RESUMEN
Piperine is an alkaloid extracted from the seed of Piper spp., which has demonstrated a larvicidal effect against Ae. aegypti. The incorporation of piperine into nanostructured systems can increase the effectiveness of this natural product in the control of Ae. aegypti larvae. In this study, we evaluated the effectiveness of piperine loaded or not into two nanostructured systems (named NS-A and NS-B) prepared by the nanoprecipitation method. The Ae. aegypti larvae were exposed to different concentrations of piperine loaded or not (2 to 16 ppm) and the mortality was investigated after 24, 48, and 72 hours. The nanostructures prepared were spherical in shape with narrow size distribution and great encapsulation efficiency. The lethal concentration 50 (LC50) for non-loaded piperine were 13.015 ppm (24 hours), 8.098 ppm (48 hours), and 7.248 ppm (72 hours). The LC50 values found for NS-A were 35.378 ppm (24 hours), 12.091 ppm (48 hours), and 8.011 ppm (72 hours), whereas the values found for NS-B were 21.267 ppm (24 hours), 12.091 ppm (48 hours), and 8.011 ppm (72 hours). Collectively, these findings suggested that non-loaded piperine caused higher larval mortality in the first hours of exposure while the nanostructured systems promoted the slow release of piperine and thereby increased the larvicidal activity over time. Therefore, loading piperine into nanostructured systems might be an effective tool to improve the larval control of vector Ae. aegypti.
Asunto(s)
Aedes , Alcaloides , Insecticidas , Nanoestructuras , Alcaloides/farmacología , Animales , Benzodioxoles , Insecticidas/farmacología , Larva , Mosquitos Vectores , Piperidinas , Extractos Vegetales/química , Polímeros , Alcamidas PoliinsaturadasRESUMEN
Banana (Musa acuminata) pseudostem cellulose was extracted and acetylated (CA) to prepare membranes with potential use as bio-packages. The CA membrane was embedded by Butia seed (CA-BS) or Butia pulp (CA-BP) extracts obtained from Butia catarinenses (Butia). The produced CA, CA-BS, and CA-BP membranes were evaluated for their physical-chemical, mechanical, thermal, and antibacterial properties. The process for obtaining the cellulose yielded a material with about 92.17% cellulose (DS = 2.85). The purity, cellulose degree acetylation, and the incorporation of Butia extracts into the membranes were confirmed by FTIR. The CA-BS and CA-BP membranes showed a smaller contact angle and higher swelling ratio than the CA membrane. Furthermore, Butia seed or pulp extracts reduced the elastic modulus and deformation at break compared to the CA membrane. The DSC analysis suggested the compatibility between sections and the CA matrix, whereas the TGA analysis confirmed the thermal stability of the membranes. Moreover, less than 1% of the Butia seed and pulp extracts were put into a food simulant media from the membrane. Finally, the CA-BS and CA-BP membranes could inhibit the growth of Staphylococcus aureus and Escherichia coli on their surface, confirming the potential use of these membranes as bio-packaging for food preservation.
Asunto(s)
Celulosa/análogos & derivados , Musa/química , Extractos Vegetales/química , Tallos de la Planta/química , Antibacterianos/química , Antibacterianos/farmacología , Celulosa/química , Fenómenos Químicos , Fenómenos Mecánicos , Membranas Artificiales , Embalaje de Productos , Análisis EspectralRESUMEN
A smart wound dressing based on carrageenan (κC), locust bean gum (LBG), and cranberry extract (CB) for monitoring bacterial wound infections was developed and characterized using UV-vis spectroscopy, FT-IR, and SEM. The mechanical, swelling, cytotoxic and pH sensor properties were also investigated. UV-vis spectra demonstrated that the obtained κC:LBG:CB hydrogel film exhibited a visible change of colors as it was immersed in PBS solution pH 5.0, 7.3 and 9.0. The spectra of FT-IR suggested that chemical interactions had occurred between κC and CB extract. The obtained κC:LBG:CB hydrogel film exhibited adequate mechanical properties and a swelling behavior dependent on pH. Cytotoxicity tests indicated that κC:LBG:CB hydrogel film had dose-dependent cytotoxicity against NIH 3T3 fibroblast cells. The in vitro studies using Staphylococcus aureus and Pseudomonas aeruginosa demonstrated that the color changes of the κC:LBG:CB hydrogel film could be observed by naked eyes, confirming the potential use of the obtained hydrogel film as a visual system for monitoring bacterial wound infections.
