RESUMEN
High altitude (alpine) lakes are efficient sentinels of environmental processes, including local pollution and long-range atmospheric transfer, because these lakes are highly vulnerable to ongoing climate changes and increasing anthropogenic pressure. Towards improving the knowledge of trace element geochemistry in the water column of alpine lakes, we assessed 64 physico-chemical parameters, including macro- and micronutrients, major and trace element concentrations in the water column of 18 lakes in the Pyrenees, located along the border between France and Spain. Lake depth, morphology, retention time and watershed rock lithology did not exhibit sizable impact on major and trace element concentrations in the water column. However, acidic (pH = 4.7 ± 0.2) lakes were distinctly different from circumneutral lakes (pH = 6.8 ± 0.5) as they exhibited >10 times higher concentrations of SO42- and trace metals (Fe, Mn, Zn, Cd, Pb, Co, Ni, Be, Al, Ga and REEs). While some of these elements clearly mark the presence of sulphide-rich minerals within the watershed (Fe, Zn, Cd and Pb), the increased mobility of lithogenic elements (Be, Al, Ga and REEs) in acidic lakes may reflect the leaching of these elements from silicate dust derived from atmospheric deposits or surrounding granites. At the same time, compared to circumneutral lakes, acidic lake water displayed lower concentrations of dissolved oxyanions (As, Mo, V, B and W) and elevated SO42- concentrations. The latter could lead to efficient Ba removal from the water column. The exploitation of metal ores within the watershed of three lakes clearly impacted high Zn and Cd concentrations observed in their water column, despite two of these lakes not being acidic. We conclude that local impacts have a greater effect on the water column than long-range atmospheric inputs and that dissolved trace element concentration measurements can be used for revealing sulphide-rich minerals or acid mine drainage within the lakes' watershed.
Asunto(s)
Metales Pesados , Oligoelementos , Contaminantes Químicos del Agua , Oligoelementos/análisis , Lagos , Agua , Altitud , Cadmio , Plomo , Minerales , Sulfuros , Monitoreo del Ambiente , Contaminantes Químicos del Agua/análisis , Metales Pesados/análisisRESUMEN
High-altitude Pyrenean lakes are ecosystems far from local pollution sources, and thus they are particularly sensitive to the atmospheric deposition of metals and metalloids. This study aims to quantify the effect of human activity in 18 lakes located in both side of the France-Spain frontier. Sediment cores were collected in summer 2013, sampled at a 1cm resolution and the concentration of 24 elements was measured by ICP-MS. Statistic and chemometric analysis of the results highlights the influence of the geographical position and lithogenic features of each lake basin on trapping pollutants. More than the 80% of the lakes showed values of enrichment factor (EF) above 2 for at least one of the elements investigated in at least one core interval, which corroborates the existence of historical anthropogenic inputs of elements in the studied area. The results demonstrate the natural origin of As and Ti in Pyrenees, together with the significant anthropogenic inputs of Cd, Pb, Sb and Sn from ancient times. The data set points mining activities as the main historical source of pollution and illustrate the large impact of the industrial revolution. The regional variability could reflect also differential long-range transport, followed by dry or wet deposition.
Asunto(s)
Monitoreo del Ambiente , Lagos , Metales , Contaminantes Químicos del Agua , Humanos , Altitud , Ecosistema , Monitoreo del Ambiente/métodos , Sedimentos Geológicos , Lagos/química , Metaloides/análisis , Metales/análisis , Metales Pesados/análisis , Contaminantes Químicos del Agua/análisis , España , FranciaRESUMEN
Analysis of the kinetics of aqueous phenol oxidation by a sono-Fenton process reveals that the via involving ortho-substituted intermediates prevails: catechol (25.0%), hydroquinone (7.7%) and resorcinol (0.6%). During the oxidation, water rapidly acquires color that reaches its maximum intensity at the maximum concentration of p-benzoquinone. Turbidity formation occurs at a slower rate. Oxidant dosage determines the nature of the intermediates, being trihydroxylated benzenes (pyrogallol, hydroxyhydroquinone) and muconic acid the main precursors causing turbidity. It is found that the concentration of iron species and ultrasonic waves affects the intensity of the turbidity. The pathway of (hydro)peroxo-iron(II) complexes formation is proposed. Operating with 20.0-27.8mgFe2+/kW rates leads to formation of (hydro)peroxo-iron(II) complexes, which induce high turbidity levels. These species would dissociate into ZZ-muconic acid and ferrous ions. Applying relationships around 13.9mgFe2+/kW, the formation of (hydro)peroxo-iron(III) complexes would occur, which could react with carboxylic acids (2,5-dioxo-3-hexenedioic acid). That reaction induces turbidity slower. This is due to the organic substrate reacting with two molecules of the (hydro)peroxo complex. Therefore, it is necessary to accelerate the iron regeneration, intensifying the ultrasonic irradiation. Afterwards, this complex would dissociate into maleic acid and ferric ions.
