Regeneration of gingival tissue using in situ tissue engineering with collagen scaffold.

OBJECTIVE: The aim of the study was to evaluate 2 types of collagen scaffold for gingival regeneration. STUDY DESIGN: Two types of collagen scaffolds, CS-pH7.4 and CS-pH3.0, were prepared by processing atelocollagen at pH 7.4 or 3.0, respectively, followed by dehydrothermal treatment. Gingival wounds with sizes of 4 × 6 mm (rectangle) or 6 mm diameter (circle) were made with buccal incisions in beagle dogs. The defective area was surgically covered with the CS-pH7.4, CS-pH3.0, or no scaffold (control). Gingival regeneration was assessed by monitoring the differences in the lengths of the epithelial and submucosal tissues at the wound site and the normal site. Histopathologic assessments were performed by 4 evaluators independently; statistical significance was evaluated by using the Wald test. RESULTS: Significantly higher recovery of epithelial and submucosal tissues, which, in turn, resulted in recovery of gum thickness, was observed in gingival wounds treated with the CS-pH7.4 compared with that in the control. CS-pH3.0 treatment also resulted in higher gingival regeneration compared with the control; however, the effects were more pronounced in wounds treated with the CS-pH7.4. CS-pH7.4-treated wounds showed better gingival regeneration compared with the control and CS-pH3.0-treated wounds, even after adjusting for interevaluator differences using a linear mixed model. CONCLUSIONS: CS-pH7.4 is a promising scaffold for gingival tissue regeneration.

Optimal dehydrothermal processing conditions to improve biocompatibility and durability of a weakly denatured collagen scaffold.

Collagen scaffolds are essential for tissue regeneration; however, preprocessing of these scaffolds is necessary because of their poor mechanical properties. The aim of this study was to determine the optimal condition for preparing a collagen scaffold with biocompatibility and durability. An atelocollagen fiber suspension was made and stored at -10°C in a container that could be cooled from the bottom to provide an orientation perpendicular to the collagen fiber and facilitate cell infiltration into the scaffold. After freeze-drying the frozen suspension, various collagen scaffolds were made by dehydrothermal (DHT) treatment under different conditions (processing temperature: 120-160°C for 0-28 h). Sections of the obtained materials were embedded under the back skin of rats, and the thickness and biocompatibility of the residual scaffold were evaluated after 2 weeks. The number of foreign body giant cells was counted to evaluate biocompatibility. Although the residual scaffold was thick, excessive DHT treatment caused a strong foreign body reaction. Weak DHT treatment resulted in a collagen scaffold with good biocompatibility but with reduced thickness. Overall, these results showed the restricted optimal conditions to make a collagen scaffold with good biocompatibility and ability to maintain sufficient space for tissue regeneration. © 2016 Wiley Periodicals, Inc. J Biomed Mater Res Part B: Appl Biomater, 105B: 2301-2307, 2017.