Asunto(s)
Infecciones Bacterianas/diagnóstico , Vendajes , Hidrogeles/química , Indicadores y Reactivos/farmacología , Extractos Vegetales/farmacología , Infección de Heridas/diagnóstico , Animales , Antocianinas/química , Antocianinas/farmacología , Antocianinas/toxicidad , Antibacterianos/química , Antibacterianos/farmacología , Antibacterianos/toxicidad , Carragenina/química , Carragenina/toxicidad , Color , Módulo de Elasticidad , Galactanos/química , Galactanos/toxicidad , Hidrogeles/toxicidad , Concentración de Iones de Hidrógeno , Indicadores y Reactivos/química , Indicadores y Reactivos/toxicidad , Mananos/química , Mananos/toxicidad , Ratones , Células 3T3 NIH , Extractos Vegetales/química , Extractos Vegetales/toxicidad , Gomas de Plantas/química , Gomas de Plantas/toxicidad , Pseudomonas aeruginosa/efectos de los fármacos , Staphylococcus aureus/efectos de los fármacos , Resistencia a la Tracción , Vaccinium macrocarpon/químicaRESUMEN
INTRODUCTION:: The significant increase in dengue, Zika, and chikungunya and the resistance of the Aedes aegypti mosquito to major insecticides emphasize the importance of studying alternatives to control this vector. The aim of this study was to develop a controlled-release device containing Piper nigrum extract and to study its larvicidal activity against Aedes aegypti. METHODS:: Piper nigrum extract was produced by maceration, standardized in piperine, and incorporated into cotton threads, which were inserted into hydrogel cylinders manufactured by the extrusion of carrageenan and carob. The piperine content of the extract and thread reservoirs was quantified by chromatography. The release profile from the device was assessed in aqueous medium and the larvicidal and residual activities of the standardized extract as well as of the controlled-release device were examined in Aedes aegypti larvae. RESULTS: The standardized extract contained 580mg/g of piperine and an LC50 value of 5.35ppm (24h) and the 3 cm thread reservoirs contained 13.83 ± 1.81mg of piperine. The device showed zero-order release of piperine for 16 days. The P. nigrum extract (25ppm) showed maximum residual larvicidal activity for 10 days, decreasing progressively thereafter. The device had a residual larvicidal activity for up to 37 days. CONCLUSIONS:: The device provided controlled release of Piper nigrum extract with residual activity for 37 days. The device is easy to manufacture and may represent an effective alternative for the control of Aedes aegypti larvae in small water containers.
Asunto(s)
Aedes/efectos de los fármacos , Insectos Vectores/efectos de los fármacos , Insecticidas/administración & dosificación , Piper nigrum/química , Extractos Vegetales/administración & dosificación , Animales , Preparaciones de Acción Retardada , Dengue/transmisión , Sistemas de Liberación de Medicamentos , Insecticidas/aislamiento & purificación , Larva/efectos de los fármacos , Dosificación Letal MedianaRESUMEN
Abstract: INTRODUCTION: The significant increase in dengue, Zika, and chikungunya and the resistance of the Aedes aegypti mosquito to major insecticides emphasize the importance of studying alternatives to control this vector. The aim of this study was to develop a controlled-release device containing Piper nigrum extract and to study its larvicidal activity against Aedes aegypti. METHODS: Piper nigrum extract was produced by maceration, standardized in piperine, and incorporated into cotton threads, which were inserted into hydrogel cylinders manufactured by the extrusion of carrageenan and carob. The piperine content of the extract and thread reservoirs was quantified by chromatography. The release profile from the device was assessed in aqueous medium and the larvicidal and residual activities of the standardized extract as well as of the controlled-release device were examined in Aedes aegypti larvae. RESULTS The standardized extract contained 580mg/g of piperine and an LC50 value of 5.35ppm (24h) and the 3 cm thread reservoirs contained 13.83 ± 1.81mg of piperine. The device showed zero-order release of piperine for 16 days. The P. nigrum extract (25ppm) showed maximum residual larvicidal activity for 10 days, decreasing progressively thereafter. The device had a residual larvicidal activity for up to 37 days. CONCLUSIONS: The device provided controlled release of Piper nigrum extract with residual activity for 37 days. The device is easy to manufacture and may represent an effective alternative for the control of Aedes aegypti larvae in small water containers.
