Role of CypA and Hsp90 in membrane translocation mediated by anthrax protective antigen.

Bacillus anthracis lethal toxin consists of the protective antigen (PA) and the metalloprotease lethal factor (LF). During cellular uptake PA forms pores in membranes of endosomes, and unfolded LF translocates through the pores into the cytosol. We have investigated whether host cell chaperones facilitate translocation of LF and the fusion protein LF(N)DTA. LF(N) mediates uptake of LF(N)DTA into the cytosol, where DTA, the catalytic domain of diphtheria toxin, ADP-ribosylates elongation factor-2, allowing for detection of small amounts of translocated LF(N)DTA. Cyclosporin A, which inhibits peptidyl-prolyl cis/trans isomerase activity of cyclophilins, and radicicol, which inhibits Hsp90 activity, prevented uptake of LF(N)DTA into the cytosol of CHO-K1 cells and protected cells from intoxication by LF(N)DTA/PA. Both inhibitors, as well as an antibody against cyclophilin A blocked the release of active LF(N)DTA from endosomal vesicles into the cytosol in vitro. In contrast, the inhibitors did not inhibit cellular uptake of LF. In vitro, cyclophilin A and Hsp90 bound to LF(N)DTA and DTA but not to LF, implying that DTA determines this interaction. In conclusion, cyclophilin A and Hsp90 facilitate translocation of LF(N)DTA, but not of LF, across endosomal membranes, and thus they function selectively in promoting translocation of certain proteins, but not of others.

Solubilization and characterization of the anthrax toxin pore in detergent micelles.

Proteolytically activated Protective Antigen (PA) moiety of anthrax toxin self-associates to form a heptameric ring-shaped oligomer (the prepore). Acidic pH within the endosome converts the prepore to a pore that serves as a passageway for the toxin's enzymatic moieties to cross the endosomal membrane. Prepore is stable in solution under mildly basic conditions, and lowering the pH promotes a conformational transition to an insoluble pore-like state. N-tetradecylphosphocholine (FOS14) was the only detergent among 110 tested that prevented aggregation without dissociating the multimer into its constituent subunits. FOS14 maintained the heptamers as monodisperse, insertion-competent 440-kDa particles, which formed channels in planar phospholipid bilayers with the same unitary conductance and ability to translocate a model substrate protein as channels formed in the absence of detergent. Electron paramagnetic resonance analysis detected pore-like conformational changes within PA on solubilization with FOS14, and electron micrograph images of FOS14-solubilized pore showed an extended, mushroom-shaped structure. Circular dichroïsm measurements revealed an increase in alpha helix and a decrease in beta structure in pore formation. Spectral changes caused by a deletion mutation support the hypothesis that the 2beta2-2beta3 loop transforms into the transmembrane segment of the beta-barrel stem of the pore. Changes caused by selected point mutations indicate that the transition to alpha structure is dependent on residues of the luminal 2beta11-2beta12 loop that are known to affect pore formation. Stabilizing the PA pore in solution with FOS14 may facilitate further structural analysis and a more detailed understanding of the folding pathway by which the pore is formed.

ClpP hydrolyzes a protein substrate processively in the absence of the ClpA ATPase: mechanistic studies of ATP-independent proteolysis.

ATP-dependent proteases are processive, meaning that they degrade full-length proteins into small peptide products without releasing large intermediates along the reaction pathway. In the case of the bacterial ATP-dependent protease ClpAP, ATP hydrolysis by the ClpA component has been proposed to be required for processive proteolysis of full-length protein substrates. We present here data showing that in the absence of the ATPase subunit ClpA, the protease subunit ClpP can degrade full-length protein substrates processively, albeit at a greatly reduced rate. Moreover, the size distribution of peptide products from a ClpP-catalyzed digest is remarkably similar to the size distribution of products from a ClpAP-catalyzed digest. The ClpAP- and ClpP-generated peptide product size distributions are fitted well by a sum of multiple underlying Gaussian peaks with means at integral multiples of approximately 900 Da (7-8 amino acids). Our results are consistent with a mechanism in which ClpP controls product sizes by alternating between translocation in steps of 7-8 (+/-2-3) amino acid residues and proteolysis. On the structural and molecular level, the step size may be controlled by the spacing between the ClpP active sites, and processivity may be achieved by coupling peptide bond hydrolysis to the binding and release of substrate and products in the protease chamber.

The ClpP N-terminus coordinates substrate access with protease active site reactivity.

Energy-dependent protein degradation machines, such as the Escherichia coli protease ClpAP, require regulated interactions between the ATPase component (ClpA) and the protease component (ClpP) for function. Recent studies indicate that the ClpP N-terminus is essential in these interactions, yet the dynamics of this region remain unclear. Here, we use synchrotron hydroxyl radical footprinting and kinetic studies to characterize functionally important conformational changes of the ClpP N-terminus. Footprinting experiments show that the ClpP N-terminus becomes more solvent-exposed upon interaction with ClpA. In the absence of ClpA, deletion of the ClpP N-terminus increases the initial degradation rate of large peptide substrates 5-15-fold. Unlike ClpAP, ClpPDeltaN exhibits a distinct slow phase of product formation that is eliminated by the addition of hydroxylamine, suggesting that truncation of the N-terminus leads to stabilization of the acyl-enzyme intermediate. These results indicate that (1) the ClpP N-terminus acts as a "gate" controlling substrate access to the active sites, (2) binding of ClpA opens this "gate", allowing substrate entry and formation of the acyl-enzyme intermediate, and (3) closing of the N-terminal "gate" stimulates acyl-enzyme hydrolysis.

Synchrotron protein footprinting supports substrate translocation by ClpA via ATP-induced movements of the D2 loop.

Synchrotron X-ray protein footprinting is used to study structural changes upon formation of the ClpA hexamer. Comparative solvent accessibilities between ClpA monomer and ClpA hexamer samples are in agreement throughout most of the sequence, with calculations based on two previously proposed hexameric models. The data differ substantially from the proposed models in two parts of the structure: the D1 sensor 1 domain and the D2 loop region. The results suggest that these two regions can access alternate conformations in which their solvent protection is greater than that in the structural models based on crystallographic data. In combination with previously reported structural data, the footprinting data provide support for a revised model in which the D2 loop contacts the D1 sensor 1 domain in the ATP-bound form of the complex. These data provide the first direct experimental support for the nucleotide-dependent D2 loop conformational change previously proposed to mediate substrate translocation.

An information-based computational technique for estimation of chromatographic peak purity.

Assessment of the purity of chromatographic peaks is an important step in developing and validating purification procedures for complex mixtures. While curve-fitting techniques can be useful for determining the retention times and relative concentrations of the components of a chromatographic peak, their utility is limited by the lack of unambiguous criteria for determining the number of such components. In this work, we present a computational technique for analyzing chromatograms to estimate the number of components, their retention times, and their relative concentrations. In contrast to Fourier-transform-based techniques, the technique we present does not require manual peak identification. It is based on curve-fitting and uses the Akaike information criterion to estimate the number of components. Application of the technique to chromatograms obtained from size-exclusion and reverse-phase chromatography of test mixtures indicates that it is useful for the characterization of complex mixtures.