Selected adjuvants increase the efficacy of foliar biofortification of iodine in bread wheat (Triticum aestivum L.) grain.

Agronomic biofortification of crops is a promising approach that can improve the nutritional value of staple foods by alleviating dietary micronutrient deficiencies. Iodine deficiency is prevalent in many countries, including Australia, but it is not clear what foliar application strategies will be effective for iodine fortification of grain. This study hypothesised that combining adjuvants with iodine in foliar sprays would improve iodine penetration in wheat, leading to more efficient biofortification of grains. The glasshouse experiment included a total of nine treatments, including three reference controls: 1) Water; 2) potassium iodate (KIO3) and 3) potassium chloride (KCl); and a series of six different non-ionic surfactant or oil-based adjuvants: 4) KIO3 + BS1000; 5) KIO3 + Pulse® Penetrant; 6) KIO3 + Uptake®; 7) KIO3 + Hot-Up®; 8) KIO3 + Hasten® and 9) KIO3 + Synerterol® Horti Oil. Wheat was treated at heading, and again during the early milk growth stage. Adding the organosilicon-based adjuvant (Pulse®) to the spray formulation resulted in a significant increase in grain loading of iodine to 1269 µg/kg compared to the non-adjuvant KIO3 control at 231µg/kg, and the water and KCl controls (both 51µg/kg). The second most effective adjuvant was Synerterol® Horti Oil, which increased grain iodine significantly to 450µg/kg. The Uptake®, BS1000, Hasten®, and Hot-Up® adjuvants did not affect grain iodine concentrations relative to the KIO3 control. Importantly, iodine application and the subsequent increase in grain iodine had no significant effects on biomass production and grain yield relative to the controls. These results indicate that adjuvants can play an important role in agronomic biofortification practices, and organosilicon-based products have a great potential to enhance foliar penetration resulting in a higher translocation rate of foliar-applied iodine to grains, which is required to increase the iodine density of staple grains effectively.

The distribution of metal and petroleum-derived contaminants within sediments around oil and gas infrastructure in the Gippsland Basin, Australia.

As oil and gas infrastructure comes to the end of its working life, a decommissioning decision must be made: should the infrastructure be abandoned in situ, repurposed, partially removed, or fully removed? Environmental contaminants around oil and gas infrastructure could influence these decisions because contaminants in sediments could degrade the value of the infrastructure as habitat, enter the seafood supply if the area is re-opened for commercial and/or recreational fishing, or be made biologically available as sediment is resuspended when the structures are moved. An initial risk hypothesis, however, may postulate that these concerns are only relevant if contaminant concentrations are above screening values that predict the possibility of environmental harm or contaminant bioaccumulation. To determine whether a substantive contaminants-based risk assessment is needed for infrastructure in the Gippsland Basin (South-eastern Australia), we measured the concentration of metals and polycyclic aromatic hydrocarbons (PAHs) in benthic sediments collected around eight platforms earmarked for decommissioning. The measurements were compared to preset screening values and to background contaminant concentrations in reference sites. Lead (Pb), zinc (Zn), PAHs and other contaminants were occasionally measured at concentrations that exceeded reference values, most often within 150 m of the platforms. The exceedance of a few screening values by contaminants at some platforms indicates that these platforms require further analysis to determine the contaminant risks associated with any decommissioning option.

Radiological risk assessment to marine biota from exposure to NORM from a decommissioned offshore oil and gas pipeline.

