Proton Nuclear Magnetic Resonance Spectroscopy Analysis of Mixtures of Chlorhexidine with Different Oxidizing Agents Activated by Photon-Induced Photoacoustic Streaming for Root Canal Irrigation.

Objective: The aim of this in vitro study was to investigate the possible interactions between photon-induced photoacoustic streaming (PIPS™)-activated oxidizing agents and 2% chlorhexidine digluconate. Background data: There is no information about the safety of laser-activated oxidizing agents in combination usage with chlorhexidine gluconate. Materials and methods: Groups were designed as follows G1: 98% para-chloroaniline (PCA); G2: 2% chlorhexidine (CHX); G3: 5.25% sodium hypochlorite (NaOCl) +2% CHX; G4: 5.25% NaOCl (30 sec PIPS activated) +2% CHX; G5: 5.25% NaOCl (60 sec PIPS activated) +2% CHX; G6: 3.5% chlorine dioxide (ClO2) + 2% CHX; G7: 3.5% (ClO2) (30 sec PIPS activated) +2% CHX; G8: 3.5% (ClO2) (60 sec PIPS activated) +2% CHX. The laser-irrigation protocol was performed with an erbium:yttrium-aluminum-garnet laser with a wavelength of 2940 nm equipped with a 140 mm long endodontic fiber tip (PIPS) using 10 mJ at 15 Hz (0.15 W), per pulse operating outputs. Groups were analyzed with proton nuclear magnetic resonance spectroscopy, using PCA as an internal standard. Results: No free PCA was formed in any groups of mixtures or after PIPS activation. Conclusions: Mixing of 3.5% ClO2 and 2% CHX does not form bulky precipitates, unlike the mixture NaOCl + CHX. PIPS activation does not cause changes in reactions of oxidizing agents.

How to improve root canal filling in teeth subjected to radiation therapy for cancer.

The aim of this study was to evaluate the influence of radiation therapy on root canal sealer push-out bond strength (BS) to dentin and the sealer/dentin interface after different final irrigation solutions (NaOCl, EDTA, and chitosan). Sixty-four maxillary canines were distributed into two groups (n=30): non-irradiated and irradiated with 60 Gy. Canals were prepared with Reciproc-R50 and subdivided (n=10) for final irrigation (NaOCl, EDTA, chitosan) and filled. Three dentin slices were obtained from each root third. The first slice of each third was selected for BS evaluation, and the failure mode was determined by stereomicroscopy. SEM analysis of the sealer-dentin interface was performed in the remaining slices. Two-way ANOVA and Tukey's tests (α=0.05) were used. Lower BS (P<0.0001) was obtained after irradiation (2.07±0.79 MPa), regardless of the final irrigation solution used. The NaOCl group (P<0.001) had the lowest BS in the irradiated (1.68±0.72) and non-irradiated (2.39±0.89) groups, whereas the EDTA (irradiated: 2.14±0.77 and non-irradiated: 3.92±1.54) and chitosan (irradiated: 2.37±0.73 and non-irradiated: 3.51±1.47) groups demonstrated a higher BS (P<0.05). The highest values were observed in the coronal third (3.17±1.38) when compared to the middle (2.74±1.36) and apical ones (2.09±0.97)(P<0.0001). There were more cohesive failures and more gaps in irradiated specimens, regardless of the final solution. The present study showed that radiation was associated with a decrease in BS, regardless of the final solution used, whereas chitosan increased BS in teeth subjected to radiation therapy.

How to improve root canal filling in teeth subjected to radiation therapy for cancer

Abstract The aim of this study was to evaluate the influence of radiation therapy on root canal sealer push-out bond strength (BS) to dentin and the sealer/dentin interface after different final irrigation solutions (NaOCl, EDTA, and chitosan). Sixty-four maxillary canines were distributed into two groups (n=30): non-irradiated and irradiated with 60 Gy. Canals were prepared with Reciproc-R50 and subdivided (n=10) for final irrigation (NaOCl, EDTA, chitosan) and filled. Three dentin slices were obtained from each root third. The first slice of each third was selected for BS evaluation, and the failure mode was determined by stereomicroscopy. SEM analysis of the sealer-dentin interface was performed in the remaining slices. Two-way ANOVA and Tukey's tests (α=0.05) were used. Lower BS (P<0.0001) was obtained after irradiation (2.07±0.79 MPa), regardless of the final irrigation solution used. The NaOCl group (P<0.001) had the lowest BS in the irradiated (1.68±0.72) and non-irradiated (2.39±0.89) groups, whereas the EDTA (irradiated: 2.14±0.77 and non-irradiated: 3.92±1.54) and chitosan (irradiated: 2.37±0.73 and non-irradiated: 3.51±1.47) groups demonstrated a higher BS (P<0.05). The highest values were observed in the coronal third (3.17±1.38) when compared to the middle (2.74±1.36) and apical ones (2.09±0.97)(P<0.0001). There were more cohesive failures and more gaps in irradiated specimens, regardless of the final solution. The present study showed that radiation was associated with a decrease in BS, regardless of the final solution used, whereas chitosan increased BS in teeth subjected to radiation therapy.

Activation of ethylenediaminetetraacetic acid by a 940 nm diode laser for enhanced removal of smear layer.

