Sequential removal of selenate, nitrate and sulfate and recovery of elemental selenium in a multi-stage bioreactor process with redox potential feedback control.

Bioreduction can facilitate oxyanions removal from wastewater. However, simultaneously removing selenate, nitrate and sulfate and recovering high-purity elemental selenium (Se0) from wastewater by a single system is difficult and may lead to carcinogenic selenium monosulfide (SeS) formation. To solve this issue, a two-stage biological fluidized bed (FBR) process with ethanol dosing based on oxidation-reduction potential (ORP) feedback control was developed in this study. FBR1 performance was first evaluated at various ORP setpoints (between -520 and -360 mV vs. Ag/AgCl) and elevated sulfate concentration. Subsequently, ethanol-fed FBR2 was used to reduce sulfate from FBR1 effluent, followed by an aerated sulfide oxidation reactor (SOR). At - 520 mV≤ ORPs≤ -480 mV, FBR1 removed 100 ±â€¯0.1% nitrate and 99.7 ±â€¯0.3% selenate without sulfate reduction. At ORPs ≥ -440 mV, selenate reduction was incomplete, whereas nitrate removal remained stable. Se0 recovery efficiency from FBR1 effluent was 37.5% with 71% Se purity. FBR2 converted 86% of the remaining sulfate in FBR1 effluent to hydrogen sulfide, but the over-oxidation of dissolved sulfide in SOR decreased the overall sulfate removal efficiency to ~46.3%. Overall, the two-stage FBR process with ORP feedback dosing of ethanol was effective for sequentially removing selenate, nitrate and sulfate and recovering Se0 from wastewater.

Long-term performance of a full-scale intermittently decanted extended aeration (IDEA) plant: The effect of dissolved oxygen and the relocation of alum dosing to bioselector.

Dosing alum to remove phosphorus (P) from wastewater is a common practice. However, the dosing-location and quantity of alum required to meet P discharge limits are vaguely defined. As such, utilities overdose alum to avoid noncompliance, but this leads to wastage and costs. This study aimed to address this issue through a long-term evaluation of an alum-assisted full-scale intermittently decanted extended aeration (IDEA) plant. Specifically, the effects of relocating alum dosing from a low P containing IDEA-tank to a bioselector containing elevated P concentrations were examined. The plant is fitted with two IDEA-tanks, each retrofitted with a bioselector at the inlet end. Over 359 d, key parameters (dissolved oxygen (DO), NH4+-N, NO2--N, NO3--N, PO43--P) were quantified to account for the effects of switching alum-dosing into the bioselector and varying dosages (429, 643, 1072 and 1286 g-Al3+ per treatment cycle). Results indicated a 52% reduction of alum usage with no impact on discharge limit (≤0.85 mg-P/L). As expected, a failure to maintain DO setpoint (1.6 mg/L) reduced both NH4+-N and PO43--P removal. Increasing alum dosage simply could not alleviate this problem, but maintenance of DO at least 85% of setpoint enabled effective rectification. This 15% DO buffer zone offers operators an opportunity to rectify imminent operational failures related to DO, prior to escalating alum dosage. An operational framework to manage DO related failures is proposed. Overall, this study offers insights on how to cost effectively apply alum and manage DO failures to achieve P discharge limits in IDEA plants.

Simultaneous nitrification, denitrification and phosphorus recovery (SNDPr) - An opportunity to facilitate full-scale recovery of phosphorus from municipal wastewater.

