[Preparation and effectiveness evaluation of placebo of Jiawei Ermiao Granules].

This study explored the preparation process of the placebo of Jiawei Ermiao Granules and evaluated the placebo effect, aiming to provide qualified placebo samples for clinical trials of Jiawei Ermiao Granules and a reference for the preparation and quality evaluation of placebos of traditional Chinese medicine granules. On the basis of the comprehensive analysis results of Jiawei Ermiao Granules, the orthogonal experiment was conducted to optimize the flavoring agents and colorants. After manual evaluation, the placebo formula was determined as dextrin 10 g, Codonopsis Radix extract 5.0 g, bitter melon extract 1.6 g, Mume Fructus extract 0.3 g, stevioside 0.1 g, sucrose octaacetate 0.004 g, indigo 0.004 g, lemon yellow 0.003 1 g, sunset yellow 0.001 8 g, bitter tea powder 0.001 8 g, caramel 0.001 3 g. Pilot trials were conducted on the placebo formula. The simulation effect of placebo was evaluated independently and comparatively, and the objectively evaluated by electronic nose and electronic tongue. The results showed that the independent manual evaluation of the placebo formula had higher error rate, and the placebo and Jiawei Ermiao Granules showed the similarity of 99.61% in the comparative manual evaluation. The smell similarity between the placebo and Jiawei Ermiao Granules was 99.19%, and the electronic tongue test showed little difference in the taste. In conclusion, the placebo prepared in this study shows a high similarity to Jiawei Ermiao Granules, which is not easy to break the blindness when being applied to clinical trials. This study provides a reference for the preparation and quality evaluation and promotes the large-scale production of placebos of traditional Chinese medicine granules, playing a role in improving the persuasiveness and acceptance of the efficacy of traditional Chinese medicines.

Ultrasonic-assisted activated carbon separation removing bacterial endotoxin from salvia miltiorrhizae injection.

Ultrasonic-assisted activated carbon separation (UACS) was first employed to improve product quality by regulating adsorption rate and removing bacterial endotoxin from salvia miltiorrhizae injection. The adsorption rate was related to three variables: activated carbon dosage, ultrasonic power, and pH. With the increase of activated carbon dosage from 0.05 % to 1.0 %, the adsorption rates of salvianolic acids and bacterial endotoxin increased simultaneously. The adsorption rates at which bacteria endotoxins increased from 52.52 % to 97.16 % were much higher than salvianolic acids. As the ultrasonic power increased from 0 to 700 W, the adsorption rates of salvianolic acids on activated carbon declined to less than 10 %, but bacterial endotoxin increased to more than 87 %. As the pH increased from 2.00 to 8.00, the adsorption rate of salvianolic acid dropped whereas bacterial endotoxin remained relatively stable. On the basis of response surface methodology (RSM), the optimal separation conditions were established to be activated carbon dose of 0.70 %, ultrasonic power of 600 W, and pH of 7.90. The experimental adsorption rates of bacterial endotoxin were 94.15 %, which satisfied the salvia miltiorrhizae injection quality criterion. Meanwhile, salvianolic acids' adsorption rates were 1.92 % for tanshinol, 4.05 % for protocatechualdehyde, 2.21 % for rosmarinic acid, and 3.77 % for salvianolic acid B, all of which were much lower than conventional activated carbon adsorption (CACA). Salvianolic acids' adsorption mechanism on activated carbon is dependent on the component's molecular state. Under ideal separation conditions, the molecular states of the four salvianolic acids fall between 1.13 % and 6.60 %. The quality of salvia miltiorrhizae injection can be improved while maintaining injection safety by reducing the adsorption rates of salvianolic acids to less than 5 % by the use of ultrasound to accelerate the desorption mass transfer rate on the activated carbon surface. When activated carbon adsorption was used in the process of producing salvia miltiorrhizae injection, the pH of the solution was around 5.00, and the proportion of each component's molecular state was tanshinol 7.05 %, protocatechualdehyde 48.93 %, rosmarinic acid 13.79 %, and salvianolic acid B 10.28 %, respectively. The loss of useful components was evident, and the corresponding activated carbon adsorption rate ranged from 20.74 % to 41.05 %. The average variation rate in plasma His and IgE was significant (P < 0.05) following injection of 0.01 % activated carbon, however the average variation rate of salvia miltiorrhizae injection was dramatically decreased with the use of UACS and CACA (P > 0.05). The ultrasonic at a power intensity of 60 W/L and the power density of 1.20 W/cm2 may resolve the separation contradiction between salvianolic acids and bacterial endotoxin, according to experiments conducted with UACS at different power intensities. According to this study, UACS has a lot of potential applications in the pharmaceutical manufacturing industry and may represent a breakthrough in the field of ultrasonic separation.

[Determination of absolute configuration of a new triterpenic acid in leaves of Ilex hainanensis].

This study aimed to explore the triterpenic acid components in leaves of Ilex hainanensis. Alkaline water extraction, macroporous resin adsorption, and high performance liquid chromatography were used to separate and purify the triterpenic acid components in leaves of I. hainanensis. The physical and chemical property analysis, MS, NMR spectroscopy, and literature comparison were performed to identify the structures, and a new triterpene acid compound was discovered:(3S, 4R, 5R, 8R, 9R, 10R, 14S, 17S, 18S, 19R)-3,19-dihydroxyursa-12,20(30)-diene-24,28-dioic-acid, and named ilexhainanin F. In addition, according to its structural characteristics, the ~(19)F-NMR Mosher method was further employed to study its absolute configuration. By comparison of the ~(19)F-NMR chemical shifts of Mosher esters, it was determined that the absolute configuration of the 3-position chiral center of the compound was the S configuration.