Nanowired Delivery of Curcumin Attenuates Methamphetamine Neurotoxicity and Elevates Levels of Dopamine and Brain-Derived Neurotrophic Factor.

Curcumin is a well-known antioxidant used as traditional medicine in China and India since ages to treat variety of inflammatory ailments as a food supplement. Curcumin has antitumor properties with neuroprotective effects in Alzheimer's disease. Curcumin elevates brain-derived neurotrophic factor (BDNF) and dopamine (DA) levels in the brain indicating its role in substance abuse. Methamphetamine (METH) is one of the most abused substances in the world that induces profound neurotoxicity by inducing breakdown of the blood-brain barrier (BBB), vasogenic edema and cellular injuries. However, influence of curcumin on METH-induced neurotoxicity is still not well investigated. In this investigation, METH neurotoxicity and neuroprotective effects of curcumin nanodelivery were examined in a rat model. METH (20 mg/kg, i.p.) neurotoxicity is evident 4 h after its administration exhibiting breakdown of BBB to Evans blue albumin in the cerebral cortex, hippocampus, cerebellum, thalamus and hypothalamus associated with vasogenic brain edema as seen measured using water content in all these regions. Nissl attaining exhibited profound neuronal injuries in the regions of BBB damage. Normal curcumin (50 mg/kg, i.v.) 30 min after METH administration was able to reduce BBB breakdown and brain edema partially in some of the above brain regions. However, TiO2 nanowired delivery of curcumin (25 mg/kg, i.v.) significantly attenuated brain edema, neuronal injuries and the BBB leakage in all the brain areas. BDNF level showed a significant higher level in METH-treated rats as compared to saline-treated METH group. Significantly enhanced DA levels in METH-treated rats were also observed with nanowired delivery of curcumin. Normal curcumin was able to slightly elevate DA and BDNF levels in the selected brain regions. Taken together, our observations are the first to show that nanodelivery of curcumin induces superior neuroprotection in METH neurotoxicity probable by enhancing BDNF and DA levels in the brain, not reported earlier.

Origin of Δ9-Tetrahydrocannabinol Impurity in Synthetic Cannabidiol.

Introduction: Cannabidiol (CBD), the nonintoxicating constituent of cannabis, is largely employed for pharmaceutical and cosmetic purposes. CBD can be extracted from the plant or chemically synthesized. Impurities of psychotropic cannabinoids Δ9-tetrahydrocannabinol (Δ9-THC) and Δ8-THC have been found in extracted CBD, thus hypothesizing a possible contamination from the plant. Materials and Methods: In this study, synthetic and extracted CBD samples were analyzed by ultrahigh-performance liquid chromatography coupled to high-resolution mass spectrometry and the parameters that can be responsible of the conversion of CBD into THC were evaluated by an accelerated stability test. Results: In synthetic and extracted CBD no trace of THC species was detected. In contrast, CBD samples stored in the dark at room temperature on the benchtop for 3 months showed the presence of such impurities. Experiments carried out under inert atmosphere in the absence of humidity or carbon dioxide led to no trace of THC over time even at high temperature. Conclusions: The results suggested that the copresence of carbon dioxide and water from the air could be the key for creating the acidic environment responsible for the cyclization of CBD. These findings suggest that it might be appropriate to review the storage conditions indicated on the label of commercially available CBD.

Pitfalls in the analysis of phytocannabinoids in cannabis inflorescence.

The chemical analysis of cannabis potency involves the qualitative and quantitative determination of the main phytocannabinoids: Δ9-tetrahydrocannabinol (Δ9-THC), cannabidiol (CBD), cannabigerol (CBG), cannabichromene (CBC), etc. Although it might appear as a trivial analysis, it is rather a tricky task. Phytocannabinoids are present mostly as carboxylated species at the aromatic ring of the resorcinyl moiety. Their decarboxylation caused by heat leads to a greater analytical variability due to both reaction kinetics and possible decomposition. Moreover, the instability of cannabinoids and the variability in the sample preparation, extraction, and analysis, as well as the presence of isomeric forms of cannabinoids, complicates the scenario. A critical evaluation of the different analytical methods proposed in the literature points out that each of them has inherent limitations. The present review outlines all the possible pitfalls that can be encountered during the analysis of these compounds and aims to be a valuable help for the analytical chemist. Graphical abstract.

A Metabolomic Approach Applied to a Liquid Chromatography Coupled to High-Resolution Tandem Mass Spectrometry Method (HPLC-ESI-HRMS/MS): Towards the Comprehensive Evaluation of the Chemical Composition of Cannabis Medicinal Extracts.

