Development of a new generic extraction method for the analysis of pesticides, mycotoxins, and polycyclic aromatic hydrocarbons in representative animal feed and food samples.

Various generic extraction methods have been used to determine pesticide residues, mycotoxins, and polycyclic aromatic hydrocarbons (PAHs) in food and animal feed to ensure consumer safety. However, these methods cannot extract all relevant compounds at an acceptable rate of recovery. This study presents a new extraction method. This new method facilitated the identification of 231 compounds, including 196 pesticides, 11 mycotoxins, and 24 PAHs over a broad range of polarities. These compounds were identified in various sample matrices, including those that are lipid-rich. The processed sample is first extracted with water, acetonitrile, formic acid, and heptane. The addition of ammonium formate results in separation into three phases and enables analysis of the aqueous phase. Solid-phase extraction clean-up procedures were performed as necessary followed by analysis by liquid or gas chromatography and mass spectrometry. Analyte recoveries were typically in the range of 70 - 120% with relative standard deviations below 20%.

Automated micro-solid-phase extraction clean-up of polycyclic aromatic hydrocarbons in food oils for analysis by gas chromatography-orbital ion trap mass spectrometry.

Food can contain unwanted compounds and need to be analyzed for compounds like carcinogenic polycyclic aromatic hydrocarbons to ensure consumer safety. The analytes need to be extracted from the sample matrix and cleaned-up to enable detection. However, established methods for clean-up are labor intensive and have a high expenditure on organic solvents. Here, we show a newly developed micro-solid-phase extraction cartridge method to automate the clean-up for analysis of polycyclic aromatic hydrocarbons in sunflower oil using gas chromatography with quadrupole-orbitrap mass spectrometry with a TriPlus autosampler. This automated micro-solid-phase extraction cartridge method needs only 4 µL of vegetable oil sample and requires only 360 µL acetonitrile for elution, and, therefore, it needs only small amounts of organic solvent. Two different micro-solid-phase extraction cartridge methods were developed, one using two commercially available cartridges with florisil and octadecylsilane/Z-Sep/CarbonX, and the other method using one commercially available cartridge with florisil followed by one self-made cartridge with octadecylsilane/Z-Sep. The latter method showed successful lipid removal and was further validated for 22 of 24 polycyclic aromatic hydrocarbon compounds in sunflower oil at a spiked level of 1090 µg/kg with recoveries ranging from 53 to 118% and relative standard deviation below 22%. This method shows promising short-time clean-up with low expenditure of solvents.

Evaluation of spin labels for in-cell EPR by analysis of nitroxide reduction in cell extract of Xenopus laevis oocytes.

Spin-label electron paramagnetic resonance (SL-EPR) spectroscopy has become a powerful and useful tool for studying structure and dynamics of biomacromolecules. However, utilizing these methods at physiological temperatures for in-cell studies is hampered by reduction of the nitroxide spin labels and thus short half-lives in the cellular environment. Consequently, reduction kinetics of two structurally different nitroxides was investigated in cell extracts of Xenopus laevis oocytes using rapid-scan cw-experiments at X-band. The five member heterocyclic ring nitroxide PCA (3-carboxy-2,2,5,5-tetramethylpyrrolidinyl-1-oxy) under investigation features much higher stability against intracellular reduction than the six member ring analog TOAC (2,2,6,6-tetramethylpiperidine-N-oxyl-4-amino-4-carboxilic acid) and is therefore a suitable spin label type for in-cell EPR. The kinetic data can be described according to the Michaelis-Menten model and thus suggest an enzymatic or enzyme-mediated reduction process.