Physicochemical and functional properties of pectin extracted from the edible portions of jackfruit at different stages of maturity.

BACKGROUND: The physicochemical and functional properties of pectin (JFP) extracted from edible portions (including pericarp and seed) of raw jackfruit (an underutilized tropical fruit) at four different maturity stages (referred to as stages I, II, III, and IV) were characterized in terms of extraction yields, chemical composition, molecular weight, and antioxidant properties to evaluate its potential use in foods. RESULT: The JFP yield increased from 9.7% to 21.5% with fruit maturity, accompanied by an increase in the galacturonic acid content (50.1%, 57.1%, 63.6%, and 65.2%) for stages I-IV respectively. The molecular weight increased from 147 kDa in stage I to 169 kDa in stage III, but decreased to 114 kDa in stage IV, probably due to cell-wall degradation during maturation. The JFP was of the high methoxyl type and the degree of esterification increased from 65% to 87% with fruit maturity. The functional properties of JFP were similar to or better than those reported for commercial apple pectin, thus highlighting its potential as a food additive. Although the phenolics and flavonoids content of JFP decreased with fruit maturity, their antioxidant capacity increased, which may be correlated with the increased content of galacturonic acid upon fruit development. Gels prepared from JFP showed viscoelastic behavior. Depending on the maturity stage in which they were obtained, different gelation behavior was seen. CONCLUSION: The study confirmed the potential of pectin extracted from edible parts of jackfruit as a promising source of high-quality gelling pectin with antioxidant properties, for food applications. © 2022 Society of Chemical Industry.

In-Depth Characterization of Bioactive Extracts from Posidonia oceanica Waste Biomass.

Posidonia oceanica waste biomass has been valorised to produce extracts by means of different methodologies and their bioactive properties have been evaluated. Water-based extracts were produced using ultrasound-assisted and hot water methods and classified according to their ethanol-affinity (E1: ethanol soluble; E2: non-soluble). Moreover, a conventional protocol with organic solvents was applied, yielding E3 extracts. Compositional and structural characterization confirmed that while E1 and E3 extracts were mainly composed of minerals and lipids, respectively, E2 extracts were a mixture of minerals, proteins and carbohydrates. All the extracts showed remarkably high antioxidant capacity, which was not only related to phenolic compounds but also to the presence of proteins and polysaccharides. All E2 and E3 extracts inhibited the growth of several foodborne fungi, while only E3 extracts decreased substantially the infectivity of feline calicivirus and murine norovirus. These results show the potential of P. oceanica waste biomass for the production of bioactive extracts.

Adsorption isotherm studies on the interaction between polyphenols and apple cell walls: Effects of variety, heating and drying.

The adsorption capacity of principal phenolic compounds onto cell walls from three apple varieties was investigated. Isothermal adsorption modelled with Langmuir, Freundlich and Redlich-Peterson equations were carried out over a range of concentrations from 0.5 to 30 mM before and after cell walls were subjected to boiling, oven-drying or freeze-drying. The isotherm data were best fitted by the Langmuir model in all cases. Polyphenols selectively adsorbed onto cell walls with maximum binding capacities ranging from 140 to 580 µg/mg cell walls depending on surface charge. Increased pectin in apple cell walls caused a 129%-311% decrease in the adsorption of negatively charged polyphenols, presumably due to electrostatic repulsive forces. Boiling had limited effect on cell wall polysaccharides and polyphenol-cell wall interactions. However, more than twofold reduction in binding capacities of polyphenols was induced after drying by altering the structural (i.e. binding sites) and compositional (i.e. pectin degradation) characteristics of cell walls.

Cellulose-pectin composite hydrogels: Intermolecular interactions and material properties depend on order of assembly.

Plant cell walls have a unique combination of strength and flexibility however, further investigations are required to understand how those properties arise from the assembly of the relevant biopolymers. Recent studies indicate that Ca2+-pectates can act as load-bearing components in cell walls. To investigate this proposed role of pectins, bioinspired wall models were synthesised based on bacterial cellulose containing pectin-calcium gels by varying the order of assembly of cellulose/pectin networks, pectin degree of methylesterification and calcium concentration. Hydrogels in which pectin-calcium assembly occurred prior to cellulose synthesis showed evidence for direct cellulose/pectin interactions from small-angle scattering (SAXS and SANS), had the densest networks and the lowest normal stress. The strength of the pectin-calcium gel affected cellulose structure, crystallinity and material properties. The results highlight the importance of the order of assembly on the properties of cellulose composite networks and support the role of pectin in the mechanics of cell walls.

Pectin impacts cellulose fibre architecture and hydrogel mechanics in the absence of calcium.

Pectin is a major polysaccharide in many plant cell walls and recent advances indicate that its role in wall mechanics is more important than previously thought. In this work cellulose hydrogels were synthesised in pectin solutions, as a biomimetic tool to investigate the influence of pectin on cellulose assembly and hydrogel mechanical properties. Most of the pectin (60-80%) did not interact at the molecular level with cellulose, as judged by small angle scattering techniques (SAXS and SANS). Despite the lack of strong interactions with cellulose, this pectin fraction impacted the mechanical properties of the hydrogels through poroelastic effects. The other 20-40% of pectin (containing neutral sugar sidechains) was able to interact intimately with cellulose microfibrils at the point of assembly. These results support the need to revise the role of pectin in cell wall architecture and mechanics, and; furthermore they assist the design of cellulose-based products through controlling the viscoelasticity of the fluid phase.