Metabolic control analysis of developing oilseed rape (Brassica napus cv Westar) embryos shows that lipid assembly exerts significant control over oil accumulation.

Metabolic control analysis allows the study of metabolic regulation. We applied both single- and double-manipulation top-down control analysis to examine the control of lipid accumulation in developing oilseed rape (Brassica napus) embryos. The biosynthetic pathway was conceptually divided into two blocks of reactions (fatty acid biosynthesis (Block A), lipid assembly (Block B)) connected by a single system intermediate, the acyl-coenzyme A (acyl-CoA) pool. Single manipulation used exogenous oleate. Triclosan was used to inhibit specifically Block A, whereas diazepam selectively manipulated flux through Block B. Exogenous oleate inhibited the radiolabelling of fatty acids from [1-(14)C]acetate, but stimulated that from [U-14C]glycerol into acyl lipids. The calculation of group flux control coefficients showed that c. 70% of the metabolic control was in the lipid assembly block of reactions. Monte Carlo simulations gave an estimation of the error of the resulting group flux control coefficients as 0.27±0.06 for Block A and 0.73±0.06 for Block B. The two methods of control analysis gave very similar results and showed that Block B reactions were more important under our conditions. This contrasts notably with data from oil palm or olive fruit cultures and is important for efforts to increase oilseed rape lipid yields.

Components of complex lipid biosynthetic pathways in developing castor (Ricinus communis) seeds identified by MudPIT analysis of enriched endoplasmic reticulum.

Ricinoleic acid is a feedstock for nylon-11 (N11) synthesis which is currently obtained from castor (Ricinus communis) oil. Production of this fatty acid in a temperate oilseed crop is of great commercial interest, but the highest reported level in transgenic plant oils is 30%, below the 90% observed in castor and insufficient for commercial exploitation. To identify castor oil-biosynthetic enzymes and inform strategies to improve ricinoleic acid yields, we performed MudPIT analysis on endoplasmic reticulum (ER) purified from developing castor bean endosperm. Candidate enzymes for all steps of triacylglycerol synthesis were identified among 72 proteins in the data set related to complex-lipid metabolism. Previous reported proteomic data from oilseeds had not included any membrane-bound enzyme that might incorporate ricinoleic acid into oil. Analysis of enriched ER enabled determination of which protein isoforms for these enzymes were in developing castor seed. To complement this data, quantitative RT-PCR experiments with castor seed and leaf RNA were performed for orthologues of Arabidopsis oil-synthetic enzymes, determining which were highly expressed in the seed. These data provide important information for further manipulation of ricinoleic acid content in oilseeds and peptide data for future quantification strategies.

Substrate selectivity of plant and microbial lysophosphatidic acid acyltransferases.

Linoleic acid (18:2) is found in a large variety of plant oils but to date there is limited knowledge about the substrate selectivity of acyltransferases required for its incorporation into storage triacylglycerols. We have compared the incorporation of oleoyl (18:1) and linoleoyl (18:2) acyl-CoAs onto lysophosphatidic acid acceptors by sub-cellular fractions prepared from a variety of plant and microbial species. Our assays demonstrated: (1). All lysophosphatidic acid acyltransferase (LPA-AT) enzymes tested incorporated 18:2 acyl groups when presented with an equimolar mix of 18:1 and 18:2 acyl-CoA substrates. The ratio of 18:1 to 18:2 incorporation into phosphatidic acid varied between 0.4 and 1.4, indicating low selectivity between these substrates. (2). The presence of either stearoyl (18:0) or oleoyl (18:1) groups at the sn-1 position of lysophosphatidic acid did not affect the selectivity of incorporation of 18:1 or 18:2 into the sn-2 position of phosphatidic acid. (3). All LPA-AT enzymes tested incorporated the saturated palmitoyl (16:0) acyl group from equimolar mixtures of 16:0- and 18:1-CoA. The ratios of 18:1 to 16:0 incorporation are generally much higher than those of 18:1 to 18:2 incorporation, varying between 2.1 and 8.6. (4). The LPA-AT from oil palm kernel is an exception as 18:1 and 16:0 are utilised at comparable rates. These results show that, in the majority of species examined, there is no correlation between the final sn-2 composition of oil or membrane lipids and the ability of an LPA-AT to use 18:2 as a substrate in in vitro assays.

Squash glycerol-3-phosphate (1)-acyltransferase. Alteration of substrate selectivity and identification of arginine and lysine residues important in catalytic activity.

Glycerol-3-phosphate 1-acyltransferase is a soluble chloroplast enzyme involved in glycerol-lipid biosynthesis associated with chilling resistance in plants (). Resistance is associated with higher selectivity for unsaturated acyl substrates over saturated ones. In vitro substrate selectivity assays performed under physiologically relevant conditions have been established that discriminate between selective and non-selective forms of the enzyme. A mutation, L261F, in the squash protein converts it from a non-selective enzyme into a selective one. The mutation lies within 10 A of the predicted acyl binding site and results in a higher K(m) for 16:0 acyl carrier protein (ACP). Site-directed mutagenesis was used to determine the importance of four residues, Arg(235), Arg(237), Lys(193), and His(194), implicated to be involved in binding of the phosphate group of glycerol 3-phosphate to the enzyme. All the proteins were highly homologous in structure to the wild type enzyme. Mutations in Arg(235), Arg(237), and Lys(193) resulted in inactive enzyme, while His(194) had reduced catalytic activity. The mutant proteins retained the ability to bind stoichiometric quantities of acyl-ACPs supporting the potential role of these residues in glycerol 3-phosphate binding.