[Fast measurement method based on near infrared spectroscopy in extraction process of Tianshu capsules].

Based on the near infrared spectroscopy, partial least square (PLS) method was used to respectively develop the quantitative calibration models to fast measure the contents of the total solid and ferulic acid in extraction process of Tianshu capsule extracts. The results showed that in the quantitative model of solid content, the correlation coefficients (R²) of calibration set and cross validation set were 0.967 301 and 0.947 726. The root-mean square error of calibration set (RMSEC) was 0.054 7 and root-mean square error of cross validation set (RMSECV) was 0.069 8. Besides, in the quantitative model of ferulic acid, the correlation coefficients (R²) of calibration set and cross validation set were 0.986 879 and 0.962 243. RMSEC was 1.402 6 and RMSECV was 2.400 2. When the established models were applied to on-line monitoring, the correlation coefficients of predicted results and measured values for total solid content and ferulic acid were 0.993 3 and 0.991 6; root-mean square error of predicted value (RMSEP) was 0.039 3 and 1.669 3 respectively; mean relative deviation of predicted value (RSEP) was 3.49% and 3.58%. The results indicated that the established models can be used to fast measure the contents of the total solid and ferulic acid in extraction process of Tianshu capsule extracts.

[Impurity removal technology of Tongan injection in liquid preparation process].

In order to effectively remove the invalid impurities in Tongan injection, optimize the optimal parameters of the impurity removal technology of liquid mixing process, in this paper, taking Tongan injection as the research object, with the contents of celandine alkali, and sinomenine, solids reduction efficiency, and related substances inspection as the evaluation indexes, the removal of impurities and related substances by the combined process of refrigeration, coction and activated carbon adsorption were investigated, the feasibility of the impurity removal method was definited and the process parameters were optimized. The optimized process parameters were as follows: refrigerated for 36 h, boiled for 15 min, activated carbon dosage of 0.3%, temperature 100 degrees C, adsorption time 10 min. It can effectively remove the tannin, and other impurities, thus ensure the quality and safety of products.

[Optimization of one-step pelletization technology of Jiuwei Xifeng granules by response surface methodology].

Using the qualified rates of particles as the evaluation indexes, the impact tactors of one-step pelletization technology of Jiuwei Xifeng granules were selected from six factors by the Plackett-Burman experimental design and the levels of non-significant factors were identified. According to the Plackett-Burman experimental design, choosing the qualified rates of particles and angle of repose as the evaluation indexes, three levels of the three factors were selected by Box-Behnken of central composite design to optimize the experimental. The best conditions were as follows: the fluid extract was sprayed with frequency of 29 r . min-1, inlet air temperature was 90 °C, the frequency of fan was 34 Hz. Under the response surface methodology optimized scheme, the average experimental results are similar to the predicted values, and surface methodology could be used in the optimization of one-step pelletization for Chinese materia medica.