Qualitative and quantitative analysis of formaldehyde in samples of hair straighteners and suitability of the labels

Formaldehyde is an active compound, irregularly used in hair products, that has the property of straighten and waterproofing the wires. However, it is highly toxic and can stimulate dermatological hypersensitivity and cancer. In this context it is of fundamental importance the inspection of these products that can be used in safe conditions for the consumer, without formaldehyde in concentrations higher than the allowed. Thus, the aim of this research was the qualitative and quantitative identification formaldehyde in samples of hair straighteners that was obtained by donation in the beauty salons of Araraquara-SP. In addition, the analysis of the packaging labels of the products tested were conducted, following the requirements of the national legislation - RDC 07/2015 which defines the mandatory labeling standards for cosmetic products. A qualitative analysis for formaldehyde identification is based on the formation of a purple colored complex. The quantitative analysis was performed by spectrophotometry. The qualitative and quantitative formaldehyde analysis methods were applied to 13 bottles of hair straighteners. When submitted to qualitative analysis, all samples showed formaldehyde presence. The quantitative analysis demonstrated that the samples identified as B, C, D, E, G, H, I, J and M presented formaldehyde concentration of 3.5 to 14.5%, which is above of the limit recommended by the National Health Surveillance Agency (ANVISA), of 0.2%. In the label analysis, in all samples were found irregularities.(AU)

Relationship Between Structure And Antimicrobial Activity Of Zinc Oxide Nanoparticles: An Overview.

The inappropriate use of antimicrobials has resulted in the selection of resistant strains. Thus, a great number of studies have focused on the investigation of new antimicrobial agents. The use of zinc oxide nanoparticles (ZnO NPs) to optimise the fight against microbial resistance has been receiving increased attention due to the non-specific activity of inorganic antimicrobial agents. The small particle size and the high surface area of ZnO NPs can enhance antimicrobial activity, causing an improvement in surface reactivity. In addition, surface modifiers covering ZnO NPs can play a role in mediating antimicrobial activity since the surface properties of nanomaterials alter their interactions with cells; this may interfere with the antimicrobial effect of ZnO NPs. The possibility of using surface modifiers with groups toxic to microorganisms can improve the antimicrobial activity of ZnO NPs. Understanding the exact toxicity mechanisms is crucial to elucidating the antimicrobial activity of ZnO NPs in bacteria and fungi. Therefore, this review aims to describe the mechanisms of ZnO NPs toxicity against fungi and bacteria and how the different structural and physical-chemical characteristics of ZnO NPs can interfere in their antimicrobial activity.

Cytotoxic effect of protic ionic liquids in HepG2 and HaCat human cells: in vitro and in silico studies.

Protic ionic liquids (PILs) are innovative chemical compounds, which due to their peculiar nature and amazing physico-chemical properties, have been studied as potential sustainable solvents in many areas of modern science, such as in the industrial fields of textile dyeing, pharmaceuticals, biotechnology, energy and many others. Due to their more than probable large-scale use in a short space of time, a wider analysis in terms of ecotoxicity and biological safety to humans has been attracting significant attention, once many ionic liquids were found to be "a little less than green compounds" towards cells and living organisms. The aim of this study is to investigate the cytotoxicity of 13 recently synthesized PILs, as well as to reinforce knowledge in terms of key thermodynamic magnitudes. All the studied compounds were tested for their in vitro toxic activities on two human cell lines (normal keratinocytes HaCaT and hepatocytes HepG2). In addition, due to the enormous number of possible combinations of anions and cations that can form ionic liquids, a group contribution QSAR model has been tested in order to predict their cytotoxicity. The estimated and experimental values were adequately correlated (correlation coefficient R 2 = 0.9260). The experimental obtained results showed their remarkable low toxicity for the studied in vitro systems.

Increased antibacterial activity of ZnO nanoparticles: Influence of size and surface modification.