Laser enhancement of ethylenediaminetetraacetic acid with cetrimide (EDTAC) has previously been shown to increase removal of smear layer, for middle-infrared erbium lasers. This study evaluated the efficiency of EDTAC activation using a near-infrared-pulsed 940 nm laser delivered by plain fibre tips into 15% EDTAC or 3% hydrogen peroxide. Root canals in 4 groups of 10 single roots were prepared using rotary files, with controls for the presence and absence of smear layer. After laser treatment (80 mJ pulse(-1) , 50 Hz, 6 cycles of 10 s), roots were split and the apical, middle and coronal thirds of the canal were examined using scanning electron microscopy, with the area of dentine tubules determined by a validated quantitative image analysis method. Lasing EDTAC considerably improved smear layer removal, while lasing into peroxide gave minimal smear layer removal. The laser protocol used was more effective for smear layer removal than the 'gold standard' protocol using EDTAC with sodium hypochlorite (NaOCl). In addition, lasers may also provide a benefit through photothermal disinfection. Further research is needed to optimise irrigant activation protocols using near-infrared diode lasers of other wavelengths.

Effect of laser-activated irrigation of 1320-nanometer Nd:YAG laser on sealer penetration in curved root canals.

INTRODUCTION: The purpose of this study was to investigate the efficacy of laser-activated irrigation (LAI) of 1320-nm neodymium-doped:yttrium-aluminum-garnet (Nd:YAG) laser on sealer penetration into dentinal tubules in the presence of 5.25% sodium hypochlorite (NaOCl) or 17% ethylenediaminetetraacetic acid (EDTA). METHODS: The curved root canals (>20°) from 63 extracted human molars (negative control, n = 3) were prepared to size #30.06 with NaOCl irrigation. Teeth were divided into 4 groups (n = 15) as follows: group N, NaOCl irrigation without LAI; group E, EDTA irrigation without LAI; group NL, LAI with NaOCl; group EL, LAI with EDTA. In all groups, the laser fiber was inserted and withdrawn 4 times for 5 seconds each. Teeth were obturated with gutta-percha and fluorescent-labeled sealer. Transverse sections at 2 and 5 mm from root apex were examined with confocal laser scanning microscopy, and the percentage of sealer penetration into dentinal tubules was measured. RESULTS: Groups E, NL, and EL showed higher percentage of sealer penetration than group N (P < .05). With NaOCl as irrigant, LAI (group NL) resulted in significantly higher amount of sealer penetration than nonactivated group (group N) in both levels (P < .05). However, with EDTA, no significant differences in sealer penetration were observed between the laser-activated group (group EL) and its nonactivated counterpart (group E) in both levels (P > .05). CONCLUSIONS: The 1320-nm Nd:YAG laser activation with either NaOCl or EDTA was much better than NaOCl irrigation alone and as effective as EDTA final flush for sealer penetration into dentinal tubules. Additional use of laser with EDTA did not improve the quality of obturation in the curved canals.

Disinfection of root canals with photon-initiated photoacoustic streaming.

INTRODUCTION: This study set out to compare the efficacy of laser-activated and ultrasonically activated root canal disinfection with conventional irrigation, specifically its ability to remove bacterial film formed on root canal walls. METHODS: Seventy human premolars were shaped to an apical size #20, taper .07, sterilized, and contaminated in situ with oral bacteria for 1 week and incubated for 2 more weeks. Irrigation was done with 6% NaOCl (group 1), NaOCl ultrasonically activated with blunt inserts (group 2), or a pulsed erbium:YAG laser at nonablative settings (group 3) for a total of 60 seconds each. Positive and negative controls were also included. Aerobic bacterial sampling was performed, and the incidence of positive samples after 24 and 48 hours as well as bacterial counts (colony-forming units) were determined. Fixed and demineralized sections 1 mm and 4 mm off the apex were Brown-Brenn stained and assessed for remaining intracanal bacteria/biofilm and dentinal tubule penetration. RESULTS: All 3 canal disinfection protocols significantly reduced bacterial counts (P < .001). None of the 3 techniques predictably generated negative samples, but laser-activated disinfection was superior to the other 2 techniques in this aspect (P < .05). Histologic sections showed variable remaining bacterial presence in dentinal tubules at the 4-mm level and significantly less bacterial biofilm/necrotic tissue remaining at the 1-mm level after laser-activated irrigation (P < .05). CONCLUSIONS: Under the conditions of this combined in situ/in vitro study, activated disinfection did not completely remove bacteria from the apical root canal third and infected dentinal tubules. However, the fact that laser activation generated more negative bacterial samples and left less apical bacteria/biofilm than ultrasonic activation warrants further investigation.

Laser activation of endodontic irrigants with improved conical laser fiber tips for removing smear layer in the apical third of the root canal.

With a tube etching process, conical-ended optical fibers for middle infrared lasers that have lateral emissions can be produced, a feature of benefit for delivering laser energy onto the root canal walls. This study examined the ability of these improved laser tips when Er:YAG and Er,Cr:YSGG lasers were used in root canals in which thick smear layers had been created intentionally to provide a challenge for the laser system. Smear layer was assessed from scanning electron microscopy images with an objective digital method. Lasing improved the action of ethylene diamine tetraacetic acid with cetavlon (EDTAC) in removing smear layer. Conical fibers performed better than plain fibers, but there was no difference in performance between the 2 laser systems when matched for all other parameters. These results provide a "proof of concept" for lateral emitting fibers for endodontic procedures and illustrate the novel contribution of lasing to the action of EDTAC in dissolving smear layer.