Scale residues can accumulate on the interior surfaces of subsea petroleum pipes and may incorporate naturally occurring radioactive materials (NORM). The persistent nature of 'NORM scale' may result in a radiological dose to the organisms living on or near intact pipelines. Following a scenario of in-situ decommissioning of a subsea pipeline, marine organisms occupying the exteriors or interiors of petroleum structures may have close contact with the scale or other NORM-associated contaminated substances and suffer subsequent radiological effects. This case study used radiological dose modelling software, including the ERICA Tool (v2.0), MicroShield® Pro and mathematical equations, to estimate the likely radiological doses and risks of effects from NORM-contaminated scale to marine biota from a decommissioned offshore oil and gas pipeline. Using activity concentrations of NORM (226Ra, 210Po, 210Pb, 228Ra, 228Th) from a subsea pipeline from Australia, environmental realistic exposure scenarios including radiological exposures from both an intact pipe (external only; accounting for radiation shielding by a cylindrical carbon steel pipe) and a decommissioned pipeline with corrosive breakthrough (resulting in both internal and external radiological exposure) were simulated to estimate doses to model marine organisms. Predicted dose rates for both the external only exposure (ranging from 26 µGy/h to 33 µGy/h) and a corroded pipeline (ranging from 300 µGy/h to 16,000 µGy/h) exceeded screening levels for radiological doses to environmental receptors. The study highlighted the importance of using scale-specific solubility data (i.e., Kd) values for individual NORM radionuclides for ERICA assessments. This study provides an approach for conducting marine organism dose assessments for NORM-contaminated subsea pipelines and highlights scientific gaps required to undertake risk assessments necessary to inform infrastructure decommissioning planning.

Synchrotron-Based Imaging Reveals the Fate of Selenium in Striped Marsh Frog Tadpoles.

Synchrotron-based X-ray fluorescence microscopy (XFM) coupled with X-ray absorption near-edge structure (XANES) imaging was used to study selenium (Se) biodistribution and speciation in Limnodynastes peronii tadpoles. Tadpoles were exposed to dissolved Se (30 µg/L) as selenite (SeIV) or selenate (SeVI) for 7 days followed by 3 days of depuration. High-resolution elemental maps revealed that Se partitioned primarily in the eyes (specifically the eye lens, iris, and retinal pigmented epithelium), digestive and excretory organs of SeIV-exposed tadpoles. Speciation analysis confirmed that the majority of accumulated Se was converted to organo-Se. Multielement analyses provided new information on Se colocalization and its impact on trace element homeostasis. New insights into the fate of Se on a whole organism scale contribute to our understanding of the mechanisms and risks associated with Se pollution.

Zinc Accumulates in the Nodes of Wheat Following the Foliar Application of 65Zn Oxide Nano- and Microparticles.

Using zinc (Zn) foliar fertilizers to enhance the grain quality of wheat (Triticum aestivum) can be an effective alternative or supplement to Zn soil fertilizers. However, knowledge about the mechanisms of Zn absorption and translocation following foliar application is scarce. Here, autoradiography and γ-spectrometry were used to investigate the behavior of 65Zn applied to wheat leaves as soluble 65Zn chloride (65ZnCl2), chelated 65Zn (65ZnEDTA), 65Zn oxide nanoparticle (65ZnO-NP) suspensions, and 65ZnO microparticle (65ZnO-MP) suspensions. The largest amount of 65Zn absorption occurred in 65ZnCl2 treated leaves. However, this treatment (65ZnCl2) also had the lowest proportion of absorbed 65Zn translocated away from the treated leaf after 15 d due to leaf scorching (p = 0.0007). Foliar-applied 65ZnO-NPs and 65ZnO-MPs had the lowest absorption, but 65ZnO-NPs had the highest relative translocation. 65Zinc EDTA was intermediate, with higher 65Zn absorption than 65ZnO treatments but similar translocation. Regardless, the majority of the foliar-applied 65Zn remained in the treated leaf for all treatments. Furthermore, 65ZnO-NPs and 65ZnO-MPs accumulated in plant nodes, suggesting that Zn was absorbed as dissolved 65Zn and particulate 65ZnO. Overall, the form and amount of absorbed 65Zn affected translocation.

Uptake and tissue distributions of cadmium, selenium and zinc in striped marsh frog tadpoles exposed during early post-embryonic development.

