Integrated Membrane Process for the Treatment and Reuse of Residual Table Olive Fermentation Brine and Anaerobically Digested Sludge Centrate.

Management of wastewater is a major challenge nowadays, due to increasing water demand, growing population and more stringent regulations on water quality. Wastewaters from food conservation are especially difficult to treat, since they have high salinity and high organic matter concentration. The aim of this work is the treatment of the effluent from a table olive fermentation process (FTOP) with the aim of reusing it once the organic matter is separated. The process proposed in this work consists of the following membrane-based technologies: Ultrafiltration (UF) (UP005, Microdyn Nadir), Forward Osmosis (FO) (Osmen2521, Hydration Technology Innovation) and Nanofiltration (NF) (NF245, Dow). The FO process was implemented to reduce the salinity entering the NF process, using the FTOP as draw solution and, at the same time, to concentrate the centrate produced in the sludge treatment of a municipal wastewater treatment plant with the aim of obtaining a stream enriched in nutrients. The UF step achieved the elimination of 50% of the chemical oxygen demand of the FTOP. The UF permeate was pumped to the FO system reducing the volume of the anaerobically digested sludge centrate (ADSC) by a factor of 3 in 6.5 h. Finally, the ultrafiltrated FTOP diluted by FO was subjected to NF. The transmembrane pressure needed in the NF stage was 40% lower than that required if the ultrafiltration permeate was directly nanofiltered. By means of the integrated process, the concentration of organic matter and phenolic compounds in the FTOP decreased by 97%. Therefore, the proposed process was able to obtain a treated brine that could be reused in other processes and simultaneously to concentrate a stream, such as the ADSC.

Nanofiltration as tertiary treatment method for removing trace pharmaceutically active compounds in wastewater from wastewater treatment plants.

The ever-increasing occurrence and persistence of pharmaceutically active compounds (PhACs) in soils, sediments, drinking water supplies and wastewater effluents are a matter of serious environmental concern for governments and researchers worldwide. Nanofiltration as tertiary treatment method can be a viable and practical tool to remove these pollutants from aquatic environments. However, organic matter present in water sources can foul the membrane surface during operation, thus being potentially able to affect the membrane performance. Therefore, fouling mechanisms could heavily influence on the removal efficiencies. The purpose of this study was to investigate the implementation of three nanofiltration membranes (TFC-SR2, NF-270 and MPS-34) and to study both the rejection of trace PhACs and the fouling mechanisms for each membrane as a function of feed solution pH. Fouling mechanisms were predicted by Hermia's model adapted to cross-flow configurations. Results demonstrated that higher removals were obtained at slightly alkaline pH, especially for anionic trace PhACs. At the same conditions, more severe fouling was observed, which resulted in strong flux declines and an increase in hydrophobicity. This indicates that the attached organic matter on the membrane surface acts as a secondary selective barrier for separation.