Proliferation of mammalian cells with Chlorococcum littorale algal compounds without serum support.

In recent years, serum-free medium for mammalian cell cultivation has attracted a lot of attention, considering the high cost of production and environmental load involved in developing the conventional animal sera. The use of alternative growth-promoting products in mammalian cell cultivation such as extracts from microalgae has proven to be quite beneficial and environmental-friendly. This research aims to cultivate mammalian cells with growth-promoting factors derived from Chlorococcum littorale. We have established a simple extraction using the ultrasonication method and applied the extract in place of serum on mammalian C2C12 cell lines, 3T3 cell lines, and CHO cell lines to compare and analyze the effectiveness of the extract. Cell passage was conducted in a suspended culture condition with the addition of the extract. The results indicate that the extract from microalgae shows a high proliferation rate in all cell lines without fetal bovine serum. Moreover, it is eco-friendly and has huge potential to replace the traditional cell culture system. It could be applied in the fields of regenerative medicine, gene/cell therapies, as well as cultured meat production.

A novel alveolar epithelial cell sheet fabricated under feeder-free conditions for potential use in pulmonary regenerative therapy.

Introduction: Lung transplantation is the only effective treatment option for many patients with irreversible pulmonary injury, and the demand for lung transplantation is increasing worldwide and expected to continue to outstrip the number of available donors. Regenerative therapy with alveolar epithelial cells (AECs) holds promise as an alternative option to organ transplantation. AECs are usually co-cultured with mouse-derived 3T3 feeder cells, but the use of xenogeneic tissues for regenerative therapy raises safety concerns. Fabrication of AEC sheets under feeder-free conditions would avoid these safety issues. We describe a novel feeder-free method of fabricating AEC sheets that may be suitable for pulmonary regenerative therapy. Methods: Lung tissues excised from male outbred rats or transgenic rats expressing green fluorescent protein (GFP) were finely minced and dissociated with elastase. The isolated AECs were cultured under four different feeder-free conditions according to whether a rho kinase (ROCK) inhibitor was included in the low-calcium medium (LCM) and whether the tissue culture dish was coated with recombinant laminin-511 E8 fragment (rLN511E8). The expanded cells were cultured on temperature-responsive dishes and subsequently harvested as AEC sheets. Engraftment of GFP-AEC sheets after their transplantation onto a partially resected region of the left lung was assessed in athymic rats. Results: AECs proliferated and reached confluence when cultured in LCM containing a ROCK inhibitor on tissue culture dishes coated with rLN511E8. When both the ROCK inhibitor and rLN511E8-coated culture dish were used, the number of AECs obtained after 7 days of culture was significantly higher than that in the other three groups. Immunohistochemical analyses revealed that aquaporin-5, surfactant protein (SP)-A, SP-C, SP-D and Axin-2 were expressed by the cultured AECs. AEC sheets were harvested successfully from temperature-responsive culture dishes (by lowering the temperature) when the expanded AECs were cultured for 7 days in LCM + ROCK inhibitor and then for 3 days in LCM + ROCK inhibitor supplemented with 200 mg/L calcium chloride. The AEC sheets were firmly engrafted 7 days after transplantation onto the lung defect and expressed AEC marker proteins. Conclusions: AEC sheets fabricated under feeder-free conditions retained the features of AECs after transplantation onto the lung in vivo. Further improvement of this technique may allow the bioengineering of alveolar-like tissue for use in pulmonary regenerative therapy.

Proliferation and differentiation of primary bovine myoblasts using Chlorella vulgaris extract for sustainable production of cultured meat.

Recently, cultured meat obtained from livestock-derived cells is being considered as a sustainable food source that reduces the use of natural resources. This study aimed to show that nutrients extracted from Chlorella vulgaris were beneficial in the culture of primary bovine myoblasts (PBMs), a major cell source for cultured meat production. Nutrients (glucose, amino acids, and vitamins) present in the animal-cell culture media were effectively recovered from C. vulgaris using acid hydrolysis treatment. On culture in nutrient-free inorganic salt solution, cell death was induced in most PBMs after 6 days of cultivation. However, the addition of C. vulgaris extract (CVE) significantly improved PBM viability, which was comparable to the viability in conventional culture medium (Dulbecco's modified Eagle's medium). Furthermore, by adding horse serum to induce differentiation, the formation of myotubes was confirmed when CVE were used. Together, the results showed that CVE could be used as an alternative to the conventional culture medium for PBMs. These findings will not only lower the environmental risks associated with the establishment of this eco-friendly cell culture system, but also highlight microalgae as a potent nutrient source that can replace conventional grain-dependent nutrient sources.

