RESUMO
We present green synthesis of silver nanoparticles in water using unirradiated and Ag 15 + ion irradiated phytoextracts of Bergenia Ciliata leaf, Eupatorium adenophorum leaf, Rhododendron arboreum leaf and flower. The use of different plant extracts and their subsequent ion irradiation allow for successful refinement of nanoparticle size and morphology. Due to changes in reducing and capping agents the nanoparticle surface functionalization also varies which not only controls the morphology but also allows for surface oxidation and aggregation processes. In this work, we have synthesized silver nanoparticles which exhibit sizes in the range from 13 to 24 nm and having shapes like spherical, quasispherical, trigonal, hexagonal, cylindrical, dendritic assemblies, and porous nanoparticles. Owing to changes in the size and shape of the nanoparticles, their direct bandgap (2.05 eV - 2.48 eV) and local surface plasmon resonance (420 nm - 490 nm) could also be tuned. These nanoparticles are examined as SERS substrates, where their enhancement factors, limit of detection for methylene blue, and SERS substrate homogeneity have been tested. It has been observed the nanoparticles synthesized using unirradiated plant extracts present an enhancement factor of 10 6 with a limit of detection 10 - 8 M. Whereas nanoparticles with refined morphology and shapes upon irradiation present high enhancement factors of >10 7 and detection limit down to 10 - 9 M. In addition, uniformity in Raman spectra over the SERS substrates has been obtained for selected Ag NPs substrates synthesized using irradiated extracts with minimum relative standard deviation in enhancement factor < 12%.
RESUMO
In this study, water dispersible fluorescent carbon quantum dot (CQD) has been synthesised, having an average size of 8.6 ± 0.4 nm using Cynodon dactylon (CD) following microwave assisted green synthetic one-step method. As-prepared CQD fluoresces strongly at 444 nm having a quantum yield of 1% in water when excited at 350 nm. This fluorescence of CQD is sensitive toward As3+ and Fe3+ metal ions. These CQD are utilized for dual metal ion fluorescence sensing; turn-on fluorescence sensing for As3+ and turn-off fluorescence sensing for Fe3+ ions. Limit of detection for As3+ and Fe3+ ions has been found to be 19 nM and 0.10 µM respectively, which is the lowest value reported for As3+ without any functionalization. The adsorption kinetics of As3+ and Fe3+ ions on CQD have been examined using pseudo-first-order-kinetic model revealing that physical adsorption is dominant over chemical processes in this work. For 0.41 g/L and 1.90 g/L dose of CQD, the equilibrium adsorption capacity was found to be 1.57 × 10-6 mg/g, 2.91 × 10-7 mg/g, and 1.01 × 10-5 mg/g, 1.69 × 10-6 mg/g respectively for As3+ and Fe3+ ions. Despite having low quantum yield in water, as-prepared CQD showed low cytotoxicity and good tolerance against photodegradation of biological cells at concentrations lower than 62.5 µg/mL and when the cells are illuminated up to 12 h. Owing to this, the synthesised CQD have been utilized as fluorescent probes for in itro cell imaging.