A pilot system integrating a settling technique and a horizontal subsurface flow constructed wetland for the treatment of polluted lake water.

An integrated system was tested at pilot-scale for treating polluted water from the Marriot Lake in Egypt, comprising a settling technique followed by three parallel horizontal subsurface flow constructed wetland (HFCWs) units operating under a continuous flow mode; one HFCW unit was planted with Typha angustifolia and contained a perforated pipes network for enhanced passive aeration (CWA), one unit was planted without the perforated pipe network (CWR) and one served as a Control unit (unplanted and without perforated pipes). Changes in physicochemical parameters, BOD5, nutrients (nitrogen, phosphorus), microbial community, and trace metals at different hydraulic retention times (HRT; 0.5-6 h) and hydraulic loading rates (HLR; 750, 1000, 1250, and 2000 L/m2/d) were monitored. The CWA unit had an overall better performance than the CWR unit, while both planted units outperformed the Control unit. CWA showed the highest performance at HLR of 1000 L/m2/d and 4-6 h-HRT with 95.3% removal for turbidity, 83% for BOD5, 99.3% for ammonia nitrogen (NH4-N), 70.8% for Total Nitrogen (TN), and 66.7% for Total Phosphorus (TP), while higher NO3-N and NO2-N effluent concentrations were observed. Trace metals levels were significantly reduced and accumulated in plant tissues. Microbial communities' densities fluctuated in the CWA unit. The integrated system with the settling stage and the planted CWA unit was proved to achieve a high removal efficiency and reached the national discharge limits, thus representing a novel nature-based solution for the sustainable remediation of polluted lake water.

Hydraulic characterization and removal of metals and nutrients in an aerated horizontal subsurface flow "racetrack" wetland treating primary-treated oil industry effluent.

Constructed wetlands (CW) are an attractive technology due to their operational simplicity and low life-cycle cost. It has been applied for refinery effluent treatment but mostly single-stage designs (e.g., vertical or horizontal flow) have been tested. However, to achieve a good treatment efficiency for industrial effluents, different treatment conditions (both aerobic and anaerobic) are needed. This means that hybrid CW systems are typically required with a respectively increased area demand. In addition, a strong aerobic environment that facilitates the formation of iron, manganese, zinc and aluminum precipitates cannot be established with passive wetland systems, while the role of these oxyhydroxide compounds in the further co-precipitation and removal of heavy metals such as copper, nickel, lead, and chromium that can simplify the overall treatment of industrial wastewaters is poorly understood in CW. Therefore, this study tests for the first time an innovative CW design that combines an artificially aerated section with a non-aerated section in a single unit applied for oil refinery wastewater treatment. Four pilot units were tested with different design (i.e., planted/unplanted, aerated/non-aerated) and operational (two different hydraulic loading rates) characteristics to estimate the role of plants and artificial aeration and to identify the optimum design configuration. The pilot units received a primary refinery effluent, i.e., after passing through a dissolved air flotation unit. The first-order removal of heavy metals under aerobic conditions is evaluated, along with the removal of phenols and nutrients. High removal rates for Fe (96-98%), Mn (38-81%), Al (49-73%), and Zn (99-100%) generally as oxyhydroxide precipitates were found, while removal of Cu (61-80%), Ni (70-85%), Pb (96-99%) and Cr (60-92%) under aerobic conditions was also observed, likely through co-precipitation. Complete phenols and ammonia nitrogen removal was also found. The first-order rate coefficient (k) calculated from the collected data demonstrates that the tested CW represents an advanced wetland design reaching higher removal rates at a smaller area demand than the common CW systems.

Effect of design and operational parameters on nutrients and heavy metal removal in pilot floating treatment wetlands with Eichhornia Crassipes treating polluted lake water.

Though having an economic and ecological impact on Marriott Lake management in Egypt, water hyacinth (Eichhornia crassipes) is an aquatic floating macrophyte with a known phytoremediation potential. In order to assess its remediation potential, pilot floating treatment wetlands (FTWs) with E. crassipes were built in duplicates to evaluate the removal of nutrients and heavy metals from the polluted lake water. The experimental design included units with different water depths (15, 25, and 35 cm; D15, D25, and D35, respectively) and plant coverage (90, 70, 50, and 0%; P90, P70, P50, and P0, respectively). The pilot FTWs were monitored over a 7-day operation cycle to identify the optimum combination of design (plant coverage, water depth) and operation (hydraulic retention time; HRT) parameters needed for maximum BOD5, TN, NH4-N, and TP removal. NH4-N removal reached 97.4% in the D25P50 unit after 3 days, BOD5 75% in the D15P90 after 3 days, TN 82% in the D25P70 after 4 days, and TP 84.2% in the D35P70 after 4 days. The open-water evaporation rate was higher than the evapotranspiration rate in the planted units, probably due to the warm climate of the study area. Metals were also sufficiently removed through bioaccumulation in plant tissues in the order of Fe > Pb > Cu > Ni (62.5%, 88.9%, 81.7%, and 80.4% for D25P50, D25P70, D25P50, and D25P90, respectively), while most of the assimilated metal mass was translocated to the plant roots. The biochemical composition of the plant tissue was significantly different between the shoot and root parts. Overall, the FTW with 70% E. crassipes coverage, 25-cm water depth, and an HRT of 3-5 days was identified as the optimum design for effective remediation of the polluted Marriott Lake in Egypt.

Stability and maturity of thickened wastewater sludge treated in pilot-scale sludge treatment wetlands.

Thickened wastewater activated sludge was treated in 13 pilot-scale sludge treatment wetlands of various configurations that operated continuously for three years in North Greece. Sludge was loaded for approximately 2.5 years, and the beds were left to rest for the remaining period. Three different sludge loading rates were used that represented three different population equivalents. Residual sludge stability and maturity were monitored for the last year. Sludge was regularly sampled and microbial respiration activity indices were measured via a static respiration assay. The phytotoxicity of sludge was quantified via a seed germination bioassay. Measurements of total solids, organic matter, total coliforms, pH and electrical conductivity were also made. According to microbial respiration activity measurements, the sludge end-product was classified as stable. The germination index of the final product exceeded 100% in most wetland units, while final pH values were approximately 6.5. The presence of plants positively affected the stability and maturity of the residual sludge end-product. Passive aeration did not significantly affect the quality of the residual sludge, while the addition of chromium at high concentrations hindered the sludge decomposition process. Conclusively, sludge treatment wetlands can be successfully used, not only to dewater, but also to stabilize and mature wastewater sludge after approximately a four-month resting phase.