A novel ADPKD model using kidney organoids derived from disease-specific human iPSCs.

Autosomal dominant polycystic kidney disease (ADPKD) is a hereditary disorder which manifests progressive renal cyst formation and leads to end-stage kidney disease. Around 85% of cases are caused by PKD1 heterozygous mutations, exhibiting relatively poorer renal outcomes than those with mutations in other causative gene PKD2. Although many disease models have been proposed for ADPKD, the pre-symptomatic pathology of the human disease remains unknown. To unveil the mechanisms of early cytogenesis, robust and genetically relevant human models are needed. Here, we report a novel ADPKD model using kidney organoids derived from disease-specific human induced pluripotent stem cells (hiPSCs). Importantly, we found that kidney organoids differentiated from gene-edited heterozygous PKD1-mutant as well as ADPKD patient-derived hiPSCs can reproduce renal cysts. Further, we demonstrated the possibility of ADPKD kidney organoids serving as drug screening platforms. This newly developed model will contribute to identifying novel therapeutic targets, extending the field of ADPKD research.

Contractile force measurement of human induced pluripotent stem cell-derived cardiac cell sheet-tissue.

We have developed our original tissue engineering technology "cell sheet engineering" utilizing temperature-responsive culture dishes. The cells are confluently grown on a temperature-responsive culture dish and can be harvested as a cell sheet by lowering temperature without enzymatic digestion. Cell sheets are high-cell-density tissues similar to actual living tissues, maintaining their structure and function. Based on this "cell sheet engineering", we are trying to create functional cardiac tissues from human induced pluripotent stem cells, for regenerative therapy and in vitro drug testing. Toward this purpose, it is necessary to evaluate the contractility of engineered cardiac cell sheets. Therefore, in the present study, we developed a contractile force measurement system and evaluated the contractility of human iPSC-derived cardiac cell sheet-tissues. By attaching the cardiac cell sheets on fibrin gel sheets, we created dynamically beating cardiac cell sheet-tissues. They were mounted to the force measurement system and the contractile force was measured stably and clearly. The absolute values of contractile force were around 1 mN, and the mean force value per cross-sectional area was 3.3 mN/mm2. These values are equivalent to or larger than many previously reported values, indicating the functionality of our engineered cardiac cell sheets. We also confirmed that both the contractile force and beating rate were significantly increased by the administration of adrenaline, which are the physiologically relevant responses for cardiac tissues. In conclusion, the force measurement system developed in the present study is valuable for the evaluation of engineered cardiac cell sheet-tissues, and for in vitro drug testing as well.

Boiogito Increases the Metabolism of Fatty Acids in Proximal Tubular Cells through Peroxisome Proliferators-Activated Receptor (PPAR) α Agonistic Activity.

The promotion of fatty acid metabolism, to which peroxisome proliferators-activated receptor (PPAR) α contributes, has been suggested to participate in maintaining the function of renal proximal tubular epithelial cells (PTECs). The loading of fatty acids to PTECs could result in cell inflammation and cell death. A "Kampo" medicine, Boiogito (BO), is used to treat overweight women exhibiting chronic fatigue and edema in the lower extremities or knees. BO improves renal function by reducing the portion of fatty acids, thereby preventing damage to PTECs. In this study, BO and Astragalus Root (AsR), a constituent crude drug of BO, were administered orally to intravenously bovine serum albumin (BSA)-administered mice to evaluate the PPARα-cAMP responsive element binding protein (CREB) binding protein (CBP) complex binding activity and/or mRNA expression of PPARα, as quantified by enzyme-linked immunosorbent assay (ELISA) and/or polymerase chain reaction (PCR). Increases in PPARα-CBP complex binding activity and the expression of PPARα mRNA were observed not only in BO-administered mice but also in AsR-administered mice, accompanied by a decrease in the amount of renal fatty acid.

