Intracellular uranium distribution: Comparison of cryogenic fixation versus chemical fixation methods for SIMS analysis.

Localization of uranium within cells is mandatory for the comprehension of its cellular mechanism of toxicity. Secondary Ion Mass Spectrometry (SIMS) has recently shown its interest to detect and localize uranium at very low levels within the cells. This technique requires a specific sample preparation similar to the one used for Transmission Electronic Microscopy, achieved by implementing different chemical treatments to preserve as much as possible the living configuration uranium distribution into the observed sample. This study aims to compare the bioaccumulation sites of uranium within liver or kidney cells after chemical fixation and cryomethods preparations of the samples: SIMS analysis of theses samples show the localization of uranium soluble forms in the cell cytoplasm and nucleus with a more homogenous distribution when using cryopreparation probably due to the diffusible portion of uranium inside the cytoplasm.

Impact of the uranium (VI) speciation in mineralised urines on its extraction by calix[6]arene bearing hydroxamic groups used in chromatography columns.

Actinides determination in urine samples is part of the analyses performed to monitor internal contamination in case of an accident or a terrorist attack involving nuclear matter. Mineralisation is the first step of any of these analyses. It aims at reducing the sample volume and at destroying all organic compounds present. The mineralisation protocol is usually based on a wet ashing step, followed by actinides co-precipitation and a furnace ashing step, before redissolution and the quantification of the actinides by the appropriate techniques. Amongst the existing methods to perform the actinides co-precipitation, alkali-earth (typically calcium) precipitation is widely used. In the present work, the extraction of uranium(VI), plutonium(IV) and americium(III) from the redissolution solutions (called "mineralised urines") on calix[6]arene columns bearing hydroxamic groups was investigated as such an extraction is a necessary step before their determination by ICP-MS or alpha spectrometry. Difficulties were encountered in the transfer of uranium(VI) from raw to mineralised urines, with yield of transfer ranging between 0% and 85%, compared to about 90% for Pu and Am, depending on the starting raw urines. To understand the origin of such a difficulty, the speciation of uranium (VI) in mineralised urines was investigated by computer simulation using the MEDUSA software and the associated HYDRA database, compiled with recently published data. These calculations showed that the presence of phosphates in the "mineralised urines" leads to the formation of strong uranyl-phosphate complexes (such as UO2HPO4) which compete with the uranium (VI) extraction by the calix[6]arene bearing hydroxamic groups. The extraction constant of uranium (VI) by calix[6]arene bearing hydroxamic groups was determined in a 0.04 mol L(-1) sodium nitrate solution (logK=4.86±0.03) and implemented in an extraction model taking into account the speciation in the aqueous phase. This model allowed to simulate satisfactorily the experimental uranium extraction data and to support the preliminary conclusions about the role of the phosphates present in mineralised urines. These calculations also showed that the phosphate/calcium ratio is a key parameter as far as the efficiency of the uranium (VI) extraction by the calix[6]arene columns is concerned. It predicted that the addition of CaCl2 in mineralised urines would release uranium (VI) from phosphates by forming calcium (II)-phosphate complexes and thus facilitate the uranium (VI) extraction on calix[6]arene columns. These predictions were confirmed experimentally as the addition of 0.1 mol L(-1) CaCl2 to a mineralised urine containing naturally a high concentration of phosphate (typically 0.04 mol L(-1)) significantly increased the percentage of uranium (VI) extraction on the calix[6]arene columns.

Development of two mobile laboratories for a routine and accident monitoring of internal contamination.

To provide medical surveillance of workers exposed to risk of internal contamination, IRSN (French Institute for Radiological Protection and Nuclear Safety) has developed two mobile laboratories for on-site monitoring. The laboratories are unique in Europe. They meet the new radiation protection requirements for nuclear medicine departments and radiological emergency response. Details of the design, calibration procedures and performance characteristics of these systems in measurements of various types of organs (thyroid, lung and whole body) are described. The sensitivity of the measurements is very close to that achieved in a heavily shielded stationary laboratory.

Sector field inductively coupled plasma mass spectrometry, another tool for plutonium isotopes and plutonium isotope ratios determination in environmental matrices.

The transfer of radio nuclides into the different compartments of the environment are widely studied and leads to the elaboration of transfer models in order to evaluate potential impact onto the environment and humans. Accurate experimental data are needed to validate these models for all types of matrices (air, water, sediments, soils, biota and food...). Among these radionuclides, 238Pu, 239Pu, 240Pu and 241Pu, are often mentioned. They have been released into the environment by nuclear weapon tests, nuclear facilities, reactors or satellite accidents. These different sources have different 240Pu/239Pu ratios and therefore this ratio is used to provide information on the source of contamination into the environment. The most conventional analytical tools used for plutonium isotope determination are liquid scintillation and alpha spectrometry, and thermal ionisation mass spectrometry (TIMS) is still considered as the primary method for determination of plutonium isotope ratios. During the last decade, mass spectrometers equipped with plasma ion sources and sector field analysers were developed and can offer now another alternative method for the accurate determination of isotope content and ratios of long-lived radionuclides in environmental samples. This paper presents and discusses the results obtained for 239Pu, 240Pu and 241Pu content and isotope ratios by sector field ICP-MS in different environmental matrices.

Determination of 241Am in sediments by isotope dilution high resolution inductively coupled plasma mass spectrometry (ID HR ICP-MS).

Trace levels (pg kg(-1)) of 241Am in sediments were determined by isotope dilution high resolution inductively coupled plasma mass spectrometry (ID HR ICP-MS) using a microconcentric nebulizer. 241Am was isolated from major elements like Ca and Fe by different selective precipitations. In further steps. Am was first separated from other transuranic elements and purified by anion exchange and extraction chromatography prior to the mass spectrometric measurements. The ID HR ICP-MS results are compared with isotope dilution alpha spectrometry.