A sequencing batch reactor system for high-level biological nitrogen and phosphorus removal from abattoir wastewater.

A sequencing batch reactor (SBR) system is demonstrated to biologically remove nitrogen, phosphorus and chemical oxygen demand (COD) to very low levels from abattoir wastewater. Each 6 h cycle contained three anoxic/anaerobic and aerobic sub-cycles with wastewater fed at the beginning of each anoxic/anaerobic period. The step-feed strategy was applied to avoid high-level build-up of nitrate or nitrite during nitrification, and therefore to facilitate the creation of anaerobic conditions required for biological phosphorus removal. A high degree removal of total phosphorus (>98%), total nitrogen (>97%) and total COD (>95%) was consistently and reliably achieved after a 3-month start-up period. The concentrations of total phosphate and inorganic nitrogen in the effluent were consistently lower than 0.2 mg P l(-1) and 8 mg N l(-1), respectively. Fluorescence in situ hybridization revealed that the sludge was enriched in Accumulibacter spp. (20-40%), a known polyphosphate accumulating organism, whereas the known glycogen accumulating organisms were almost absent. The SBR received two streams of abattoir wastewater, namely the effluent from a full-scale anaerobic pond (75%) and the effluent from a lab-scale high-rate pre-fermentor (25%), both receiving raw abattoir wastewater as feed. The pond effluent contained approximately 250 mg N l(-1) total nitrogen and 40 mg P l(-1) of total phosphorus, but relatively low levels of soluble COD (around 500 mg l(-1)). The high-rate lab-scale pre-fermentor, operated at 37 degrees C and with a sludge retention time of 1 day, proved to be a cheap and effective method for providing supplementary volatile fatty acids allowing for high-degree of biological nutrient removal from abattoir wastewater.

Achieving the nitrite pathway using aeration phase length control and step-feed in an SBR removing nutrients from abattoir wastewater.

Aeration phase length control and step-feed of wastewater are used to achieve nitrogen removal from wastewater via nitrite in sequencing batch reactors (SBR). Aeration is switched off as soon as ammonia oxidation is completed, which is followed by the addition of a fraction of the wastewater that the SBR receives over a cycle to facilitate denitrification. The end-point of ammonia oxidation is detected from the on-line measured pH and oxygen uptake rate (OUR). The method was implemented in an SBR achieving biological nitrogen and phosphorus removal from anaerobically pre-treated abattoir wastewater. The degree of nitrite accumulation during the aeration period was monitored along with the variation in the nitrite oxidizing bacteria (NOB) population using fluorescence in situ hybridization (FISH) techniques. It is demonstrated that the nitrite pathway could be repeatedly and reliably achieved, which significantly reduced the carbon requirement for nutrient removal. Model-based studies show that the establishment of the nitrite pathway was primarily the result of a gradual reduction of the amount of nitrite that is available to provide energy for the growth of NOB, eventually leading to the elimination of NOB from the system.

Micro-scale observations of the structure of aerobic microbial granules used for the treatment of nutrient-rich industrial wastewater.

The structure and function of aerobic microbial granules from a lab-scale sequencing batch reactor treating nutrient-rich abattoir wastewater were investigated. These wastewater-fed granules were examined using a wide range of micro-scale techniques including light microscopy, scanning and transmission electron microscopy, fluorescent in situ hybridisation (FISH) combined with confocal laser scanning microscopy and oxygen and pH microsensors, in conjunction with a range of measurements in the bulk liquid phase. Interesting structural features were observed in these granules that have not been reported in synthetic-fed granules. The complex nature of abattoir wastewater was suggested to be responsible for accelerating the breaking process of large mature granules due to a rapid clogging of the granules pores and channels and for the very diverse microbial community observed displaying specific spatial distribution throughout the granules. More importantly, the dissolution at lower pH of mineral complexes associated to the granule matrix of extracellular polymeric substances might have caused the structural damages observed on the granules even though some pH buffer capacity was observed inside these granules. Ciliate protozoa were found to be very abundant on the surface of these wastewater-fed granules, which could potentially assist with reducing the high levels of suspended solids usually present in the aerobic granular sludge effluent. All these observations provide support to future studies on aerobic granular sludge treating real wastewater especially with regard to the granule structure and the mechanisms involved in their formation.

Simultaneous nitrification, denitrification, and phosphorus removal from nutrient-rich industrial wastewater using granular sludge.

The biological removal of nitrogen and phosphorus from nutrient-rich abattoir wastewater using granular sludge has been investigated. A lab-scale sequencing batch reactor, seeded with granular sludge developed using synthetic wastewater, was operated for 13 months under alternating anaerobic and aerobic conditions. It is demonstrated that the granules could be sustained and indeed further developed with the use of abattoir wastewater. The organic, nitrogen, and phosphorus loading rates applied were 2.7 gCOD L(-1) day(-1), 0.43 gN L(-1) day(-1), and 0.06 gP L(-1) day(-1), respectively. The removal efficiency of soluble COD, soluble nitrogen and soluble phosphorus were 85%, 93%, and 89%, respectively. However, the high suspended solids in the effluent limited the overall removal efficiency to 68%, 86%, and 74% for total COD, TN, and TP, respectively. This good nutrient removal was achieved through the process known as simultaneous nitrification, denitrification, and phosphorus removal, likely facilitated by the presence of large anoxic zones in the center of the granules. The removal of nitrogen was likely via nitrite optimizing the use of the limited COD available in the wastewater. Accumulibacter spp. were found to be responsible for most of the denitrification, further reducing the COD requirement for nitrogen and phosphorus removal. Mineral precipitation was evaluated and was not found to significantly contribute to the overall nutrient removal. It is also shown that the minimum HRT in a granular sludge system is not governed by the sludge settleability, as is the case with floccular sludge systems, but likely by the limitations associated with the transfer of substrates in granules.

