracellular extracts of the isolated fungi along with the single-cell oils extracted from those fungi were screened for phytochemicals, which showed the presence of alkaloids, flavonoides, glycosides, phenols, saponins and terpenoids. All strains showed potent antioxidant activity, determined using 1,1-diphenyl-2-picrylhydrazyl (DPPH), 2,2-azino-bis-3-ethylbenzthiazoline-6-sulfonic acid (ABTS) and ferric reducing antioxidant power (FRAP) activity. Extracellular extract and single-cell oil of A. heteromorphus showed the highest antioxidant activity with maximum ABTS radical scavenging activity and reducing potential. Highest content of phenolic and flavonoid compounds within the isolated fungi was found to be 37.58 mg gallic acid equivalent (GAE)/g and 62.07 mg catechine equivalent (CE)/g, respectively. Chromatographic analysis of the intracellular and extracellular extracts of the fungi showed the presence of gallic acid, di-hydroxy benzoic acid, ferulic acid, quercetin, epigerin, kampferol, trans cinnamic acid, chlorogenic acid and rutin, which made them biologically important and beneficial for human health.

Improvement of the degradation of sulfate rich wastewater using sweetmeat waste (SMW) as nutrient supplement.

External dosing of sweetmeat waste (SMW) dosing into exhausted upflow packed bed bioreactor (PBR) resulted in prompt reactivation of SO4(2-) removal. Different SMW concentrations in terms of chemical oxygen demand (COD)/SO4(2-) ratios (1, 2, 4 and 8) were introduced into four identical PBR where process stability was found within 3 weeks of operation. SO4(2-) removal was proportional to COD/SO4(2-) ratios up to 4 at which maximum sulfate removal (99%) was achieved at a rate of 607 mg/d. The value of COD consumption:SO4(2-)removal was much higher at ratio 4 than 8 whereas, ratio 2 was preferred over all. Net effluent acetate concentration profile and total microbial population attached to the reactor matrices were corresponding to COD/SO4(2-) ratio as 4>8>2>>1. Sulfate reducing bacteria (SRB) population was found to be inversely proportional to COD/SO4(2-) ratio in which acetate oxidizing SRB and fermentative bacteria were the dominant.

Improvement of power generation using Shewanella putrefaciens mediated bioanode in a single chambered microbial fuel cell: effect of different anodic operating conditions.

Three different approaches were employed to improve single chambered microbial fuel cell (sMFC) performance using Shewanella putrefaciens as biocatalyst. Taguchi design was used to identify the key process parameter (anolyte concentration, CaCl2 and initial anolyte pH) for maximization of volumetric power. Supplementation of CaCl2 was found most significant and maximum power density of 4.92 W/m(3) was achieved. In subsequent approaches, effect on power output by riboflavin supplementation to anolyte and anode surface modification using nano-hematite (Fe2O3) was observed. Volumetric power density was increased by 44% with addition of 100 nM riboflavin to anolyte while with 0.8 mg/cm(2) nano-Fe2O3 impregnated anode power density and columbic efficiency increased by 40% and 33% respectively. Cyclic voltammetry revealed improvement in electrochemical activity of Shewanella with nano-Fe2O3 loading and electrochemical impedance depicted inverse relationship between charge transfer resistance and nano-Fe2O3 loading. This study suggests anodic improvement strategies for maximization of power output.