Microencapsulation of Brazilian Cherokee blackberry extract by freeze-drying using maltodextrin, gum Arabic, and pectin as carrier materials.

There are many blackberry cultivars in Brazil; however, the characteristics and applications of the Cherokee cultivar have not yet been widely studied. For this reason, this research investigated the behaviour of maltodextrin (MD), gum Arabic (GA), and pectin (PEC), as carriers combined in different proportions (20% MD, 15% MD + 5% GA, 15% MD + 5% PEC), on encapsulation of Cherokee blackberry pulp extract obtained by freeze-drying. The results of moisture content (2.73-3.36%), water activity (aw) (0.11-0.15), solubility (52.40-54.11%), hygroscopicity (17.59-21.11%), colour (hue 0.24-0.32), retention of anthocyanins (51.55-60.53%), total phenolic compounds (39.72-70.73 mg GAE/100g), antioxidant activity at 25 mg/mL (77.89-80.02%), IC50 (12.26-14.53), simulated in vitro digestion and morphology were discussed. Concerning morphology, blackberry powders had irregular structures and amorphous structures. Comparatively, the best results were obtained for MD-GA. MD-GA presented the highest content of phenolic compounds (70.73 ± 1.84 mg GAE/100g) and antioxidant activity (80.02%), as well as the lowest IC50 value (12.26). In general, all powders showed an increase in phenolic compounds during in vitro digestion, because of the pH conditions and digestive enzymes present in the simulated digestive fluid. This result shows that the wall material provides protection, since the blackberry rich extract (RE) showed degradation of phenolic compounds in in vitro digestion. In this sense, freeze-drying is a suitable technique for the encapsulation of Cherokee blackberry pulp extract.

Desolventizing of Jatropha curcas oil from azeotropes of solvents using ceramic membranes.

The separation of Jatropha curcas oil from azeotropes of ethyl alcohol-n-hexane and isopropyl alcohol-n-hexane using ceramic membranes with different cutoffs (5, 10 and 20 kDa) is presented. The mass ratios of oil:azeotropes (O:S) studied were 1:3 for feeding pressures of 0.1, 0.2 and 0.3 MPa, and 1:1 for the feeding pressure of 0.1 MPa. Isopropyl alcohol was the best solvent for the membranes conditioning to permeate n-hexane (240 kg/m2 h). In the separation of J. curcas oil and azeotropes of solvents, both membranes showed oil retention and total flux decreases with time. Overall, the lowest decrease in the retentions was reached in the 5 kDa membrane, while the lowest decrease in the total flux was reached in the 20 kDa. In the separation of oil and ethyl alcohol-n-hexane azeotrope, the best retention at 60 min of the process was equal to 17.3 wt% in the 20 kDa membrane at 0.3 MPa and O:S ratio equalled to 1:3. In this condition, the total permeate flux was 17.5 kg/m2 h. Different retentions and permeabilities are provided when changing the O:S ratio, the feeding pressure and the molecular weight cutoff of membranes.