Assessment of Antioxidative and Alpha-Amylase Potential of Polyherbal Extract.

The present study aims to prepare a polyherbal formulation (PHF) of Azadirachta indica (Neem), Aloe barbadensis (Aloe vera), Allium sativum (garlic), Acacia arabica (Babul), and Aegle marmelos (Bel) and evaluation of antidiabetic and antioxidant activity utilizing the in vitro model. Air-dried powder of 5 medicinal plants, which are divided into equal portions, and PHF, is prepared by the soxhlet technique using polar and nonpolar solvents. The PHF is screened for the phytochemical screening, and then the antidiabetic activity is determined by alpha-amylase inhibition. The extracts thus obtained are also subjected to the inhibition assay by the use of (DNS) dinitro salicylic acid. The antioxidant activity was determined by the DPPH radical scavenging assay, H2O2 scavenging assay, and TBARS assay. In in vitro study, the result revealed polyherbal formulation in which hot water extract has the topmost inhibitory effect on alpha-amylase activity, ranging from 20.4% to 79.5% with an IC50 value of 48.98 ± 0.31 µg/ml. This extract clearly showed the effective lowering of postprandial hypertriglyceridemia (PPHG). In the antioxidant activity carried out by using the (DPPH) radical scavenging assay, the highest result was obtained by the concentration of 250 µg/ml, which was around 77.2 ± 0.05 with statistical significance compared with control (a: p < 0.01; b: p < 0.001), while in the GTA method, the highest result was obtained by the concentration of 250 µg/ml, which was around 78.2 ± 0.05, and in the case of the TBARS assay, the concentration of 250 µg/ml gave around 76.2 ± 0.03 anti-oxidant value. In conclusion, the study shows that polyherbal formulation has superior antidiabetic activity and antioxidant properties.

Neuropharmacological and Antidiabetic Potential of Lannea coromandelica (Houtt.) Merr. Leaves Extract: An Experimental Analysis.

The present study examines the neuropharmacological and antidiabetic properties of methanol leaves extract of Lannea coromandelica in animal models. This study is carried out by elevated plus-maze apparatus, motor coordination, thiopental sodium has an induction role in sleeping time, hole board, hole cross, open field, antidiabetic studies. Mice were treated doses of 100, 150, and 200 mg/kg body weight in elevated plus-maze apparatus and motor coordination; 100 and 200 mg/kg body weight in sleeping time, hole cross, hole board, and open field tests; and 200 and 400 mg/kg body weight in the antidiabetic activity test. Extraction specifies a significantly decreased time duration and sleeping time in a thiopental sodium-induced sleeping time test. The experimental extract decreased locomotor and exploratory behaviors of mice in the open-field and hole-cross tests compared to the effects of the control. Furthermore, the extract increased sleeping time with a dose-dependent onset of action. The hole-board test extract also demonstrated a reduced number of head dips. The findings showed that L. coromandelica has potential neuropharmacological effects. In addition, in alloxan-induced diabetic mice, leaves extract at 200 and 400 mg/kg body weight revealed significant antidiabetic properties and could be used to manage blood glucose levels with more research.

Recent technologies for nutrient removal and recovery from wastewaters: A review.

Water scarcity and its pollution has become a concern in recent times. The disposal of nutrient-rich (nitrogen and phosphorous) wastewater is also one of the main cause of water pollution through eutrophication, reduced dissolved oxygen that poses threat to aquatic ecosystems. As a result, nutrient removal has become a mandate apart from the removal of organics. However, the removal of nutrients from sewage is a challenging task. Conversely, conventional biological treatment processes provide little relief in nutrient removal. The treated effluents from conventional biological processes do not achieve the stringent nutrient removal disposal standard limits and become primary cause of pollution in the receiving water bodies. This has stressed upon the need for eco-friendly, low-energy and cost-efficient nutrient removal treatment technologies. Various biological treatment combinations or variants are in use for the efficient removal of nutrients. The biological processes in itself or in combination with chemical processes are preferred over technologies based solely on physico-chemical processes for its treatment performance at lower cost. This review summarizes the existing treatment processes and their possible up-gradation with the aim to accomplish the marked effluent standards for the nutrients. The concept of conventional systems and advanced systems for nutrients (nitrogen and phosphorous) removal which are already developed or under development are deeply discussed. Further, the challenges of each treatment systems are abridged. Finally, the possible suggestions for the modification/retrofitting of existing treatment systems for achieving stringent disposal standards are pointed out.

Experimental design of Al2O3/MWCNT/HDPE hybrid nanocomposites for hip joint replacement.

Fracture in the hip joint is a major and quite common health issue, particularly for the elderly. The loads exploited by the lower limbs are very acute and severe; in the femur, they can be several folds higher than the whole weight of the body. Nanotechnology and nanocomposites offer great potential in biomedical applications. The organic materials are more biocompatible. Mechanical properties like strength and hardness are challenging parameters which control the selection of a joint. HDPE in its pure form has been successfully used as a prosthetic foot (external) but failed as an implant material due to limited mechanical properties. High-density polyethylene thermoplastic polymer (HDPE) and multi-walled carbon nanotubes (MWCNT)/Nano-Alumina is selected as a potential material for a biomedical implant and its mechanical properties and biocompatibility have been discussed. HDPE/MWCNT/Alumina (Al2O3) nanocomposites have not been explored yet for prosthetic implants. These nanocomposites were prepared in this investigation in different compositions. Prepared material has been physiochemically characterized to check the morphology and the structure. MWCNTs enhanced hardness and elastic modulus of the HDPE. Optimization of the material composition revealed that hybrid composite with structure (2.4% Al2O3 and 0.6% MWCNT) exhibits better mechanical properties compared to other ratios with 3% MWCNTs and 5% MWCNTs. Thermal gravimetric analysis (TGA) dedicates that the percentage of crystallization has been increased to 6% after adding MWCNT to HDPE. The moisture absorption decreased to 90% with 5% MWCNT. Experimental results of Colorimetric assay (MTT) of a normal human epithelial cell line (1- BJ1) over Al2O3/MWCNT@HDPE showed <20% cytotoxic activity, proving its acceptance for medical use. HDPE/MWCNT/Al2O3 nanocomposites emerged as a candidate material for artificial joints.