Microbial distribution of Accumulibacter spp. and Competibacter spp. in aerobic granules from a lab-scale biological nutrient removal system.

Granular sludge for simultaneous nitrification, denitrification and phosphorus removal (SNDPR) was generated and studied in a lab-scale sequencing batch reactor (SBR). The SBR was monitored for 450 days during which the biomass was transformed from flocs to granules, which persisted for the last 130 days of operation. Short sludge settling time was employed to successfully generate the granules, with the 10th and 90th percentiles of diameter being 0.7 and 1.6 mm respectively. Good phosphorus removal and nitrification occurred throughout the SBR operation but only when granules were generated were denitrification and full nutrient removal complete. Fluorescence in situ hybridization and oxygen microsensors were used to study the granules at a microscale. Accumulibacter spp. (a polyphosphate-accumulating organism, PAO) and Competibacter spp. (a glycogen non-polyphosphate-accumulating organism, GAO) were the most abundant microbial community members (together 74% of all Bacteria) and both are capable of denitrification. In the aerobic period of the SBR operation, the oxygen penetrated 250 microm into the granules leaving large anoxic zones in the centre part where denitrification can occur. In granules > 500 microm in diameter, Accumulibacter spp. was dominant in the outermost 200 microm region of the granule while Competibacter spp. dominated in the granule central zone. The stratification of these two populations between the outer aerobic and inner anoxic part of the granule was highly significant (P < 0.003). We concluded that the GAO Competibacter spp., and not the PAO Accumulibacter spp., was responsible for denitrification in this SBR. This is undesirable for SNDPR as savings in carbon demand cannot be fulfilled with phosphorus removal and denitrification being achieved by different groups of bacteria.

Identifying causes for N2O accumulation in a lab-scale sequencing batch reactor performing simultaneous nitrification, denitrification and phosphorus removal.

The recently described process of simultaneous nitrification, denitrification and phosphorus removal (SNDPR) has a great potential to save capital and operating costs for wastewater treatment plants. However, the presence of glycogen-accumulating organisms (GAOs) and the accumulation of nitrous oxide (N(2)O) can severely compromise the advantages of this process. In this study, these two issues were investigated using a lab-scale sequencing batch reactor performing SNDPR over a 5-month period. The reactor was highly enriched in polyphosphate-accumulating organisms (PAOs) and GAOs representing around 70% of the total microbial community. PAOs were the dominant population at all times and their abundance increased, while GAOs population decreased over the study period. Anoxic batch tests demonstrated that GAOs rather than denitrifying PAOs were responsible for denitrification. N(2)O accumulated from denitrification and more than half of the nitrogen supplied in a reactor cycle was released into the atmosphere as N(2)O. After mixing SNDPR sludge with other denitrifying sludge, N(2)O present in the bulk liquid was reduced immediately if external carbon was added. We therefore suggest that the N(2)O accumulation observed in the SNDPR reactor is an artefact of the low microbial diversity facilitated by the use of synthetic wastewater with only a single carbon source.

Simultaneous nitrification, denitrification, and phosphorus removal in a lab-scale sequencing batch reactor.

Simultaneous nitrification and denitrification (SND) via the nitrite pathway and anaerobic-anoxic-enhanced biological phosphorus removal (EBPR) are two processes that can significantly reduce the energy and COD demand for nitrogen and phosphorus removal. The combination of these two processes has the potential of achieving simultaneous nitrogen and phosphorus removal with a minimal requirement for COD. A lab-scale sequencing batch reactor (SBR) was operated in alternating anaerobic-aerobic mode with a low dissolved oxygen (DO) concentration (0.5 mg/L) during the aerobic period, and was demonstrated to accomplish nitrification, denitrification, and phosphorus removal. Under anaerobic conditions, COD was taken up and converted to polyhydroxyalkanoates (PHAs), accompanied by phosphorus release. In the subsequent aerobic stage, PHA was oxidized and phosphorus was taken up to <0.5 mg/L by the end of the cycle. Ammonia was also oxidized during the aerobic period, but without accumulation of nitrite or nitrate in the system, indicating the occurrence of simultaneous nitrification and denitrification. However, off-gas analysis showed that the final denitrification product was mainly nitrous oxide (N(2)O), not N(2). Further experimental results demonstrated that nitrogen removal was via nitrite, not nitrate. These experiments also showed that denitrifying glycogen-accumulating organisms (DGAOs), rather than denitrifying polyphosphate-accumulating organisms (DPAOs), were responsible for the denitrification activity.