Sewage treatment plants are a potential point source for recycling of phosphorus (P). Several technologies have been proposed to biologically recover P from wastewater. The majority of these technologies are side-stream processes and rely on an external source of soluble organic carbon to facilitate P recovery. To date, no studies have demonstrated the potential to facilitate main-stream recovery of P, using carbon that is naturally present in wastewater. Simultaneous nitrification, denitrification and phosphorus removal (SNDPR) is an elegant process that can uptake influent carbon and effectively remove both nitrogen (N) and P from wastewater. SNDPR studies to date, however, have failed to facilitate an end-of-anaerobic-phase P rich liquor, that enables economies of scale to recover influent P. Therefore, this study examined the feasibility of achieving a P rich liquor (e.g. > 70 mg-P/L) in a granular SNDPR process. A synthetic influent that replicated the nutrient and carbon concentrations of municipal wastewater was used to investigate whether carbon in the influent wastewater could enable both nutrient removal and P recovery from wastewater. Our granular SNDPR process was able to facilitate an end-of-anaerobic-phase liquor with P enriched to approximately 100 mg-P/L. A dissolved oxygen (DO) concentration of 0.5 mg/L in a sequencing batch reactor (SBR) was found to be essential to achieve complete nutrient removal and a high P concentration at the end of the anaerobic phase. At this steady state of reactor operation, the abundance of polyphosphate accumulating organisms (PAOs) was 2.6 times the abundance of glycogen accumulating organisms (GAOs). The study also demonstrated the importance of denitrifying polyphosphate accumulating organisms (DPAOs) and glycogen accumulating organisms (DGAOs) to achieve complete removal of N from the effluent. Compared to nitrifying bacteria, the polyphosphate accumulating organisms (PAOs) had a higher affinity towards DO. This study, for the first time, showed that the mainstream recovery of P is feasible using a SNDPR process.

Improvement of carbon usage for phosphorus recovery in EBPR-r and the shift in microbial community.

Enhanced biological phosphorus removal and recovery (EBPR-r) is a biofilm process that makes use of polyphosphate accumulating organisms (PAOs) to remove and recover phosphorus (P) from wastewater. The original process was inefficient, as indicated by the low P-release to carbon (C)-uptake (Prel/Cupt) molar ratio of the biofilm. This study successfully validated a strategy to improve the Prel/Cupt ratio by at least 3-fold. With an unchanged supply of carbon in the recovery stream, an increase in the hydraulic loading in stages I, II and III (7.2, 14.4 and 21.6 L, respectively) resulted in a 43% increase in the Prel/Cupt ratio (0.069, 0.076 and 0.103, respectively). The ratio further increased by 150% (from 0.103 to 0.255) when the duration of the P uptake period was increased from 4 h (stage III) to 10 h (stage IV). Canonical correspondence analysis showed that, correlated to the 3-fold increase in the Prel/Cupt ratio, there was an increase in the abundance of PAOs ("Candidatus Accumulibacter" Clade IIA) and a decrease in the occurrence of glycogen accumulating organisms (GAOs) (family Sinobacteraceae). However, the four stage operation impaired denitrification, resulting in a 5-fold reduction in the Nden/Pupt ratio. The decline in denitrification was consistent with a decrease in the abundance of denitrifiers including denitrifying PAOs (family Comamonadaceae and "Candidatus Accumulibacter" Clade IA). Overall, a strategy to facilitate more efficient use of carbon was validated, enabling a 3-fold carbon saving for P recovery. The new process enabled up to 80% of the wastewater P to be captured in a P-enriched stream (>90 mg/L) with a single uptake/release cycle of recovery.

Simultaneous phosphorus uptake and denitrification by EBPR-r biofilm under aerobic conditions: effect of dissolved oxygen.

A biofilm process, termed enhanced biological phosphorus removal and recovery (EBPR-r), was recently developed as a post-denitrification approach to facilitate phosphorus (P) recovery from wastewater. Although simultaneous P uptake and denitrification was achieved despite substantial intrusion of dissolved oxygen (DO >6 mg/L), to what extent DO affects the process was unclear. Hence, in this study a series of batch experiments was conducted to assess the activity of the biofilm under various DO concentrations. The biofilm was first allowed to store acetate (as internal storage) under anaerobic conditions, and was then subjected to various conditions for P uptake (DO: 0-8 mg/L; nitrate: 10 mg-N/L; phosphate: 8 mg-P/L). The results suggest that even at a saturating DO concentration (8 mg/L), the biofilm could take up P and denitrify efficiently (0.70 mmol e(-)/g total solids*h). However, such aerobic denitrification activity was reduced when the biofilm structure was physically disturbed, suggesting that this phenomenon was a consequence of the presence of oxygen gradient across the biofilm. We conclude that when a biofilm system is used, EBPR-r can be effectively operated as a post-denitrification process, even when oxygen intrusion occurs.

A novel post denitrification configuration for phosphorus recovery using polyphosphate accumulating organisms.

