Adsorption of polar and nonpolar compounds onto complex nanooxides with silica, alumina, and titania.

Adsorption of low-molecular adsorbates (nonpolar hexane, nitrogen, weakly polar acetonitrile, and polar diethylamine, triethylamine, and water) onto individual (silica, alumina, titania), binary (silica/alumina (SA), silica/titania (ST)), and ternary (alumina/silica/titania, AST) fumed oxides was studied to analyse the effects of morphology and surface composition of the materials. Certain aspects of the interfacial phenomena dependent on the structural characteristics of oxides were analysed using calorimetry, (1)H NMR, and Raman spectroscopies, XRD, and ab initio quantum-chemical calculations. The specific surface area S(BET,X)-to-S(BET,N(2)) ratio (X is an organic adsorbate) changes from 0.68 for hexane adsorbed onto amorphous SA8 (degassed at 200 degrees C) to 1.85 for acetonitrile adsorbed onto crystalline alumina (degassed at 900 degrees C). These changes are relatively large because of variations in orientation, lateral interactions, and adsorption compressing of molecules adsorbed onto oxide surfaces. Larger S(BET,X)/S(BET,N(2)) values are observed for mixed oxides with higher crystallinity of titania or/and alumina phases in larger primary nanoparticles with greater surface roughness and hydrophilicity. Polar adsorbates can change the structure of aggregates of oxide nanoparticles that can, in turn, affect the results of adsorption measurements.

Well-defined oxide core-polymer shell nanoparticles: interfacial interactions, peculiar dynamics, and transitions in polymer nanolayers.

Interfacial interactions, chain dynamics, and glass and melting transitions were studied in well-defined core-shell nanoparticles with amorphous silica or crystalline alumina cores and noncrystallizable poly(vinyl pyrrolidone) (PVP) or crystallizable poly(ethylene glycol) (PEG) shells. Varying particle composition caused regular changes in the shell thickness from 1 to 2 nm (monomolecular layer) up to 90 nm. Far- and mid-IR spectroscopy allowed us to register hydrogen bonding and, tentatively, Lewis/Brønsted (LB) interfacial interactions as well as changes in the dynamics and conformational state of the polymer chains as a function of the nanoshell thickness. Their most pronounced peculiarities were found for the monomolecular polymer layers. The LB interactions were stronger with the alumina substrate than silica. DSC analysis was performed, and the data obtained were in agreement with the spectroscopic data. Unlike the bulk polymer, the PVP monolayer was characterized with an extraordinarily large dynamic heterogeneity within the glass transition while broadening the transition range and varying the activation energy by an order of magnitude. The PEG monolayer adsorbed on silica was totally amorphous, whereas a highly crystalline one with the anomalously thin lamellae, down to 3 nm thick, was adsorbed on an alumina surface, presumably as a result of the quasi-heteroepitaxial crystallization process.

[Influence of direct electric current on hydrodynamic diameter of human serum albumin].

The effect of the weak electric current (2 mA/cm2) on structural characteristics (hydrodynamic diameter and molecular weight) of the human serum albumin (HSA) was studied using photon correlation spectroscopy (PCS). The average diameter of initial HSA globule is approximately 7 nm (66.8 kDa). After electric current treatment during 2-5 min the diameter of HSA monomer increases to 7.5 nm. The duration of electric current treatment being increased to 20 min the size of HSA monomers decreases to 6.4 nm. The behaviour of HSA oligomers is close to that of monomers. Consequently, changes in the sizes of monomers and oligomers of HSA under the electric current treatment are caused by the change in the charge density stimulating change of tertiary structure of molecules and possible addition of ions from the buffer solution to them.

Surface structure and properties of mixed fumed oxides.

A variety of fumed oxides such as silica, alumina, titania, silica/alumina (SA), silica/titania (ST), and alumina/silica/titania (AST) were characterized. These oxides have different specific surface areas and different primary particle composition in the bulk and at the surface. These materials were studied by FTIR, NMR, Auger electron spectroscopy, one-pass temperature-programmed desorption with mass spectrometry control (OP TPDMS), microcalorimetry, and nitrogen adsorption. Nonlinear changes in the surface content of alumina in SA and AST and titania in ST and AST samples with increasing oxide content along with simultaneous changes in their specific surface area cause complex dependencies of the heat of immersion in water and desorption of water on heating on the structural parameters. Simultaneous analysis of changes in the surface phase composition, in the concentration of hydroxyls, and in the structural characteristics reveals that at a low content of the second phase the structural characteristics (e.g., S(BET)) are predominant; however, at a large content of these oxides the phase composition plays a more important role.