In the current study, the size and surface of ZnO nanoparticle (ZnO NP) suspensions and powders were finely controlled to evaluate their influence on the ZnO antibacterial activity against Staphylococcus aureus and Escherichia coli. The ZnO NP were prepared by the sol-gel method with different reaction times for NP size control and followed by the addition of (3-glycidyloxypropyl) trimethoxysilane (GPTMS) as a surface modifier. The ZnO NP were characterized by different techniques and the antibacterial activity was assessed through the minimum inhibitory concentration assay (MIC), minimum bactericidal concentration assay (MBC) and scanning electron microscopy (SEM). The ZnO NP exhibited significant antibacterial activity against Staphylococcus aureus. The NP size highly influenced the antibacterial activity, which increased with decreasing particle size. The small ZnO NP presented bactericidal activity whereas the largest showed bacteriostatic activity. The use of GPTMS, in general, led to increase of MIC and MBC. The formation of holes in the cell wall of Staphylococcus aureus was evidenced by SEM after contact between the bacteria and ZnO NP. The cytotoxicity assay showed that ZnO NP did not cause a loss of cell viability in the human keratinocyte cell line (HaCat) at the maximum concentration assessed. Thus, this study indicated that 5 nm ZnO NP modified by GPTMS has great potential for use as an inorganic antibacterial material.

Assessment of an anti-ageing structured cosmetic formulation containing goji berry

Based on previous studies, it has been found that goji berry (GB), popularly known as a 'miracle fruit', has excellent antioxidant potential and can be used in the treatment of skin disorders associated with ageing. This study aimed to incorporate GB into a structured cosmetic in order to optimise its penetration. Stability studies of the formulation, determination of the antioxidant activity of the extract and of the formulation, rheological measurements, SAXS, polarised light microscopy and bioadhesion analyses were performed. The results indicated the antioxidant activity of the extract, which can be incorporated into an emulsified cosmetic formulation. The emulsified formulation containing the extract remained stable, even after being submitted to thermal and luminous stresses for 30 days. In addition, rheological tests revealed that the addition of the GB soft extract reduced the viscosity of the formulation, increasing thixotropy and deformation. These systems were characterised by SAXS as a lamellar phase, which was confirmed by polarised light microscopy. These highly organised structures indicate their excellent stability. In vitro bioadhesion experiments revealed that these formulations exhibited skin adhesion strength statistically similar to commercial anti-ageing formulation. These results suggest that this formulation has excellent potential to be used as a topical treatment for ageing.

Bacterial cellulose skin masks-Properties and sensory tests.

BACKGROUND: Bacterial cellulose (BC) is a versatile material produced by microorganisms in the form of a membranous hydrogel, totally biocompatible, and endowed with high mechanical strength. Its high water-holding capacity based on its highly porous nanofibrillar structure allows BC to incorporate and to release substances very fast, thus being suitable for the preparation of skincare masks. AIMS: The preparation and characterization of cosmetic masks based on BC membranes and active cosmetics. METHODS: The masks were prepared by the simple incorporation of the cosmetic actives into BC membranes, used as a swelling matrix. The masks were characterized by Fourier transform infrared (FTIR), scanning electron microscopy (SEM), sensory tests, and skin moisture tests on volunteers. RESULTS: The results of sensory tests revealed the good performance of BC, being considered effective by the panel of volunteers, specially for adhesion to the skin (7.7 at the score scale), and improvement of the skin moisture (the hydration effect increased 76% in 75% of the volunteers that used vegetable extract mask formulation [VEM]), or a decrease in skin hydration (80% of the volunteers showed 32.6% decrease on skin hydration using propolis extract formulation [PEM] treatment), indicating the BC nanofiber membranes can be used to skincare applications. CONCLUSION: The results demonstrate the BC can be used as an alternative support for cosmetic actives for skin treatment.

Physicochemical characterization of drug nanocarriers.

Pharmaceutical design has enabled important advances in the prevention, treatment, and diagnosis of diseases. The use of nanotechnology to optimize the delivery of drugs and diagnostic molecules is increasingly receiving attention due to the enhanced efficiency provided by these systems. Understanding the structures of nanocarriers is crucial in elucidating their physical and chemical properties, which greatly influence their behavior in the body at both the molecular and systemic levels. This review was conducted to describe the principles and characteristics of techniques commonly used to elucidate the structures of nanocarriers, with consideration of their size, morphology, surface charge, porosity, crystalline arrangement, and phase. These techniques include X-ray diffraction, small-angle X-ray scattering, dynamic light scattering, zeta potential, polarized light microscopy, transmission electron microscopy, scanning electron microcopy, and porosimetry. Moreover, we describe some of the commonly used nanocarriers (liquid crystals, metal-organic frameworks, silica nanospheres, liposomes, solid lipid nanoparticles, and micelles) and the main aspects of their structures.