Enhanced biological phosphorus removal (EBPR) has been widely used to remove phosphorus (P) from wastewater. In this study we report a novel modification to the EBPR approach, namely enhanced biological phosphorus removal and recovery (EBPR-r) that facilitates biological recovery of P from wastewater using a post denitrification configuration. The novel approach consists of two major steps. In the first step, a biofilm of phosphorus accumulating organisms (PAOs) is exposed to a wastewater stream in the absence of active aeration, during which P is taken up by the biofilm using nitrate and residual dissolved oxygen as electron acceptors. Thus, P and nitrogen (N) removal from wastewater is achieved. During the second step, the P enriched biofilm is exposed to a smaller recovery stream supplemented with an external carbon source to facilitate P release under anaerobic conditions. This allows P to be recovered as a concentrated liquid. The EBPR-r process was able to generate a P recovery stream four time more concentrated (28 mg-P/L) than the wastewater stream (7 mg-P/L), while removing nitrate (denitrification) from the wastewater stream. Repeated exposure of the biofilm (10 P-uptake and release cycles) to a recovery stream yielded up to 100 mg-P/L. Overall, EBPR-r is the first post denitrification strategy that can also facilitate P recovery during secondary wastewater treatment.

Biological phosphorus and nitrogen removal in sequencing batch reactors: effects of cycle length, dissolved oxygen concentration and influent particulate matter.

Removal of phosphorus (P) and nitrogen (N) from municipal wastewaters is required to mitigate eutrophication of receiving water bodies. While most treatment plants achieve good N removal using influent carbon (C), the use of influent C to facilitate enhanced biological phosphorus removal (EBPR) is poorly explored. A number of operational parameters can facilitate optimum use of influent C and this study investigated the effects of cycle length, dissolved oxygen (DO) concentration during aerobic period and influent solids on biological P and N removal in sequencing batch reactors (SRBs) using municipal wastewaters. Increasing cycle length from 3 to 6 h increased P removal efficiency, which was attributed to larger portion of N being removed via nitrite pathway and more biodegradable organic C becoming available for EBPR. Further increasing cycle length from 6 to 8 h decreased P removal efficiencies as the demand for biodegradable organic C for denitrification increased as a result of complete nitrification. Decreasing DO concentration in the aerobic period from 2 to 0.8 mg L(-1) increased P removal efficiency but decreased nitrification rates possibly due to oxygen limitation. Further, sedimented wastewater was proved to be a better influent stream than non-sedimented wastewater possibility due to the detrimental effect of particulate matter on biological nutrient removal.

Microbial community changes with decaying chloramine residuals in a lab-scale system.

When chloramine is used as a disinfectant, managing an acceptable "residual" throughout the water distribution systems particularly once nitrification has set in is challenging. Managing chloramine decay prior to the onset of nitrification through effective control strategies is important and to-date the strategies developed around nitrification has been ineffective. This study aimed at developing a more holistic knowledge on how decaying chloramine and nitrification metabolites impact microbial communities in chloraminated systems. Five lab-scale reactors (connected in series) were operated to simulate a full-scale chloraminated distribution system. Culture independent techniques (cloning and qPCR) were used to characterise and quantify the mixed microbial communities in reactors maintaining a residual of high to low (2.18-0.03 mg/L). The study for the first time associates chloramine residuals and nitrification metabolites to different microbial communities. Bacterial classes Solibacteres, Nitrospira, Sphingobacteria and Betaproteobacteria dominated at low chloramine residuals whereas Actinobacteria and Gammaproteobacteria dominated at higher chloramine residuals. Prior to the onset of nitrification bacterial genera Pseudomonas, Methylobacterium and Sphingomonas were found to be dominant and Sphingomonas in particular increased with the onset of nitrification. Nitrosomonas urea, oligotropha, and two other novel ammonia-oxidizing bacteria were detected once the chloramine residuals had dropped below 0.65 mg/L. Additionally nitrification alone failed to explain chloramine decay rates observed in these reactors. The finding of this study is expected to re-direct the focus from nitrifiers to heterotrophic bacteria, which the authors believe could hold the key towards developing a control strategy that would enable better management of chloramine residuals.