INTRODUCTION: Cannabis sativa L. is a powerful medicinal plant and its use has recently increased for the treatment of several pathologies. Nonetheless, side effects, like dizziness and hallucinations, and long-term effects concerning memory and cognition, can occur. Most alarming is the lack of a standardised procedure to extract medicinal cannabis. Indeed, each galenical preparation has an unknown chemical composition in terms of cannabinoids and other active principles that depends on the extraction procedure. OBJECTIVE: This study aims to highlight the main differences in the chemical composition of Bediol® extracts when the extraction is carried out with either ethyl alcohol or olive oil for various times (0, 60, 120 and 180 min for ethyl alcohol, and 0, 60, 90 and 120 min for olive oil). METHODOLOGY: Cannabis medicinal extracts (CMEs) were analysed by liquid chromatography coupled to high-resolution tandem mass spectrometry (LC-MS/MS) using an untargeted metabolomics approach. The data sets were processed by unsupervised multivariate analysis. RESULTS: Our results suggested that the main difference lies in the ratio of acid to decarboxylated cannabinoids, which dramatically influences the pharmacological activity of CMEs. Minor cannabinoids, alkaloids, and amino acids contributing to this difference are also discussed. The main cannabinoids were quantified in each extract applying a recently validated LC-MS and LC-UV method. CONCLUSIONS: Notwithstanding the use of a standardised starting plant material, great changes are caused by different extraction procedures. The metabolomics approach is a useful tool for the evaluation of the chemical composition of cannabis extracts. Copyright © 2017 John Wiley & Sons, Ltd.

Analysis of cannabinoids in commercial hemp seed oil and decarboxylation kinetics studies of cannabidiolic acid (CBDA).

Hemp seed oil from Cannabis sativa L. is a very rich natural source of important nutrients, not only polyunsaturated fatty acids and proteins, but also terpenes and cannabinoids, which contribute to the overall beneficial effects of the oil. Hence, it is important to have an analytical method for the determination of these components in commercial samples. At the same time, it is also important to assess the safety of the product in terms of amount of any psychoactive cannabinoid present therein. This work presents the development and validation of a highly sensitive, selective and rapid HPLC-UV method for the qualitative and quantitative determination of the main cannabinoids, namely cannabidiolic acid (CBDA), tetrahydrocannabinolic acid (THCA), cannabidiol (CBD), tetrahydrocannabinol (THC), cannabinol (CBN), cannabigerol (CBG) and cannabidivarin (CBDV), present in 13 commercial hemp seed oils. Moreover, since decomposition of cannabinoid acids generally occurs with light, air and heat, decarboxylation studies of the most abundant acid (CBDA) were carried out in both open and closed reactor and the kinetics parameters were evaluated at different temperatures in order to evaluate the stability of hemp seed oil in different storage conditions.

Medicinal cannabis: Principal cannabinoids concentration and their stability evaluated by a high performance liquid chromatography coupled to diode array and quadrupole time of flight mass spectrometry method.

In the last few years, there has been a boost in the use of cannabis-based extracts for medicinal purposes, although their preparation procedure has not been standardized but rather decided by the individual pharmacists. The present work describes the development of a simple and rapid high performance liquid chromatography method with UV detection (HPLC-UV) for the qualitative and quantitative determination of the principal cannabinoids (CBD-A, CBD, CBN, THC and THC-A) that could be applied to all cannabis-based medicinal extracts (CMEs) and easily performed by a pharmacist. In order to evaluate the identity and purity of the analytes, a high-resolution mass spectrometry (HPLC-ESI-QTOF) analysis was also carried out. Full method validation has been performed in terms of specificity, selectivity, linearity, recovery, dilution integrity and thermal stability. Moreover, the influence of the solvent (ethyl alcohol and olive oil) was evaluated on cannabinoids degradation rate. An alternative extraction method has then been proposed in order to preserve cannabis monoterpene component in final CMEs.

Application of Polymeric Nanoparticles for CNS Targeted Zinc Delivery In Vivo.

A dyshomeostasis of zinc ions has been reported for many psychiatric and neurodegenerative disorders including schizophrenia, attention deficit hyperactivity disorder, depression, autism, Parkinson's and Alzheimer's disease. Furthermore, alterations in zinc-levels have been associated with seizures and traumatic brain injury. Thus, altering zinclevels within the brain is emerging as a new target for the prevention and treatment of psychiatric and neurological diseases. However, given the restriction of zinc uptake into the brain by the blood-brain barrier, methods for controlled regulation and manipulation of zinc concentrations within the brain are rare. Here, we performed in vivo studies investigating the possibility of brain targeted zinc delivery using zinc-loaded nanoparticles which are able to cross the blood-brain barrier. After injecting these nanoparticles, we analyzed the regional and time-dependent distribution of zinc and nanoparticles within the brain. Moreover, we evaluated whether the presence of zinc-loaded nanoparticles alters the expression of zinc sensitive genes and proteins such as metallothioneins and zinc transporters and quantified possible toxic effects. Our results show that zinc loaded g7 nanoparticles offer a promising approach as a novel non - invasive method to selectively enrich zinc in the brain within a small amount of time.