Guava: phytochemical composition of a potential source of antioxidants for cosmetic and/or dermatological applications

ABSTRACT Guava (Psidium guajava L.) is a native fruit of the American tropics with commercial applications for its taste, flavor and aroma. Numerous pharmacological uses have been described for it, such as the antiseptic effect of its leaves, the use of the fresh fruit and tea from its leaves for the treatment of diarrhea, dysentery, diabetes mellitus, and others. However, considering its rich composition, the guava also is a potential source of antioxidants to be used in the development of new formulations for cosmetic and/or dermatological applications, the main focus of this research. Herein, we describe the study of the phytochemical composition and the antioxidant activity of a guava extract prepared with non-toxic solvents aiming its use at biological applications. High performance liquid chromatography and mass spectrometry were employed to identify the major components, while thermoanalytical measurements and hot stage microscopy were used to assess the chemical stability of guava fruit extract. The antioxidant activity was also evaluated assessing the SOD-like activity and ABTS free radical scavenger. The results show that the extract is a rich source of phenolic compounds, such as quercetin, kaempferol, schottenol, among many others. All of the components found in guava extract exhibit biological effects according to the literature data, mainly antioxidant properties.

Drug Delivery Systems Obtained from Silica Based Organic-Inorganic Hybrids.

This is a review of hybrid materials based on silica as an inorganic phase used as drug delivery systems (DDS). Silica based DDS have shown effectivity when compared with traditional delivery systems. They present advantages such as: (a) ability to maintain the therapeutic range with minor variations; (b) prevention of local and systemic toxic effects; (c) plasma concentrations increase of substances with a short half-life; and (d) reduction of the number of daily doses, which may increase patient adherence to the treatment. These advantages occur due to the physical, chemical and optical properties of these materials. Therefore, we discuss the properties and characteristics of them and we present some applications, using different approaches of DDS to ensure therapeutic effectiveness and side effects reduction such as implantable biomaterial, film-forming materials, stimuli-responsive systems and others.

Toxicity and Loss of Mitochondrial Membrane Potential Induced by Alkyl Gallates in Trypanosoma cruzi.

American trypanosomiasis or Chagas disease is a debilitating disease representing an important social problem that affects, approximately, 10 million people in the world. The main aggravating factor of this situation is the lack of an effective drug to treat the different stages of this disease. In this context, the search for trypanocidal substances isolated from plants, synthetic or semi synthetic molecules, is an important strategy. Here, the trypanocidal potential of gallates was assayed in epimastigotes forms of T. cruzi and also, the interference of these substances on the mitochondrial membrane potential of the parasites was assessed, allowing the study of the mechanism of action of the gallates in the T. cruzi organisms. Regarding the preliminary structure-activity relationships, the side chain length of gallates plays crucial role for activity. Nonyl, decyl, undecyl, and dodecyl gallates showed potent antitrypanosomal effect (IC50 from 1.46 to 2.90 µM) in contrast with benznidazole (IC50 = 34.0 µM). Heptyl gallate showed a strong synergistic activity with benznidazole, reducing by 10(5)-fold the IC50 of benznidazole. Loss of mitochondrial membrane potential induced by these esters was revealed. Tetradecyl gallate induced a loss of 53% of the mitochondrial membrane potential, at IC50 value.

Rheology as a Tool to Predict the Release of Alpha-Lipoic Acid from Emulsions Used for the Prevention of Skin Aging.

The availability of an active substance through the skin depends basically on two consecutive steps: the release of this substance from the vehicle and its subsequent permeation through the skin. Hence, studies on the specific properties of vehicles, such as their rheological behavior, are of great interest in the field of dermatological products. Recent studies have shown the influence of the rheological features of a vehicle on the release of drugs and active compounds from the formulation. In this context, the aim of this study was to evaluate the influence of the rheological features of two different emulsion formulations on the release of alpha-lipoic acid. Alpha-lipoic acid (ALA) was chosen for this study because of its antioxidant characteristics, which could be useful for the prevention of skin diseases and aging. The rheological and mechanical behavior and the in vitro release profile were assayed. The results showed that rheological features, such as viscosity, thixotropy, and compliance, strongly influenced the release of ALA from the emulsion and that the presence of a hydrophilic polymer in one of the emulsions was an important factor affecting the rheology and, therefore, the release of ALA.