Olive mill wastewater treatment using natural adsorbents: phytotoxicity on durum wheat (Triticum turgidum L. var. durum) and white bean (Phaseolus vulgaris L.) seed germination.

This research was undertaken to optimize the phenolic compound removal from Olive Mill Wastewater (OMW) by sawdust and red clay as natural adsorbents. Fractional factorial experimental design at 25-1 was used in order to optimize the experimental conditions for high removal efficiency. Statistics ANOVA analysis, Fisher's test, and Student's test suggested that the adsorbent dose has the most significant influence on polyphenol removal for both adsorbents. The maximum removal of polyphenols by sawdust reached 49.6% at 60 °C by using 60 g/L of adsorbent dose, pH 2, reaction time of 24 h, and agitation speed of 80 rpm. Whereas, for red clay, 48.08% of polyphenols removal was observed under the same conditions for sawdust except the temperature of 25 °C instead of 60 °C. In addition, the thermodynamic parameters suggested spontaneous process for both adsorbents, endothermic for the sawdust and exothermic for red clay. Furthermore, the phytotoxicity effect of OMW on durum wheat (Triticum turgidum L. var. durum) and white bean (Phaseolus vulgaris L.) seed germination was investigated. The obtained results showed that the untreated OMW inhibited the seed germination of T. turgidum and P. vulgaris seeds. OMW treatment with red clay followed by dilution (95% water) resulted in 87 and 30% germination of P. vulgaris and T. turgidum, respectively. While, the treatment of OMW with sawdust and dilution at 95% resulted in 51 and 26% germination of P. vulgaris and T. turgidum, respectively.

Assessment of the impact of diluted and pretreated olive mill wastewater on the treatment efficiency by infiltration-percolation using natural bio-adsorbents.

The current study was carried out to treat the olive mill wastewater (OMW) via infiltration percolation process, using low-cost natural adsorbents that could improve the ability of the system to enhance the disposal rate of elimination of pollutant from the OMW. The experimental pilot was composed of three PVC (polyvinyl chloride) columns with 10 cm in diameter and 110-cm height equipped with lateral air entries. Each column was filled with four layers of 10 cm of a mixture of sand (70%), charcoal (20%) and sawdust (10%) respectively. These layers were alternated by four permeable layers of 10 cm of Pouzzolane. To assess the effect of the pretreatment on the efficiency of the system, three types of OMW were used: raw OMW, diluted OMW with domestic wastewater at 1/1(v/v) ratio and OMW pretreated with lime. For the column feed with raw OMW, an average removal of total COD (41%), dissolved COD (54%), NH4-N (40.25%), NO3- (15.76%), total phosphorus (55.63%) and orthophosphate (50.84%) was recorded. The results showed that the column feed with diluted OMW with domestic wastewater was the most efficient one with a removal rate that reached 93.2% of total COD, 86.2% of dissolved COD, 92% of polyphenol, 92% of orthophosphate (OP), 97.2% of total phosphorus (TP) and 81% of NH4-N. The pretreatment of OMW with lime gave the lowest removal rate for all the parameters: total COD (34%), dissolved COD (50%), NH4-N (30%), NO3- (- 21%), total phosphorus (15.19%) and orthophosphate (9.04%). This study demonstrated that the dilution is a way to optimize the efficiency of the system of infiltration-percolation in treating the OMW.