RESUMO
The objective of this study was to reduce the stockpile of steel slag, which is a solid waste generated in the steelmaking process, and promote the resource utilization of steel slag powder (SSP) in construction projects. Experimental research was conducted on SSP and fly ash (FA) as supplementary cementitious materials. Composite cement paste samples were prepared to investigate the effects of the water-to-binder ratio and cement-substitution rate on the macroscopic mechanical properties, including the setting time, fluidity, flexural strength, and compressive strength of the prepared paste. The mineral composition in the raw materials was measured using X-ray diffraction (XRD), and a micro-morphological and structural analysis of the hydrated cementitious material samples was performed using scanning electron microscopy (SEM); the SEM and Image Pro Plus (IPP) image analysis techniques were combined for a quantitative analysis of the microstructure. The results showed that the addition of FA and SSP delayed the hydration of cement, thereby improving the flowability of the composite paste. Under the same curing age and cement substitution rate, the sample strength decreased with increasing water-to-binder ratio. Under the same water-to-binder ratio and curing age, the variations in the flexural and compressive strengths of the SSP group samples were inconsistent in the early and later stages, and the sample group with 20% SSP exhibited optimal mechanical strength in the later stage. The microscopic results showed that the needle-like AFt crystals in the hydrated pores decreased in number with the increase in the SSP content. The hydration products of the FA-SSP admixture, such as C-S-H gel and RO phase, acted as pore fillers in alkaline environments. When the water-to-binder ratio was 0.4 and the FA-to-SSP ratio was 1:1 to replace 40% cement, the performance of the hardened cement paste was the best among all the test groups containing both FA and SSP. This study provides a theoretical basis for the practical application of SSP and FA as cementitious materials in construction-related fields.
RESUMO
BACKGROUND: Genic male sterility (GMS) line is an important approach to utilize heterosis in Brassica rapa, one of the most widely cultivated vegetable crops in Northeast Asia. However, the molecular genetic mechanisms of GMS remain to be largely unknown. RESULTS: Detailed phenotypic observation of 'Bcajh97-01A/B', a B. rapa genic male sterile AB line in this study revealed that the aberrant meiotic cytokinesis and premature tapetal programmed cell death occurring in the sterile line ultimately resulted in microspore degeneration and pollen wall defect. Further gene expression profile of the sterile and fertile floral buds of 'Bcajh97-01A/B' at five typical developmental stages during pollen development supported the result of phenotypic observation and identified stage-specific genes associated with the main events associated with pollen wall development, including tapetum development or functioning, callose metabolism, pollen exine formation and cell wall modification. Additionally, by using ChIP-sequencing, the genomic and gene-level distribution of trimethylated histone H3 lysine 4 (H3K4) and H3K27 were mapped on the fertile floral buds, and a great deal of pollen development-associated genes that were covalently modified by H3K4me3 and H3K27me3 were identified. CONCLUSIONS: Our study provids a deeper understanding into the gene expression and regulation network during pollen development and pollen wall formation in B. rapa, and enabled the identification of a set of candidate genes for further functional annotation.