Impact of toothbrush head configuration and dentifrice abrasivity on non-carious cervical lesions in-vitro.

OBJECTIVE: To investigate the effect of toothbrush head configuration and dentifrice slurry abrasivity on the development of simulated non-carious cervical lesions (NCCLs) in vitro. METHODS: Extracted premolars were randomly allocated into 15 groups (n = 16) generated by the association between toothbrush head configuration (flat-trimmed, rippled, cross-angled/multilevel/rubbers added, cross-angled/multilevel/flex head, feathered) and dentifrice slurry abrasivity (low/medium/high). Teeth were mounted on acrylic blocks and had their roots partially covered with acrylic resin, leaving 2-mm root surfaces exposed. Toothbrushing was performed for 35,000 and 65,000 double-strokes. Specimens were analyzed using non-contact profilometry for dental volume loss (mm3) and lesion morphology. Data was analyzed using ANOVA with pairwise comparisons and Kruskal-Wallis tests. RESULTS: The two-way interaction between toothbrush head configuration and slurry abrasivity was significant (p = 0.02). At 35,000 strokes, the flat-trimmed and cross-angled/multilevel/rubbers added toothbrushes caused the highest loss, when associated to the high-abrasive slurry (p<0.05); whereas cross-angled/multilevel/flex head showed the least loss, when associated to the low-abrasive (p<0.05). At 65,000, more dental loss was observed for all toothbrushes when associated to the high-abrasive slurry, with flat-trimmed causing the highest loss (p < 0.05). Lower dental loss rates were observed for cross-angled/multilevel/flex head associated to the low-abrasive slurry when compared to the other toothbrushes (p < 0.05), except to feathered (p = 0.14) and rippled (p = 0.08). Flat lesions (mean internal angle ± standard-deviation: 146.2°± 16.8) were mainly associated with low-abrasive slurry, while wedge-shaped lesions (85.8°± 18.8) were more frequent with medium- and high-abrasive slurries. CONCLUSION: The development, progression and morphology of simulated NCCLs were modulated by both toothbrush head configuration and dentifrice abrasivity. CLINICAL SIGNIFICANCE: Dental professionals should consider both the type of toothbrush and dentifrice abrasivity in the management plan of patients at risk of developing NCCLs.

Fracture Strength of Composite Rest Seats: An In Vitro Comparative Study of Different Composite versus Amalgam Restorations.

Occlusal rest provides support for removable partial dentures (RPD). Rest seats are ideally prepared in enamel, but the abutment teeth might be restored or need restorations. This study compared the fracture strength of abutments restored with composite to amalgam restorations after rest seat preparation. Disto-occlusal cavities were prepared in 30 extracted human maxillary premolars. The specimens were allocated in three groups (n = 10) based on the type of restoration. All the specimens were exposed to thermomechanical aging followed by cycling loading. Fracture strength was tested using a universal testing machine, and then, the fracture mode was recorded. The data were analyzed using Kruskal-Wallis test with a significance level set at 0.05. The fracture mode was recorded as catastrophic or non-catastrophic. The fracture strength between all tested groups showed no significant difference. The highest and lowest fracture strength were recorded on amalgam and Tetric N-Ceram groups, respectively. Composite Tetric N-Ceram showed equal distribution of fracture sites on the restorative materials and teeth, it also displayed the highest number of non-catastrophic fractures unlike other groups where the fracture occurred more within the restorations. The fracture strength of composite was comparable to that of amalgam restorations with prepared rest seats.

Different cavity disinfectant efficacy against S.mutans and shear bond strength of caries affected dentin bonded to resin restoration.

AIMS: The existing study aimed to assess the survival rate of S.mutans and shear bond strength (SBS) of resin adhesive restoration bonded to carious affected dentin (CAD) after using different cavity disinfectants (Chitosan, Fotoenticine®, and CO2 laser) in comparison to Chlorhexidine (CHX). MATERIALS AND METHODS: The study included human mandibular molars assessed on International Caries Detection and Assessment System (ICDAS) score 4 and 5. The cusp part of the clinical crown was cut off until the reduction reaches the central fossa while being continuously supplied with water coolant till the tooth cementoenamel junction (CEJ). The root sections were embedded in polymethyl methacrylate acrylic resin followed by culturing S.mutans biofilm on the CAD surface. Specimens were arbitrarily allocated into four groups(n = 10) based on the type of disinfection. Group 1 (2% CHX), Group 2 (Chitosan), Group 3 (Fotoenticine), and Group 4 (CO2 laser). S.mutans survival rate was assessed and CAD was restored with a composite restorative material. Thermoocycling of the samples was performed and a universal testing machine (UTM) and Stereomicroscope were used to identify bond integrity and type of fracture. ANOVA and Tukey multiple comparison tests were used to assess SBS. Data on the survival rate of S. mutans were compared between groups using the nonparametric Kruskal-Wallis test RESULTS: Outcomes revealed that Group 1 (CHX) displayed the highest survival rate (0.65 ± 0.10). However, lowest survival rate was demonstrated by Group 3 (Fotoenticine) treated specimens (0.25 ± 0.06). It was also discovered that CHX unveiled highest bond strength values (21.48 ± 1.39 MPa). Nevertheless, Group 2 (Chitosan) showed lowest SBS (11.01 ± 1.00 MPa). Intergroup comparison analysis presented that group 1, and group 4 (Co2 laser) (17.76 ± 0.41 MPa) displayed no significant difference in their bond integrity achieved. (p > 0.05). However, group 3 (Fotoenticine) (16.28 ± 0.51 MPa) and group 2 demonstrated comparable outcomes of SBS. (p > 0.05) CONCLUSION: The use of CHX and CO2 lasers as disinfectants on the CAD surface resulted in a positive impact on the SBS of resin composite, according to the study's findings. However, it is worth noting that Fotoenticine exhibited better antimicrobial efficacy against S. mutans.