Historical control data on developmental toxicity studies in rodents.

Historical control data on rodent developmental toxicity studies, performed between 1994 and 2010, were obtained from 19 laboratories in Japan, including 10 pharmaceutical and chemical companies and nine contract research organizations. Rats, mice, and hamsters were used for developmental toxicity studies. Data included maternal reproductive findings at terminal cesarean sections and fetal findings including the spontaneous incidences of external, visceral, and skeletal anomalies. No noticeable differences were observed in maternal reproductive data between laboratories. Inter-laboratory variations in the incidences of fetuses with anomalies appeared to be due to differences in the selection of observation parameters, observation criteria, classification of the findings, and terminology of fetal alterations. Historical control data are useful for the appropriate interpretation of experimental results and evaluation of the effects of chemical on reproductive and developmental toxicities.

Cell delivery in regenerative medicine: the cell sheet engineering approach.

Recently, cell-based therapies have developed as a foundation for regenerative medicine. General approaches for cell delivery have thus far involved the use of direct injection of single cell suspensions into the target tissues. Additionally, tissue engineering with the general paradigm of seeding cells into biodegradable scaffolds has also evolved as a method for the reconstruction of various tissues and organs. With success in clinical trials, regenerative therapies using these approaches have therefore garnered significant interest and attention. As a novel alternative, we have developed cell sheet engineering using temperature-responsive culture dishes, which allows for the non-invasive harvest of cultured cells as intact sheets along with their deposited extracellular matrix. Using this approach, cell sheets can be directly transplanted to host tissues without the use of scaffolding or carrier materials, or used to create in vitro tissue constructs via the layering of individual cell sheets. In addition to simple transplantation, cell sheet engineered constructs have also been applied for alternative therapies such as endoscopic transplantation, combinatorial tissue reconstruction, and polysurgery to overcome limitations of regenerative therapies and cell delivery using conventional approaches.

Fabrication of pulsatile cardiac tissue grafts using a novel 3-dimensional cell sheet manipulation technique and temperature-responsive cell culture surfaces.

Recent progress in cell transplantation therapy to repair impaired hearts has encouraged further attempts to bioengineer 3-dimensional (3-D) heart tissue from cultured cardiomyocytes. Cardiac tissue engineering is currently pursued utilizing conventional technology to fabricate 3-D biodegradable scaffolds as a temporary extracellular matrix. By contrast, new methods are now described to fabricate pulsatile cardiac grafts using new technology that layers cell sheets 3-dimensionally. We apply novel cell culture surfaces grafted with temperature-responsive polymer, poly(N-isopropylacrylamide) (PIPAAm), from which confluent cells detach as a cell sheet simply by reducing temperature without any enzymatic treatments. Neonatal rat cardiomyocyte sheets detached from PIPAAm-grafted surfaces were overlaid to construct cardiac grafts. Layered cell sheets began to pulse simultaneously and morphological communication via connexin43 was established between the sheets. When 4 sheets were layered, engineered constructs were macroscopically observed to pulse spontaneously. In vivo, layered cardiomyocyte sheets were transplanted into subcutaneous tissues of nude rats. Three weeks after transplantation, surface electrograms originating from transplanted grafts were detected and spontaneous beating was macroscopically observed. Histological studies showed characteristic structures of heart tissue and multiple neovascularization within contractile tissues. Constructs transplanted into 3-week-old rats exhibited more cardiomyocyte hypertrophy and less connective tissue than those placed into 8-week-old rats. Long-term survival of pulsatile cardiac grafts was confirmed up to 12 weeks. These results demonstrate that electrically communicative pulsatile 3-D cardiac constructs were achieved both in vitro and in vivo by layering cardiomyocyte sheets. Cardiac tissue engineering based on this technology may prove useful for heart model fabrication and cardiovascular tissue repair. The full text of this article is available at http://www.circresaha.org.