RESUMEN
This work aims at establishing the contribution of the iron species to the turbidity of phenol solutions oxidized with photo-Fenton technology. During oxidation, turbidity increases linearly with time till a maximum value, according to a formation rate that shows a dependence of second order with respect to the catalyst concentration. Next, the decrease in turbidity shows the evolution of second-order kinetics, where the kinetics constant is inversely proportional to the dosage of iron, of order 0.7. The concentration of iron species is analysed at the point of maximum turbidity, as a function of the total amount of iron. Then, it is found that using dosages FeT=0-15.0â mg/L, the majority iron species was found to be ferrous ions, indicating that its concentration increases linearly with the dosage of total iron. This result may indicate that the photo-reaction of ferric ion occurs leading to the regeneration of ferrous ion. The results, obtained by operating with initial dosages FeT=15.0 and 25.0â mg/L, suggest that ferrous ion concentration decreases while ferric ion concentration increases in a complementary manner. This fact could be explained as a regeneration cycle of the iron species. The observed turbidity is generated due to the iron being added as a catalyst and the organic matter present in the system. Later, it was found that at the point of maximum turbidity, the concentration of ferrous ions is inversely proportional to the concentration of phenol and its dihydroxylated intermediates.
Asunto(s)
Peróxido de Hidrógeno/química , Hierro/química , Modelos Químicos , Oxígeno/química , Fenol/química , Simulación por Computador , Peróxido de Hidrógeno/efectos de la radiación , Hierro/efectos de la radiación , Cinética , Luz , Nefelometría y Turbidimetría/métodos , Oxidación-Reducción/efectos de la radiación , Soluciones , Viscosidad , Contaminantes Químicos del Agua/química , Contaminantes Químicos del Agua/aislamiento & purificaciónRESUMEN
Turbidity presented by phenol solutions oxidized with Fenton reagent shows the tendency of a first order intermediate kinetics. Thus, turbidity can be considered a representative parameter of the presence of intermediate oxidation species, which are generated along the decomposition of toxic and reluctant contaminants, such as phenol. Moreover, that parameter presents a linear dependence with the catalyst dosage, but is also determined by the initial contaminant load. When analyzing the oxidation mechanism of phenol, it is found that the maximum turbidity occurs when the treatment is carried out at oxidant to phenol molar ratios R = 4.0. These oxidation conditions correspond to the presence of a reaction mixture mainly composed of dihydroxylated rings, precursors of the muconic acid formation. The oxidation via "para" comprises the formation reactions of charge transfer complexes (quinhydrone), between the para-dihydroxylated intermediates (hydroquinone) and the para-substituted quinones (p-benzoquinone), which are quite unstable and reactive species, quickly decomposed into hydroxyhydroquinones. Working with oxidant ratios up to R = 6.0, the maximum observed value of turbidity in the oxidized solutions is kept almost constant. It is found that, in these conditions, the pyrogallol formation is maximal, what is generated through the degradation of ortho-species (catechol and ortho-benzoquinone) and meta-substituted (resorcinol). Operating with ratios over R = 6.0, these intermediates are decomposed into biodegradable acids, generating lower turbidity in the solution. Then, the residual turbidity is a function of the molar ratio of the ferrous ions vs. moles of oxidant utilized in the essays, that lets to estimate the stoichiometric dosage of catalyst as 20 mg/L at pH = 3.0, whereas operating in stoichiometric conditions, R = 14.0, the residual turbidity of water results almost null.
Asunto(s)
Peróxido de Hidrógeno/química , Hierro/química , Fenol/química , Eliminación de Residuos Líquidos/métodos , Contaminantes Químicos del Agua/química , Purificación del Agua/métodos , Catálisis , Cromatografía Líquida de Alta Presión , Concentración de Iones de Hidrógeno , Cinética , Nefelometría y Turbidimetría/métodos , Oxidantes/química , Oxidación-Reducción , Quinonas/química , Espectrofotometría Ultravioleta , TemperaturaRESUMEN
The BIODEP model in terms of atmosphere-lake interactions was developed. The model was applied to an oligotrophic, dimictic high altitude lake (Lake Redo, Pyrenees) for a range of polychlorinated biphenyl (PCB) congeners. High altitude lakes, which receive their contaminant inputs uniquely from the atmosphere through long-range atmospheric transport, provide ideal controlled environments for the study of the interactions between atmospheric depositional and water column biogeochemical processes. The BIODEP model was able to predict dissolved water concentrations and PCB accumulation in the lake sediment within a factor of 2. This shows that the BIODEP model captures the essential processes driving the sink of POPs in high altitude lakes and that POP occurrence in the lake is driven by direct atmospheric inputs with limited influence from the watershed. An important seasonal variability in water column concentrations is predicted which should have important implications in sampling strategies. Furthermore, it is shown that diffusive air-water exchange dominated the PCB dynamics in the lake, especially for the less chlorinated biphenyls.