RESUMEN
OBJECTIVE: Evaluation of biaxial flexural strength (BFS) of nanoglass (NG) and multiwalled carbon nanotubes (MWCNTs) reinforced 3D-printed denture base resins and their shear bond strength (SBS) to 3D-printed and acrylic denture teeth. METHODS: Silanized NG and MWCNTs were added to 3D-printed denture base resin to obtain four groups: Control, 0.25 wt% NG, 0.25 wt% MWCNTs, and a combination group with 0.25 wt% of both fillers. All specimens were tested before and after 600 cycles of thermal aging. BFS (n = 88) was tested using disk-shaped specimens (12 ×2 mm) centralized on an O ring in a universal testing machine. Weibull analysis was conducted to assess predictability of failure. SBS (n = 176) was tested for acrylic and 3D-printed denture teeth attached to bar-shaped specimens in a universal testing machine followed by failure mode analysis using stereomicroscope. Two and three-way ANOVA tests followed by Tukey post hoc test were conducted for BFS and SBS. Kruskal-Wallis test compared percent change among groups with subsequent Dunn post hoc test with Bonferroni correction (α = 0.05). RESULTS: BFS was affected significantly by filler content (P < 0.001) and thermal cycling (P < 0.001), with thermal cycling displaying the uppermost effect (È p2 =0.551). A significant interaction between filler content, thermal cycling, and teeth type was displayed by SBS results (P < 0.001, F=10.340, È p2 =0.162). The highest BFS values belonged to 0.25 % MWCNTs while the highest SBS to printed teeth was displayed by the combination. SIGNIFICANCE: The combination group displayed higher BFS and SBS to printed teeth compared to control which allows 3D-printed materials to have a long-term clinical success.