RESUMO
AIM: The objective of the current study was to compare the effectiveness of antimicrobial photodynamic therapy (PDT) versus Poly-L-glycolic acid nanoparticles loaded riboflavin incorporated in aloe vera gel (PGA/RF/AV) on periimplant parameters and bacterial counts in chronic hyperglycemic patients having periimplantitis. METHODS: One hundred and two diabetic patients undergoing mechanical debridement (MD) were equally divided into three groups: Group 1: PGA/RF/AV+ MD, Group 2: PDT + MD, and Group 3: MD alone. Periimplant parameters [Bleeding on probing (BoP), probing depth (PD), plaque index (PI), marginal bone level (MBL)] were recorded in all three groups. Periimplant plaque samples were studied to record the levels of Tannerella forsythia (Tf) and Porphyromonas gingivalis (Pg). The recordings were taken at baseline, 3 months and 6 months post treatment. RESULTS: All three groups showed a reduction in severity of periimplantitis measured in terms of PD, PI, MBL and BoP. A statistically significant reduction in PD, PI and MBL was found in patients in Group 2 whereas participants of Group 1 were found to have a significant decrease in BoP. A statistically significant decline in the numbers of both the bacterial species was seen in Group 2 at the three-month follow-up whereas at the six-month follow-up, a statistically significant reduction was observed in treatment Group 2 in the levels of Tf species only. CONCLUSION: Riboflavin-loaded nanocarrier incorporated in aloe vera gel showed greater clinical efficacy than PDT alone in the treatment of periimplantitis in chronic hyperglycemic individuals.
Assuntos
Aloe , Peri-Implantite , Fotoquimioterapia , Humanos , Peri-Implantite/tratamento farmacológico , Fotoquimioterapia/métodos , Fármacos Fotossensibilizantes/uso terapêutico , Desbridamento , Riboflavina/uso terapêuticoRESUMO
AIM: The present study aimed to appraise the effect of Diode laser (DL), riboflavin, and curcumin on the bond strength of adhesive restorative material and the effects of pretreatment on microleakage scores. MATERIAL AND METHODS: Ninety caries-free human permanent premolars were obtained and disinfected. All specimens were mounted till CEJ. To provide standardization, a 2 × 2 mm flat non-carious cervical lesion (NCCL) dentin surface was exposed. This was followed by dentin surface roughening/cervical groove preparation with a round bur. After tooth surface preparation, ninety specimens were divided arbitrarily into three groups. Group 1: NCCL exposed to DL; group 2: NCCL pretreated with riboflavin photosensitizer (RFP) and group 3 pretreated with curcumin photosensitizer (CP). All the three groups were further divided into two subgroups A1, A2, B1, B2, C1, and C2 based on the restorative material used (n = 15). Subgroup A1, B1, and C1 were restored with composite resin (CR). Subgroup A2, B2, and C2 were restored with RMGIC. Ten samples from each subgroup were evaluated for shear bond strength (SBS) testing under a universal testing machine (UTM). Five from each subgroup were evaluated for microleakage assessment. Bond strength and microleakage analysis were performed using analysis of variance (ANOVA) with a Post-hoc test (Tukey's post hoc test) at a significance level (p = 0.05). RESULTS: The group A1, DL-CR shows the highest SBS (16.41± 0.4 MPa). However, CP-RMGIC groups demonstrated the lowest bond integrity. RFP-CR and the DL-CR group displayed comparable outcomes of SBS (p>0.05). The highest microleakage was observed with CP-RMGIC. The least microleakage was displayed by DL-CR. CONCLUSION: Noncarious cervical lesions pretreated with diode laser and riboflavin photosensitizer showed better shear bond strength and reduced microleakage when bonded to composite resin than non-carious cervical lesions pretreated with curcumin.