Enhancement of oil forensic methodology through the addition of polycyclic aromatic nitrogen heterocycle biomarkers for diagnostic ratios.

Current oil spill forensic identification of source oils relies upon hydrocarbon biomarkers resistant to weathering. This international technique was developed by the European Committee for Standardization (CEN), under EN 15522-2 Oil Spill Identification guidelines. The number of biomarkers have expanded at pace with technological advances, while distinguishing new biomarkers becomes more challenging due to interference of isobaric compounds, matrix effects, and high cost of weathering experiments. Application of high-resolution mass spectrometry enabled exploration of potential polycyclic aromatic nitrogen heterocycle (PANH) oil biomarkers. The instrumentation showed reduction in isobaric and matrix interferences, allowing for identification of low-level PANH and alkylated PANHs (APANHs). Weathered oil samples, obtained from a marine microcosm weathering experiment, enabled comparison with source oils to identify new, stable forensic biomarkers. This study highlighted eight new APANH diagnostic ratios that expanded the biomarker suite, increasing the confidence for identifying highly weathered oils back to their source oil.

Advancement in oil forensics through the addition of polycyclic aromatic sulfur heterocycles as biomarkers in diagnostic ratios.

In current oil spill forensics, diagnostic ratios of hydrocarbon biomarker responses are commonly used to compare oil spill samples to source materials in order to determine the identity of the oil. This well recognized procedure was developed by the European Committee for Standardization (CEN) with corresponding published EN 15522-2 Oil Spill Identification guidelines. However, it is further recognized that weathering can have a negative effect on some of the biomarkers used in the analysis, leading to decreased confidence in the result. In this study, polycyclic aromatic sulfur heterocycles (PASHs) and their alkylated forms (APASHs) were assessed for their potential as additional biomarkers. With the aim of identifying stable PASHs and APASHs useful as weathered oil biomarkers, the superior specificity of gas chromatography with high resolution mass spectrometry was exploited to determine chromatographic peak responses for sixteen petroleum oil samples. Extensive study, involving microcosm extreme weathering and spreadsheet development, led to the identification of 19 new diagnostic ratios based on newly discovered stable PASH and APASH biomarkers. Application of the extended diagnostic ratio suite showed high potential to improve the forensic attribution of post-spill weathered oil back to its original source.

A rapid gas chromatography quadrupole time-of-flight mass spectrometry method for the determination of polycyclic aromatic hydrocarbons and sulfur heterocycles in spilled crude oils.

Spilled crude oil samples contain various toxic compounds including polycyclic aromatic hydrocarbons (PAHs) as well as sulfur heterocycles (PASHs) and their related alkylated forms (APAHs and APASHs). In this study, a method was successfully developed employing a gas chromatography quadrupole time-of-flight (GC-QToF) mass spectrometer to quantitatively analyze both PAHs/APAHs and PASHs/APASHs in these samples. With GC-QToF, the monoisotopic mass of the compounds is distinguished, allowing the PASHs/APASHs to be extracted separately from the PAHs/APAHs in crude oil. A gas chromatography triple quadrupole (GC-MS/MS) mass spectrometer was also used to confirm that a GC-QToF is the preferred instrument for analyzing these compounds. With the use of PASH/APASH standards to determine response correction factors (RCFs) in relation to PAH standards, the developed method is capable of analyzing PAHs, APAHs, PASHs, and APASHs in a single injection. The use of RCFs allowed for the development of a practical polycyclic aromatic carbon (PAC) method for analyzing a total of 77 compounds of the 2 groups in crude oil. This newly developed method was applied to spilled crude oils, demonstrating its potential in toxicological study as well as oil spill forensic investigation.

Enhanced analysis of weathered crude oils by gas chromatography-flame ionization detection, gas chromatography-mass spectrometry diagnostic ratios, and multivariate statistics.

Artificially weathered crude oil "spill" samples were matched to unweathered suspect "source" oils through a three-tiered approach as follows: Tier 1 gas chromatography-flame ionization detection (GC/FID), Tier 2 gas chromatography-mass spectrometry (GC/MS) diagnostic ratios, and Tier 3 multivariate statistics. This study served as proof of concept for a promising and new method of crude oil forensics that applies principal component analysis (PCA) and partial least squares discriminant analysis (PLSDA) in tandem with traditional forensic oil fingerprinting tools to confer additional confidence in challenging oil spill cases. In this study, weathering resulted in physical and chemical changes to the spilled oils, thereby decreasing the reliability of GC/FID and GC/MS diagnostic ratios in source attribution. The shortcomings of these traditional methods were overcome by applying multivariate statistical tools that enabled accurate characterization of the crude oil spill samples in an efficient and defensible manner.

Enhanced marine monitoring and toxicity study of oil spill dispersants including Corexit EC9500A in the presence of diluted bitumen.

Observations made for the analysis of the oil spill dispersant tracer dioctyl sulfosuccinate (DOSS) during LC50 toxicity testing, highlighted a stability issue for this tracer compound in seawater. A liquid chromatography high-resolution quadrupole time-of-flight mass spectrometry (LC/QToF) was used to confirm monooctyl sulfosuccinate (MOSS) as the only significant DOSS breakdown product, and not the related isomer, 4-(2-ethylhexyl) 2-sulfobutanedioate. Combined analysis of DOSS and MOSS was shown to be applicable to monitoring of spill dispersants Corexit® EC9500A, Finasol OSR52, Slickgone NS, and Slickgone EW. The unassisted conversion of DOSS to MOSS occurred in all four oil spill dispersants solubilized in seawater, although differences were noted in the rate of MOSS formation. A marine microcosm study of Corexit EC9500A, the formulation most rapid to form MOSS, provided further evidence of the stoichiometric conversion of DOSS to MOSS under conditions relevant to real world dilbit spill. Results supported combined DOSS and MOSS analysis for the monitoring of spill dispersant in a marine environment, with a significant extension of sample collection time by 10 days or longer in cooler conditions. Implications of the unassisted formation of MOSS and combined DOSS:MOSS analysis are discussed in relation to improving dispersant LC50 toxicity studies.