RESUMO
A GC-MS fingerprint of rosemary oil and an UPLC fingerprint of non-volatile compounds of rosemary were established. Sixty-three kinds of volatile compounds and thirty-eight kinds of non-volatile compounds were identified tentatively using GC-MS and UPLC-Q-TOF-MS, respectively, and most of them are flavonoids, oxygenated monoterpenes, and diterpenoids, etc. According to multivariate data analysis, chemical differences existed among commercial rosemary samples, for example, the essential oil of imported rosemary sample belongs to Morocco/Tunisian type and the one of domestic sample belongs to Spanish type. The results of principal components analysis and partial least squares discriminant analysis showed that the imported and domestic rosemary samples were classified into two groups and fourteen components including eucalyptol, (+)-α-pinene, and carnosic acid, were found as the discrimination markers. In comparison with imported rosemary, it can be found that the contents of ten markers such as (+)-α-pinene, o-cymene, and carnosic acid were higher, nonetheless, lower contents for the other markers, in those domestic rosemary samples. Moreover, rosmarinic acid, an important bioactive component in rosemary extract, extensively varied among different samples, indicating that the quality evaluation of rosemary should be concerned.
Assuntos
Compostos Fitoquímicos/análise , Óleos de Plantas/análise , Rosmarinus/química , Cromatografia Líquida de Alta Pressão , Cromatografia Gasosa-Espectrometria de Massas , Análise MultivariadaRESUMO
Objective: To optimize the extraction condition of polysaccharide from Schisandra chinensis. Aqueous two-phase extractionï¼ ATPEï¼ method was used, based on Box-Behnken design with Response surface methodologyï¼ BBD-RSMï¼. Methods: solvent volume,K2HPO4 and PEG6000 were selected as the investigation factors by the single-factor experiment, and the overall desirabilityï¼ ODï¼of phase volume ratio, partition coefficient and extraction rates were the reponse value. BBD-RSM was used to optimize the extraction process. . Results: The optimal parameters were as follows,the solvent volume was 5 m L,the addition amount of K2HPO4 was 1. 0 g, the addition amount of PEG6000 was 1. 8 g and centrifugation time was 9 min, which indicated that the model had a good predictability. The predicted value was 0. 950,and the deviation between observed and predicted values was 3. 94% Conclusion: The ATPE technology is easy to operate and cost-effective for the extraction of polysaccharides from Schisandra chinensis.