PLGA Nanoparticles Loaded Cerebrolysin: Studies on Their Preparation and Investigation of the Effect of Storage and Serum Stability with Reference to Traumatic Brain Injury.

Cerebrolysin is a peptide mixture able to ameliorate symptomatology and delay progression of neurological disorders such as Alzheimer's disease and dementia. The administration of this drug in humans presents several criticisms due to its short half-life, poor stability, and high doses needed to achieve the effect. This paper investigates the potential of polylactic-co-glycolide (PLGA) nanoparticles (NPs) as sustained release systems for iv administration of cerebrolysin in normal and brain injured rats. NPs were prepared by water-in-oil-in-water (w/o/w) double emulsion technique and characterized by light scattering for mean size and zeta potential and by scanning electron microscopy (SEM) for surface morphology. The NPs produced by double sonication under cooling at 60 W for 45 s, 12 mL of 1 % w:v of PVA, and 1:0.6 w:w drug/PLGA ratio (C-NPs4) displayed an adequate loading of drug (24 ± 1 mg/100 mg of NPs), zeta potential value (-13 mV), and average diameters (ranged from 250 to 330 nm) suitable to iv administration. SEM images suggested that cerebrolysin was molecularly dispersed into matricial systems and partially adhered to the NP surface. A biphasic release with an initial burst effect followed by sustained release over 24 h was observed. Long-term stability both at room and at low temperature of freeze-dried NPs was investigated. To gain deeper insight into NP stability after in vivo administration, the stability of the best NP formulation was also tested in serum. These PLGA NPs loaded with cerebrolysin were able to reduce brain pathology following traumatic brain injury. However, the size, the polydispersivity, and the surface properties of sample were significantly affected by the incubation time and the serum concentration.

In vitro evaluation of PLA nanoparticles containing a lipophilic drug in water-soluble or insoluble form.

Cloricromene (AD6), an anti-ischemic drug, is rapidly metabolised into a stable and active metabolite (cloricromene acid, AD6-acid) poorly soluble in water and less lipophilic than cloricromene. The aim of this study was to evaluate which of the two forms has more possibility to be efficiently encapsulated in nanoparticles based on poly(D,L-lactide) and prepared using the nanoprecipitation method. Increasing the theoretical loading of AD6, an increase in drug actual loading and in the mean particle size occurred, while no formation of nanoparticles was observed when the highest theoretical loading (50 mg) was employed. Changing the pH of the aqueous phase the drug content dramatically increased. However, at a pH value of 11 a more rapid hydrolysis of AD6 occurred. When AD6-acid was embedded in the nanoparticles, suitable results concerning both drug content and encapsulation efficiency were achieved. A good control in the release of AD6 from the AD6-loaded nanoparticles was observed while the liberation of AD6-acid from the AD6-acid-loaded nanoparticles was faster than the dissolution of the AD6-acid free. These results confirm that the most easy encapsulable form in nanoparticles is AD6-acid probably owing to its poor water solubility. Further studies will be carried out in order to evaluate if the increase in the liberation of AD6-acid by nanoencapsulation may have outcomes in its bioavaibility in vivo.

Characterization of the mechanism of interaction in ibuprofen-Eudragit RL100 coevaporates.

The present study is a preliminary exploration of the affinity between a carboxylic model drug, the nonsteroidal antiinflammatory agent ibuprofen (IBU) and Eudragit RL100 (RL) polymer. Due to the presence of a variable amount of quaternary ammonium groups in this matrix, physical and chemical interaction with the carboxylic drug can occur, which reinforces its scant mechanical dispersion in the polymer network and can ultimately affect its release profile in vitro and in vivo. To study these aspects, IBU was mixed at increasing weight ratios and in different chemical forms (free acid, sodium salt, and n-butyl ester), to investigate further the role of the carboxylic group in the interaction with the RL polymer. Therefore, IBU-RL solid dispersions (coevaporates) were obtained and fully characterized in the solid state through spectroscopic, calorimetric, and x-ray diffractometric analyses. The in vitro release pattern of the drug, in the different chemical states, was studied for the coevaporates, compared with drug-RL physical mixtures, along with drug adsorption profiles from aqueous solutions on the surface of the polymer granules.