Predictive Value of Quantitative Duplex Ultrasound Analysis for In-stent Carotid Artery Restenosis.

Context: In-stent restenosis (ISR) is a common clinical complication after carotid artery stenting (CAS) and a major risk for a stent's fatigue life. Duplex ultrasound (DUS) is widely used for the preliminary evaluation and follow-up of extracranial carotid artery disease, but DUS stenosis grading is mainly based on the original or nonsurgical carotid artery. That grading may not be applicable to carotid artery stenosis after CAS. Objective: The study intended to investigate the predictive value of quantitative analysis of results from the DUS examination in the evaluation of ISR following CAS. Design: The research team designed a control analysis of result samples. Setting: The study took place in the Ultrasound Department at the Affiliated Yantai Yuhuangding Hospital of Qingdao University in Yantai, Shandong, China. Participants: Participants were 103 patients who underwent carotid artery stenting (CAS) between March 2017 and April 2018 at the hospital. Outcome Measures: The study used Doppler DUS and digital subtraction angiography (DSA) of the carotid artery at 12 months postoperatively to analyze the consistency of DUS and DSA in the evaluation of ISR. Taking the results of the DSA examination as the standard, the research team analyzed the differences between those results and the indicators from the DUS examination for participants with different severities of stenosis. The research team plotted the receiver operating characteristic curve (ROC) and evaluated the diagnostic efficiency of DUS indicators in the determination of restenosis, including diagnostic accuracy, sensitivity, specificity, positive predictive value, and negative predictive value. Results: The DSA examination showed that stenosis severity was 0%-30% for 51 participants, 31%-50% for 27 participants, 51%-80% for 16 participants, and >80% for 9 participants. The DUS showed that stenosis severity was 0%-30% for 35 participants, 31%-50% for 38 participants, 51%-80% for 22 participants, and >80% for 8 participants. The consistency was found to be Kappa (ĸ) = 0.74. Taking the DSA as the standard, the peak systolic velocity (PSV), end diastolic velocity (EDV), peak systolic velocity of the internal carotid artery/peak systolic velocity of the common carotid artery (PSVICA/PSVCCA) significantly increased in participants with a stenosis severity of 51-80% and >80%, compared with those with a stenosis severity of <50%, and the difference was statistically significant (P < .05). The ROC curve showed that the area under curve (AUC) of the PSV predicting restenosis at a >50% severity was significantly higher than those of the EDV and PSVICA/PSVCCA (P < .05). Where the optimal cut-off-off point for the PSV was 195 cm/s, the ROC curve showed that the AUC of the PSV predicting restenosis at an >80% severity was significantly higher than that of the EDV and PSVICA/PSVCCA (P < .05). Where the optimal cut-off point for the PSV was 280 cm/s, the PSV had significantly higher diagnostic accuracy, sensitivity, and positive predictive value than the EDV and PSVICA/PSVCCA in evaluating the restenosis at a severity of >50% and >80%. Conclusions: Doppler DUS can effectively evaluate restenosis after carotid artery stenting (CAS), where a PSV ≥195 cm/s and 280 cm/s can be used as the reference indicators for >50% and >80% restenosis.

A versatile CeO2/Co3O4 coated mesh for food wastewater treatment: Simultaneous oil removal and UV catalysis of food additives.

Food waste water is one of the most urgent environmental problems for the close connection between food and our daily life. Herein, we use a simple hydrothermal method to prepare a highly efficient catalyst-CeO2/Co3O4 compound on the stainless steel mesh, aiming for food waste water treatment. Possessing the superhydrophilic property and catalytic ability under ultraviolet light, CeO2/Co3O4 coated mesh has successfully processed three representative contaminants in food wastewater, which are soybean oil (food oil), AR (food dye) and VA (food flavor) simultaneously with an one-step filtration. Besides, the mesh is stable in a wide pH range and performs well in reusability. Therefore, such a multifunctional material with simple preparation method, high processing efficiency and facile operation shows a promising prospect for practical production and application for food wastewater treatment.