RESUMEN
The availability of microbially-safe drinking water is a challenge in many developing regions. Due to the well-known antibacterial effect of silver ions, materials used for their controlled release have been widely studied for point-of-use water disinfection. However, even if it is in principle known that chloride anions can suppress the antibacterial efficiency of silver, the majority of previous studies, surprisingly, have not focused on chloride concentrations relevant for freshwaters and thus for practical applications. Here, we prepared low-cost nanocellulose-aluminium oxyhydroxide nanocomposites functionalized with silver nanoparticles. Field samples obtained from Chennai, India were used as a guideline for choosing relevant chloride concentrations for the antibacterial studies, i.e., 10, 90, and 290 ppm. The antibacterial performance of the material against Escherichia coli and Bacillus subtilis was demonstrated and the influence of chloride concentration on the antibacterial effect was studied with E. coli. A 1 h contact time led to bacterial reductions of 5.6 log10, 2.9 log10, and 2.2 log10, respectively. This indicates that an increase of chloride concentration leads to a substantial reduction of antibacterial efficiency, even within chloride concentrations found in freshwaters. This work enables further insights for designing freshwater purification systems that utilize silver-releasing materials.
RESUMEN
Understanding the chemical changes happening to nanostructures during a process is vital in selecting them for applications. Here, we investigated the difference in the reactivity of the bulk and nanoscale forms of molybdenum disulfide (MoS2) in solution with lead ions (Pb2+ and Pb4+) as probes, at room temperature. While the bulk form did not show any reactivity in the experimental timescale, the two-dimensional (2D) nanoscale form showed not only reactivity but also quite rapid kinetics that resulted in the formation of distinct products, principally PbMoO4 with anion substitution, in a few seconds. Depending on the charge state of the cation, and the pH of the reaction mixture, two different kinds of morphologies of the same reaction product were formed. Furthermore, we demonstrate that this unusual reactivity of the MoS2 nanosheets (NSs) was retained in its supported form and hence, such supported materials can be effective for the abstraction of toxic lead from water, with fast kinetics.
RESUMEN
Arsenic-free drinking water, independent of electrical power and piped water supply, is possible only through advanced and affordable materials with large uptake capacities. Confined metastable 2-line ferrihydrite, stable at ambient temperature, shows continuous arsenic uptake in the presence of other complex species in natural drinking water and an affordable water-purification device is made using the same.
RESUMEN
Creation of affordable materials for constant release of silver ions in water is one of the most promising ways to provide microbially safe drinking water for all. Combining the capacity of diverse nanocomposites to scavenge toxic species such as arsenic, lead, and other contaminants along with the above capability can result in affordable, all-inclusive drinking water purifiers that can function without electricity. The critical problem in achieving this is the synthesis of stable materials that can release silver ions continuously in the presence of complex species usually present in drinking water that deposit and cause scaling on nanomaterial surfaces. Here we show that such constant release materials can be synthesized in a simple and effective fashion in water itself without the use of electrical power. The nanocomposite exhibits river sand-like properties, such as higher shear strength in loose and wet forms. These materials have been used to develop an affordable water purifier to deliver clean drinking water at US $2.5/y per family. The ability to prepare nanostructured compositions at near ambient temperature has wide relevance for adsorption-based water purification.