Metals and metalloids released through anthropogenic activities can accumulate in aquatic organisms, resulting in adverse effects in sensitive species. We investigated the influence of feeding regime and exposure complexity (i.e., mixture) on bioaccumulation kinetics and body distribution of common metal(loid) pollutants in Limnodynastes peronii during early post-embryonic development. Tadpoles were exposed to radiolabelled 109Cd, 75Se and 65Zn alone and in a mixture for 4 days, followed by 3 days depuration in clean water. One group was fed directly in exposure aquaria, whereas a second group was transferred to clean water for feeding, to investigate the potential influence of sorption to food on uptake. Bioconcentration factor and retention was observed to be greatest for Se. Results demonstrate that tadpoles accumulated and retained half the amount of Cd when exposed in mixture, suggesting that Se and/or Zn may have antagonistic effects against Cd uptake. Additionally, tadpoles fed directly in exposure water accumulated 2-3-times more Cd and Zn compared to tadpoles fed in clean water, indicating that the presence of food particles is an important factor that may influence uptake. Interestingly, this had a negligible impact on Se uptake. The study reveals how exposure conditions can influence the bioaccumulation of metal(loid)s, highlighting experimental factors as important considerations for both controlled toxicity experiments and for understanding exposure risks for amphibian populations.

Bioaccumulation and Biodistribution of Selenium in Metamorphosing Tadpoles.

Selenium is an important macronutrient with a very narrow margin between essentiality and toxicity. Amphibians are hypothesized to be particularly sensitive due to the potential for metamorphosis-driven mobilization, which could transfer or concentrate contaminant burdens within specific organs. We explored the potential role of tissue degeneration and remodeling during anuran metamorphosis as a mechanism for altering tissue-specific Se burdens. Limnodynastes peronii tadpoles were exposed to dissolved 75Se (as selenite) for 7 days and depurated until completion of metamorphosis. Bioaccumulation and retention kinetics were assessed in whole tadpoles and excised tissues using gamma spectroscopy, and temporal changes in biodistribution were assessed using autoradiography. Tadpoles retained Se throughout metamorphosis, and partitioned the element predominantly within digestive and excretory tissues, including livers > mesonephros > guts > gallbladder. Importantly, our results demonstrate that Se biodistribution varies significantly throughout development. This is indicative of tissue transference, and particularly in tissues developing de novo after depuration. To the best of our knowledge, this is the first study demonstrating Se transference during metamorphic tissue remodelling. Further research is warranted to explore the fate and metabolism of Se (and other metal and metalloids) during anuran development and the implications of transference for influencing toxicity.

Phosphorus Fate and Dynamics in Greywater Biofiltration Systems.

Phosphorus, a critical environmental pollutant, is effectively removed from stormwater by biofiltration systems, mainly via sedimentation and straining. However, the fate of dissolved inflow phosphorus concentrations in these systems is unknown. Given the growing interest in using biofiltration systems to treat other polluted waters, for example greywater, such an understanding is imperative to optimize designs for successful long-term performance. A mass balance method and a radiotracer, 32P (as H3PO4), were used to investigate the partitioning of phosphorus (concentrations of 2.5-3.5 mg/L, >80% was in dissolved inorganic form) between the various biofilter components at the laboratory scale. Planted columns maintained a phosphorus removal efficiency of >95% over the 15-week study period. Plant storage was found to be the dominant phosphorus sink (64% on average). Approximately 60% of the phosphorus retained in the filter media was recovered in the top 0-6 cm. The 32P tracer results indicate that adsorption is the immediate primary fate of dissolved phosphorus in the system (up to 57% of input P). Plant assimilation occurs at other times, potentially liberating sorption sites for processing of subsequent incoming phosphorus. Plants with high nutrient uptake capacities and the ability to efficiently extract soil phosphorus, for example Carex appressa, are, thus, recommended for use in greywater biofilters.