Effects of nano metal oxide particles on denitrifying phosphorus removal system: Potential stress mechanism and recovery strategy.

The accumulation of nano metal oxide particles (NMOPs) in municipal sewage treatment systems harms the microbial community and its metabolism in activated sludge system, resulting in the degradation of its pollutants removal performance. In this work, the stress effect of NMOPs on the denitrifying phosphorus removal system was systematically investigated in terms of pollutants removal performance, key enzyme activities, microbial community diversity and abundances, and intracellular metabolites. Among the ZnO NPs, TiO2 NPs, CeO2 NPs, and CuO NPs, the ZnO NPs showed the most significant impacts with the chemical oxygen demand, total phosphorus, and nitrate nitrogen removal ratio decreased from above 90 % to 66.50 %, 49.13 %, and 57.11 %, respectively. The addition of surfactants and chelating agents could relieve the toxic effect of NMOPs on the denitrifying phosphorus removal system, and the chelating agents were more effective than surfactants in performance recovery. After adding ethylene diamine tetra acetic acid, the removal ratio of chemical oxygen demand, total phosphorus, and nitrate nitrogen under ZnO NPs stress was restored to 87.31 %, 88.79 %, and 90.35 %, respectively. The study provides valuable knowledge to better understand the impacts and stress mechanism of NMOPs on activated sludge systems and provides a solution to recover the nutrients removal performance of denitrifying phosphorus removal system under NMOPs stress.

Colour stabilities of three types of orthodontic clear aligners exposed to staining agents.

The aim of this study was to evaluate and compare the colour stabilities of three types of orthodontic clear aligners exposed to staining agents in vitro. Sixty clear orthodontic aligners produced by three manufacturers (Invisalign, Angelalign, and Smartee) were immersed in three staining solutions (coffee, black tea, and red wine) and one control solution (distilled water). After 12-h and 7-day immersions, the aligners were washed in an ultrasonic cleaner and measured with a colourimeter. The colour changes (ΔE*) were calculated on the basis of the Commission Internationale de I'Eclairage L*a*b* colour system (CIE L*a*b*), and the results were then converted into National Bureau of Standards (NBS) units. Fourier transformation infrared (FT-IR) spectroscopy and scanning electron microscopy (SEM) were conducted to observe the molecular and morphologic alterations to the aligner surfaces, respectively. The three types of aligners exhibited slight colour changes after 12 h of staining, with the exception of the Invisalign aligners stained with coffee. The Invisalign aligners exhibited significantly higher ΔE* values (ranging from 0.30 to 27.81) than those of the Angelalign and Smartee aligners (ΔE* values ranging from 0.33 to 1.89 and 0.32 to 1.61, respectively, P<0.05). FT-IR analysis confirmed that the polymer-based structure of aligners did not exhibit significant chemical differences before and after the immersions. The SEM results revealed different surface alterations to the three types of aligner materials after the 7-day staining. The three types of aesthetic orthodontic appliances exhibited colour stability after the 12-h immersion, with the exception of the Invisalign aligners stained by coffee. The Invisalign aligners were more prone than the Angelalign and Smartee aligners to pigmentation. Aligner materials may be improved by considering aesthetic colour stability properties.