Impact of Compensating Curves on Mastication of Complete Denture Wearers: A Randomised Triple-Blind Clinical Trial.

INTRODUCTION: The application of occlusal concepts in prosthodontics is still under debate.This study assessed the impact of compensating curves on the comminution of complete denture wearers. METHODS: Seven edentulous subjects, aged 64.6 ± 2.0 years, were rehabilitated with new muco-supported complete dentures and tested in two occlusal plane settings: with and without compensating curves. A randomised triple-blind clinical trial was conducted, considering one-week and one-month as adaptation periods for dentures. After each trial, the subjects were crossed over to their respective groups. One-week was also chosen as the washout period, and after that, the subjects were re-examined. The masticatory performance and swallowing threshold were determined while chewing Optocal test food. The multiple sieve method was used for fractionation and granulometry. RESULTS: During the masticatory performance and swallowing threshold estimates, no differences were found between the median particle sizes obtained with the both occlusal plane conditions (P ⟩ 0.05). However, the swallowing threshold improved after one month, resulting in smaller particle sizes. Moreover, the chewing rates for the both test foods were also increased (P ⟨ 0.05). CONCLUSIONS: These findings suggest that the compensating curves did not have an impact on the masticatory function of subjects wearing complete dentures.

Occlusal Loading Effect on Stress Distribution of Endodontically Treated Teeth: Finite Element Analysis Study.

AIM: Evaluate the influence of occlusal loading on the stress distribution of endodontically treated teeth after root canal preparation with different file's sizes and tapers by means of finite element analysis. METHODOLOGY: Seven three-dimensional models of a single-rooted, single-canal lower second premolar were established, one healthy control and six endodontically treated and restored models. The shape of root canal preparations followed file configurations 30/.05, 30/.09, 35/.04, 35/.06, 40/.04, and 40/.06. Von- Mises equivalent stresses were calculated by applying 30 N, 90 N and 270 N loads to the buccal cusp tip, each one at 90º, 45º and 20º angles from the occlusal plane simulating occlusion, dental interference and laterality, respectively. RESULTS: 45º loading was more prone to formation of higher stress values. The simulation of occlusion and laterality resulted in maximum stress areas located at the inner side of the root curvature, while under occlusal interference they were on the lingual surface over the tooth's long axis. CONCLUSIONS: The angulation of occlusal loading and magnitude were determinants for stress distribution on dental structure. Both variations of size and taper were not determinants for the increase in the maximum stress areas.