Higher Fine Particle Fraction in Sediment Increased Phosphorus Flux to Estuary in Restored Yellow River Basin.

River delta-front estuaries (DEs) are vital interfaces for fluxes between terrestrial and marine environments. However, deep uncertainty exists in estimating the sedimentary pollutant flux from terrestrial environments in DEs due, in part, to a lack of direct measurements in these dynamic and complicated regions and uncertainty in the calculation method. Due to its high sediment content, the Yellow River (YR) has a strong ability to adsorb phosphorus; therefore, it reliably reflects estuarine sedimentary processes. Here, through the comprehensive analysis of field samples, monitoring data and remote sensing images, we conclude that riverine fine particles control the deltaic estuary pollution status and that particle size is the key factor. Based on the stable relationships between phosphorus and heavy metals, with r2 values of 0.990, 0.992, and 0.639 for As, Cd, and Cr, respectively, we estimated that the P flux reached 22.68 g/m2 yr in 2017. Analysis of the YR high-silt sediment load, which has a strong phosphorus adsorption ability and constitutes a substantial fraction of global fluvial sediment transport, revealed a negative correlation between the riverine sediment load and the estuarine phosphorus flux.

Using river sediments to analyze the driving force difference for non-point source pollution dynamics between two scales of watersheds.

The formation and transportation processes of non-point source (NPS) pollution varied among the studied watersheds in the Northeastern China, so we hypothesized that the driving force behind NPS pollution followed the spatial scale effect. With a watershed outlet sedimentary flux analysis and a distributed NPS pollution loading model, we investigated the temporal dynamics of NPS and the differences in driving forces. Sediment core samples were collected from two adjacent watersheds, the smaller Abujiao watershed and the larger Naoli watershed. The natural climatic conditions, long-term variations in the distribution of land use, soil properties and tillage practices were the same in the two watersheds. The vertical distributions of total nitrogen, total phosphorus, Zn and As at 1-cm intervals in the section showed clear differences between the watersheds. There were higher concentrations of total nitrogen and total phosphorus in the larger watershed, but the heavy metals were more concentrated in the smaller watershed. Lead-210 (210Pb) analyses and the constant rate of supply model provided a dated sedimentary flux, which was correlated with the corresponding yearly loading of NPS total nitrogen and total phosphorus in the two watersheds. The total phosphorus showed a stable relationship in both watersheds with an R2 value that ranged from 0.503 to 0.682. A rose figure comparison also demonstrated that the pollutant flux in the sediment was very different in the two watersheds, which had similar territorial conditions and different hydrological patterns. Redundancy analysis further indicated that expanding paddy areas had a large impact on the sedimentary flux of nitrogen and phosphorus in the smaller watershed, but precipitation had a direct impact on NPS loading in the larger watershed. We concluded that the spatial scale effect affected the NPS pollution via the transport processes in the waterway, which was mainly influenced by branch length and drainage density.

Does antifouling paint select for antibiotic resistance?

There is concern that heavy metals and biocides contribute to the development of antibiotic resistance via co-selection. Most antifouling paints contain high amounts of such substances, which risks turning painted ship hulls into highly mobile refuges and breeding grounds for antibiotic-resistant bacteria. The objectives of this study were to start investigate if heavy-metal based antifouling paints can pose a risk for co-selection of antibiotic-resistant bacteria and, if so, identify the underlying genetic basis. Plastic panels with one side painted with copper and zinc-containing antifouling paint were submerged in a Swedish marina and biofilms from both sides of the panels were harvested after 2.5-4weeks. DNA was isolated from the biofilms and subjected to metagenomic sequencing. Biofilm bacteria were cultured on marine agar supplemented with tetracycline, gentamicin, copper sulfate or zinc sulfate. Biofilm communities from painted surfaces displayed lower taxonomic diversity and enrichment of Gammaproteobacteria. Bacteria from these communities showed increased resistance to both heavy metals and tetracycline but not to gentamicin. Significantly higher abundance of metal and biocide resistance genes was observed, whereas mobile antibiotic resistance genes were not enriched in these communities. In contrast, we found an enrichment of chromosomal RND efflux system genes, including such with documented ability to confer decreased susceptibility to both antibiotics and biocides/heavy metals. This was paralleled by increased abundances of integron-associated integrase and ISCR transposase genes. The results show that the heavy metal-based antifouling paint exerts a strong selection pressure on marine bacterial communities and can co-select for certain antibiotic-resistant bacteria, likely by favoring species and strains carrying genes that provide cross-resistance. Although this does not indicate an immediate risk for promotion of mobile antibiotic resistance, the clear increase of genes involved in mobilizing DNA provides a foundation for increased opportunities for gene transfer in such communities, which might also involve yet unknown resistance mechanisms.