Asunto(s)
Animales , Extractos Vegetales/administración & dosificación , Aedes/efectos de los fármacos , Piper nigrum/química , Insectos Vectores/efectos de los fármacos , Insecticidas/administración & dosificación , Sistemas de Liberación de Medicamentos , Preparaciones de Acción Retardada , Dengue/transmisión , Insecticidas/aislamiento & purificación , Larva/efectos de los fármacos , Dosificación Letal MedianaRESUMEN
Studies have demonstrated the potential of Copaifera sp. oleoresin to control Aedes aegypti proliferation. However, the low water solubility is a factor that limits its applicability. Thus, the micro- or nanoencapsulation could be an alternative to allow its use in larval breeding places. The purpose of this study was to evaluate if achievable lethal concentrations could be obtained from Copaifera sp. oleoresin incorporated into polymers (synthetic or natural) and, mainly, if it can be sustained in the residual activity compared to the pure oil when tested against the A. aegypti larvae. Microcapsules were prepared by the process of emulsification/precipitation using the polymers of cellulose acetate (CA) and poly(ethylene-co-methyl acrylate) (PEMA), yielding four types of microcapsules: MicPEMA1 and MicPEMA2, and MicCA1 and MicCA2. When using only Copaifera sp. oleoresin, the larvicidal activity was observed at concentrations of LC50 = 48 mg/L and LC99 = 149 mg/L. For MicPEMA1, the LC50 and LC99 were 78 and 389 mg/L, respectively. Using MicPEMA2, the LC50 was 120 mg/L and LC99 > 500 mg/L. For microcapsules MicCA1 and MicCA2, the LC50 and LC99 were 42, 164, 140, and 398 mg/L, respectively. For a dose of 150 mg/L of pure oleoresin, the residual activity remained above 20% for 10 days, while the dose of 400 mg/L remained above 40% for 21 days. The MicPEMA1 microcapsules showed a loss in residual activity up to the first day; however, it remained in activity above 40% for 17 days. The microcapsules of MicCA1 showed similar LC50 of pure oil with 150 mg/L.
Asunto(s)
Aedes/efectos de los fármacos , Cápsulas/farmacología , Fabaceae/química , Insecticidas/farmacología , Extractos Vegetales/farmacología , Resinas Acrílicas , Aedes/crecimiento & desarrollo , Animales , Cápsulas/química , Insecticidas/química , Larva/efectos de los fármacos , Dosificación Letal Mediana , Extractos Vegetales/química , Polímeros/química , Polímeros/farmacologíaRESUMEN
The aim of this study was to investigate the mechanical properties of starch/glycerol/Melissa officinalis, a topical drug delivery system for labial herpes treatment. Four films were prepared with different concentrations of starch, glycerol, and Melissa officinalis extract. The results revealed that increasing the glycerol concentration in the film reduced elasticity modulus and tensile strength, exhibiting a plasticizing effect. The increase in free volume resulted in increased release of hydroxycinnamic derivatives expressed as rosmarinic acid.
O objetivo deste trabalho foi estudar as propriedades mecânicas e o mecanismo de liberação de um sistema tópico de liberação prolongada para o tratamento do Herpes labial a partir de filmes de amido/glicerol/extrato de Melissa officinalis, planta com comprovada atividade antiviral. Foram obtidos quatro filmes poliméricos com diferentes concentrações de amido, glicerol e extrato de Melissa officinalis os quais foram caracterizados mecanicamente e determinado o perfil de liberação de derivados hidroxicinâmicos. Os resultados demonstraram que o aumento da concentração de glicerol no filme produz uma redução no módulo de elasticidade e na tensão de deformação como conseqüência do efeito plastificante. O aumento no volume livre do polímero resultou em aumento da liberação dos derivados hidroxicinâmicos expressos como ácido rosmarínico.