RESUMO
BACKGROUND: Preclinical evaluation of new chemical entities (NCEs) designed to be administered by inhalation route requires lung administration to rodents, especially in the discovery phase. Different administration methods have been used until now, but more efforts are required to obtain controlled and reproducible lung deposition when only small amounts of neat powder material are available. METHODS: The PreciseInhale platform used in the present study enables well-controlled powder aerosol exposures with only small amounts of micronized neat material, providing data on inhalation pharmacokinetic (PK) of NCEs at a very early stage. The DustGun aerosol technology uses compressed air to generate a respirable aerosol from milligram-amounts of powder that is delivered to one animal at a time. The new methodology was used to investigate the inhalation PK and lung retention in the rat of the novel Chiesi PDE4 inhibitor CHF6001 in three exposure models of the PreciseInhale platform: nose-only, intratracheally intubated rat, and the isolated, ventilated, and perfused rat lung. Results were compared with data from two other pulmonary delivery systems commonly used in preclinical studies: liquid instillation and powder insufflation. RESULTS: Administration of micronized CHF6001 using the PreciseInhale system yielded lung exposures in the same range as the other tested devices, but the reproducibility in lung deposition was improved. The initial amount of CHF6001 in lungs at the first sampling time point was close to the predetermined target dose. Tracheal deposition with PreciseInhale (0.36 ± 0.22 µg) was significantly less than with other tested delivery systems: PennCentury (23.7 ± 3.2 µg) and Airjet (25.6 ± 7.2 µg). CONCLUSIONS: The PreciseInhale platform enabled the administration of CHF6001 powder with good accuracy and reproducibility, with low tracheal deposition. The new platform can be used at an early discovery stage to obtain inhalatory PK data for respirable aerosols of neat NCE powder without excipients and with minimal use of dry powder formulation work.
Assuntos
Sistemas de Liberação de Medicamentos , Pulmão/metabolismo , Inibidores da Fosfodiesterase 4/farmacocinética , Sulfonamidas/farmacocinética , para-Aminobenzoatos/farmacocinética , Administração por Inalação , Aerossóis , Animais , Avaliação Pré-Clínica de Medicamentos/métodos , Feminino , Masculino , Modelos Biológicos , Inibidores da Fosfodiesterase 4/administração & dosagem , Pós , Ratos , Ratos Sprague-Dawley , Reprodutibilidade dos Testes , Sulfonamidas/administração & dosagem , Tecnologia Farmacêutica/métodos , Distribuição Tecidual , Traqueia/metabolismo , para-Aminobenzoatos/administração & dosagemRESUMO
BACKGROUND: Our aim was to investigate the potential of the DustGun aerosol technology integrated with the isolated, perfused, and ventilated lung of the rat (IPL) to study the pulmonary disposition of an inhaled model biopharmaceutical, the 40-kDa protein horseradish peroxidase (HRP). METHOD: The DustGun aerosol technology was used to deliver respirable powder aerosols of HRP (the mass median aerodynamic diameter: 1.7 µm) as an 80-sec bolus to the IPL perfused in a single-pass mode. Lung perfusate was repeatedly sampled for 125 min after the HRP exposure. The amount of active HRP clearing with the perfusate or being retained in the lung was measured enzymatically. RESULTS AND CONCLUSIONS: The total amount of HRP deposited in the lungs was 335 ± 100 µg and 568 ± 47 µg for a low- and high-dose exposure, respectively. After inhalation, the initial appearance of HRP in the perfusate was rapid. However, the total amount of HRP that cleared with the perfusate remained below 0.5% of the deposited dose. The effect of opening the tight junctions between the alveolar epithelial cells on HRP absorption was studied by exposing the IPL to nebulized aerosols of either 0.02, 0.2, or 2% poly-L-Arginine (PLA) (MW 42.5 kDa) in phosphate-buffered saline (PBS) for 5 min, at 40 min after the HRP exposure. Subsequent exposure to 0.02% PLA did not affect HRP absorption. However, exposure to 0.2% PLA increased the absorption rate ninefold, and the total amount of HRP clearing with the perfusate increased to approximately 4% of the deposited dose. No further increase was obtained with 2% PLA, indicating a steep dose-response for the enhancer. It was concluded that the pulmonary absorption of HRP is quite slow, and absorption enhancers affecting tight junctions have a distinctive, yet limited efficiency. The presented inhalation technology can be very useful in studying the pulmonary absorption of biopharmaceuticals.