Screening of antimycotics in Swedish sewage treatment plants--waters and sludge.

Concentrations of six pharmaceutical antimycotics were determined in the sewage water, final effluent and sludge of five Swedish sewage treatment plants (STPs) by solid phase extraction, liquid/solid extraction, and liquid chromatography-electrospray tandem mass spectrometry. The antimycotics were quantified by internal standard calibration. The results were used to estimate national flows that were compared to predictions based on sales figures. Fluconazole was the only one of the six investigated antimycotics that was detected (at concentrations ranging from 90 to 140 ng L(-1)) in both raw sewage water and final effluent. Negligible amounts of this substance were removed from the aqueous phase, and its levels were below the limit of quantification in all of the analyzed sludge samples. In contrast, clotrimazole, ketoconazole and econazole were present in all of the sludge samples, at concentrations ranging between 200 and 1000 microg kg(-1), dry weight. There were close correlations between the national measured and predicted antimycotic mass flows. Antimycotic fate analysis, based on sales figures, indicated that 53% of the total amount of fluconazole sold appeared in the final effluents of the STPs, while 1, 155, 35, 209 and 41% of the terbinafine, clotrimazole, ketoconazole, econazole and miconazole sold appeared in the digested dewatered sludge.

Environmental risk assessment of antibiotics in the Swedish environment with emphasis on sewage treatment plants.

The potential risks associated with antibiotics present in the Swedish environment were assessed using concentrations found in hospital effluent, and sewage treatment waters and sludge, in combination with data on their environmental effects obtained from the literature. For the aqueous environment, measured environmental concentrations and effect/no observed effect concentration ratios were much lower than one in most cases. The only exceptions, where concentrations of the investigated substances were high enough to pose potential risks, were the concentrations of the two fluoroquinolones, ofloxacin and ciprofloxacin, in the hospital effluent. Treating digested dewatered sludge by heat did not fully eliminate norfloxacin or ciprofloxacin, thus pellets may still contain high amounts of these substances (sub to low mgkg(-1)dw). In leaching tests less than 1% of the amounts of these fluoroquinolones in the sludge or pellets reached the aqueous phase, indicating that their mobility is limited if sludge is used to fertilize soil.

Selection of a representative set of chemical accidents from a complex data matrix for the development of environment-accident index.

Chemical accidents often lead to negative consequences for the environment. Preparedness and proper actions are, therefore, essential components in order to minimise environmental effects. To assist and facilitate this work, a proposed planning tool, the environment-accident index (EAI), was formulated by Scott [J. Hazard. Mater. 61 (1998) 305]. As a result of a first validation of the index, based on 21 chemical accidents, the database was complemented with 42 additional accidents covering a broader spectrum of chemicals. The additional accidents were collected by means of an inquiry and their environmental consequences are, so far, unknown. The collected data had an overrepresentation of accidents involving petroleum products (69%). Because of the overrepresentation of this group of chemicals in the material, the data was skewed with respect to chemical properties. Since the model should be valid for a variety of chemical accidents, a method was needed which enabled a proper and unbiased selection of a representative subset of accidents to be used in development and validation of the model. For this purpose, the possibility to use multivariate data analysis in combination with statistical design was investigated. The result showed the feasibility of this method in the selection of a representative subset from a complex and skewed large dataset. Within the new dataset, 53% were accidents involving petroleum products and 47% involved other chemicals. The selected accidents will be used in further work to evaluate the environmental consequences, for model development and model validation.