A phenylalanine in DGAT is a key determinant of oil content and composition in maize.

Plant oil is an important renewable resource for biodiesel production and for dietary consumption by humans and livestock. Through genetic mapping of the oil trait in plants, studies have reported multiple quantitative trait loci (QTLs) with small effects, but the molecular basis of oil QTLs remains largely unknown. Here we show that a high-oil QTL (qHO6) affecting maize seed oil and oleic-acid contents encodes an acyl-CoA:diacylglycerol acyltransferase (DGAT1-2), which catalyzes the final step of oil synthesis. We further show that a phenylalanine insertion in DGAT1-2 at position 469 (F469) is responsible for the increased oil and oleic-acid contents. The DGAT1-2 allele with F469 is ancestral, whereas the allele without F469 is a more recent mutant selected by domestication or breeding. Ectopic expression of the high-oil DGAT1-2 allele increases oil and oleic-acid contents by up to 41% and 107%, respectively. This work provides insights into the molecular basis of natural variation of oil and oleic-acid contents in plants and highlights DGAT as a promising target for increasing oil and oleic-acid contents in other crops.

Phonomyography and mechanomyography can be used interchangeably to measure neuromuscular block at the adductor pollicis muscle.

UNLABELLED: The standard of neuromuscular monitoring is the measurement of the force of contraction (mechanomyography, MMG). Phonomyography (PMG) consists of recording low-frequency sounds created during muscle contraction. In this study, we compared and used both methods to determine neuromuscular blockade (NMB) at the adductor pollicis muscle. In 14 patients, PMG was recorded via a small condenser microphone taped to the thenar mass, and a standard mechanomyographic device was applied to the same arm. In another group of 14 patients, only PMG was measured. After induction of anesthesia, the ulnar nerve was stimulated supramaximally using single twitch stimulation (0.1 Hz) for onset and train-of-four (TOF) stimulation every 12 s during offset of NMB produced by mivacurium 0.1 mg/kg. Onset and recovery indices measured by the 2 methods were compared using Student's t-test (P < 0.05). Similar comparisons were made between the two PMG groups (with or without special board). Agreement between PMG and MMG was examined using a Bland-Altman test. Onset was 165 (68) s versus 172 (67) s [mean (SD)], and maximum blockade was 89 (10)% versus 90 (11)%, for PMG and MMG respectively (NS). Time to 25%, 75%, and 90% recovery was 16.5 (4.2) min, 22.1 (6.9) min, and 24.5 (8.2) min, respectively for PMG, not different from 16.7 (4) min, 22.8 (8.1) min, and 24.8 (8.8) min for MMG. Mean bias was 0% with limits of agreement of -10 and + 10% of twitch height for all signals (MMG minus PMG). Time to TOF of 0.5, 0.7, 0.8, and 0.9, was 1 min faster with PMG than with MMG, with limits of agreement of -1.5 to 3.5 min. Pharmacodynamic data derived without or with special arm fixation were not significantly different. MMG and PMG can be used interchangeably to determine NMB at the adductor pollicis muscle. PMG is easier to apply, does not need a special monitoring board and could be a reliable monitor to determine NMB in daily routine. IMPLICATIONS: Mechanomyography and phonomyography (PMG), a novel method of monitoring neuromuscular blockade (NMB) by recording low-frequency sounds emitted by muscle contraction, can be used interchangeably to determine NMB at the adductor pollicis muscle. PMG is easier to apply, does not need a special monitoring board and could be a reliable monitor to determine NMB in daily routine.